1995 subaru wont start the starter and battery are brand new,
Starter and battery have now both been replaced, still every other time i drive it it wont turn over, I findthat if i wait and wiggle the connections to the battery sometimes it will start. I always starts eventually... for now anyway
An expert who has achieved level 2 by getting 100 points
An expert that got 10 achievements.
An expert that got 5 achievements.
An expert whose answer got voted for 100 times.
Re: 1995 subaru wont start the starter and battery are...
Iwould check where the grounds at the motor and body. Make sure there is no rust built up under them. Sometimes just loosening and retightening them is enough to make a good contact. Good luck and have a good day.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
You might not believe this, but check your battery. Some of these vehicles have cut-outs when the battery level goes below a preset amount.
I work on Ford brands and on them, a low battery level will even disconnect the Alternator circuit and mess with the starter. Some even act up when the battery slightly dips below 12 volts.
Your antitheft can make your starter cut out. And If you think about it, all of the measurements to make the engine run are based on feedback of voltage and amperage. This is how the engine management system adjusts. If your prime source of power is low, then all of the following electrical readings will be low. Some may be too low to work.
Your fuelpump will hold pressure in a closed system for hours. The fuel pressure regulator will command the fuelpump to stop working if the fuel pressure is at maximum. Without responses from the other components and after satisfactory pressure, the fuelpump will turn off.