- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Check the dome light switch. I believe its between the map lights in the front overhead console. You can set it to Always Off, On with Doors, or Always On.
The Dome light and the cargo area light should come on when the door is open and the switch is set to door position, or when set to the always on position.
If only one of the lights come on change the bulb of that light. If neither light comes on change the fuse.
I believe the instrument panel fuse block is located on the passenger side of the center console, to the left of the glove box near the floor. The cover usual lists where and what each fuse does. Look for Interior Lighting, I believe #23. Pull the fuse and check if its broken. If it is replace it. If not you may have electrical issues.
The bulbs is replaced from the back of the overhead console with 1/4 turn bulb holders.
the overhead console ( non rail version ) is held up with spring clips.
Open the rear compartment, and grab the rear corners and pull down 1 at a time. They are very hard to pull the 1st few times. Once you have the read released, there is another set of spring clips in the front, so be careful how far down you pull the rear, until the front is released.
Once you can see the back of the overhead console, you will see the 1/4 turn bulb holders for the map and interior lights.
If you're talking about the map lights (2 lights in between driver and passenger)
If you have just the map lights, just pull the whole assembly out. Don't worry about anything breaking, just pull it down, just not at an angle or anything. It easily snaps back into place after. Bulbs can be removed once you have it out.
If you have an overhead console, you remove a screw towards the front of the overhead console Then just pull. If you're talking about other interior lights, let me know I'll let you know how to remove it.
Open your car bulet the go to where the overhead light holder hid remove the overhead light panel then remove the burnt bulb then replace with the new one then couple the panel back and close the bulet and here coming the overhead light working.
Open the rear compartment ( on the non rail overhead ) grab and pull down in each rear corner. The overhead is held on with 4 or 6 spring clips. Once you have the overhead console down, the bulbs are installed from the rear with 1/4 turn bulb holders.
There are spring clips holding the console to the roof.
Open the compartment, and grasp each corner, and pull down. This will take a moderate amount of pull to release the spring clips.
There are 4 or 6 spring clips holding the console to the ceiling, at the least the center spring clips will release when you pull down on the rear. remove the front held in place by the spring clips. There are 2 connectors for the overhead console, these have ~ 6" if slack in them.
From this point, you can remove the connectors, or you will see the gray bulb holders for the map / interior lamps. These are 1/4 twist bulb holders.
To change the bulbs for the map lights you need to first remove the screw located on the overhead console which is towards the front of the console (towards the front window). Then you need to pry down on the rear of the console. Once the console is removed you then need to remove the map light bulbholders and replace the bulbs.
As for the bulbs for the ashtray I am not sure if there is one.