SOURCE: toyota landcruiser ignition switch
I am not 100% sure on toyota but most ignition switches you must remove the housing around the steering wheel to get to it . Its usually a large plastic componet on the left side behind the turn signal handle . It is always best to go to the local auto parts store and buy a haynes repair manual before attempting any repairs. Hope evereything turns out well for you !!
SOURCE: water pump on a toyota landcruiser 4.2 ltr diesel
Hi Scott_har892
In shortr yes,
If it's getting close to a timing belt change and or the water pump is about to fail do them both at the same time with the radiator removed (just makes it so much easier) while your are at it do the timing cover seals as well
SOURCE: landcruiser auto transmission,,how to check fluid level
when you open your hood look in the back of the motor on the left side.. you should see a stick with a circle on the end of it for your finger have you vehicle running warmed up that means let it run for 10 or 15 min. and then pull the stick out.. wipe it off real good. stick it back in all the way.. pull it back out and hold it horizontally and check it.. it's sometimes hard to read because it has bubbles on it.. try it a couple of times to get an accurate reading good-luck ray
SOURCE: Timing belt light of Toyota LandCruiser 2006
the reset procedure of the timing belt light is all done by pressing the trip meter button and holding it in whilst the ignition is turned to on then select from the trip button then continue pressing until you come to 15 on trip metre, turn off and then restart. The light should then go off.
271 views
Usually answered in minutes!
×