Question about 1991 Toyota Pickup

1 Answer

We are putting a clutch in my 91 toyota pickup 4x4 do we take off the transfer case first or take out the transfer case and transmission together

Posted by on

  • laura_budlon Feb 03, 2009

    well we got it out but i need a new gasket in the transfer case also i also need a slave boot the one on my truck was all melted where can i get one any ideas

  • Anonymous Mar 13, 2014

    Can you put the transmission in with the transfer case already put together?



1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Toyota Master
  • 1,861 Answers

Hi. Welcome to FixYa. I will do my best to assist you, with the hopes that you will award me with a FixYa rating for my assistance.

What I do, in my service department, is to pull the transmission and the transfer case as on unit. It is faster, and much simpler. There is no reason to pull them separately. That is way too much work.

I hope that this helps you out.

Thanks for choosing FixYa for assistance.

Posted on Jan 30, 2009

    GEORGE FINLEY Nov 04, 2013

    it is for a 2001 chevy 1500 with a 261 ld transfer case



1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

I have a 93 toy. 4x4 Iam getting ready to change clutch. Can I split the transfer off of the transmission?

it would be to much trouble. it is not that bad to do it with everything together just a little heavier.
have doen at least 40 of these in the last 25 yrs and did not split transfer from trans

Jun 15, 2011 | 1993 Toyota Pickup

1 Answer

What type of fluid or gear oil goes into transfer case 1989 4x4 toyota pickup

Transfer Case Fluid Types

Automatic Trans. Dexron II or III Manual Trans. GL4 or GL5, 75W/90

Feb 23, 2011 | 1989 Toyota Pickup SR5

1 Answer

Do I need to take out the transmission to change the clutch on a 1991 Toyota pickup with 4-wheel drive?

Hello. Welcome to FixYa. I will be happy to assist you.


You have to remove the transmission, and the transfer case, from the vehicle to access the clutch assembly. There is no other way to remove the clutch.

Feb 19, 2011 | 1991 Toyota Pickup

1 Answer

I need instructions on how to put a new clutch in a 1988 toyota 4x4 pick-up.

bit of a job but you can do it remove driveshaft
remove cross bar (most models) disconnect the transfer case disconect the slave cylinder and all the lines going to the cooler support the motor take the trany bolts loose and pull the transmission out
remember that they are heavy ( replace the clutch
use the alinment tool reinstall the new clutch pressure plate and throwout bearing assembly
reinstall the trans /transfer case and drives shafts
crossbar and all the little stuff cooling lines etc
slave cylinder etc good luck

Mar 05, 2010 | Toyota Pickup Cars & Trucks

2 Answers

91 toyota pickup with clutch problems

First you have to bleed air from clutch fluid.
if it is not ok, Remove clutch agan & check pressure plate finger blance or damage.

Nov 18, 2009 | 1991 Toyota Pickup

1 Answer

I am replacing my clutch on my 2000 tacoma 4x4. Should I remove the transfer case with the transmission or separately .

Its a lot heavier to deal with if you leave the transfer box in place. Saying that its one less job to do when you put it back. Either way your probably going to need help if you don't have a hoist.

Nov 05, 2009 | 2000 Toyota Tacoma PreRunner

2 Answers


usually japanese and corean cars do fit there transi ...not sure but!

Jul 21, 2009 | 1991 Toyota Pickup

1 Answer

I have a 91 Toyota 4X4 truck. the clutch is hydraulic. Where is the fluid reservoir located?

There is a small "master cylinder", forthe clutch, located on the driver side of the engine compartment, below the master cylinder.

May 06, 2009 | 1991 Toyota Pickup

1 Answer

Clutch replacement 91 pickup 4x4 toyota

ase mechanic:

well depends how strong you are, and if you are using a car lift or doing on your back. either way drain the transfer case fluid, should be bolt on bottom, otherwise when you seperate the transfer case from trans there will big mess. take transfer case off first note how it is mounted with paint marker and then take trans out. much easier then leaving together.

Jan 29, 2009 | 1991 Toyota Pickup

Not finding what you are looking for?
1991 Toyota Pickup Logo

Related Topics:

176 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts


Level 3 Expert

77169 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8732 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides