Question about 1995 Geo Prizm

1 Answer

Starter fuse on 95 geo prism

Used needle nose hosing came off leaving the prongs now what?

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

I fiqured it out, the starter fuse on 95 geo is bolted in. you have unbolt the fuse box under the hood. you have to push the fuses out the bottom, patience is the key it doesn't push easily,once you have it pushed out remove the bottom cover and remove a 8mm and 10mm bolt.reverse to install

Posted on Jan 30, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the start relay on a 96 Geo prism I can find it


wont crank? Check fuses first? (USA answers)
use the scan tool and get P1500" starter signal dead?
which engine, 1.6L or 1.8L which trans, A/T or M/T (auto./stick)
did you try cranking in Neutral (guessing A/T)??
the relay with 2 white wires, it is.
the USA left drivers side fuse box. is WHERE it is.
if you hot wire the starter and it cranks its, ok the starter
if car cranks in Neutral the PRNDL switch is bad.
if the relay below has 12vdc on coil or 11v, cranking
voltmeter across coil and output contact is dead the relay is bad.
if no 12v across , that means bad key line (PNRLD) or bad ignition switch, (hot wired starter works, is base line 1st test)




25452221-tk5pw0guzkbs2wb12fwiwrb2-5-0.jpg

Feb 19, 2015 | 1996 Geo Prizm

1 Answer

Where is fuse for taillights in 1996 geo prism


In the fuse box under dash or bonnet.

Nov 09, 2014 | 1996 Geo Prizm

1 Answer

Alternator fuse


hello fuse has two bolts / 1 8 bolt on one side and 1 ten bolt on the other side/ u need socket set

Dec 12, 2013 | Toyota Cars & Trucks

1 Answer

My interior lights dim when i turn my headlights on on my 95 Geo Prism.


Did you check ground strap between Eng. block and ext. fire wall ?

Mar 03, 2013 | 1995 Geo Prizm

1 Answer

NEED TO REPLACE MY THROTTLE CABLE ON MY 95 TRACKER. ANY INFO WOULD BE HELPFUL


take your old one off by prying on socket located on gas pedal.then disconnect by throttle, rotate and it will slip out the side. local junk yard will sell you one for about 20 if you take it off.there is two
types. make sure you have the write one. 1.6 8 valve, 1.6 16 valve. the hard part about taking this off is not to break to many of the prongs off the cable as it goes threw the fire wall. its about 5 min job to replace. tools pliers needle nose 10 mm wrench. hope this helps.

Jan 03, 2011 | 1990 Geo Tracker

1 Answer

1994 geo prism, fuse blew, I don't have manual


the only fuse for the starter is not located in the fuse box it is located in the positive wires that go to the starter its called a fusible link and when then amperage of the starter exceeds the fusible link rating the fusible link blows the link is usually located inthe positive wire to the starter and at some point fatter then the wire itself

May 04, 2010 | 1990 Geo Prizm

2 Answers

1994 geo prism will not start but does turn over


i have a 95 corolla which has same motor, i replaced distributor coils all that turns out it wasthe am2 under thehood fuse box

Jul 09, 2009 | 1996 Geo Prizm

1 Answer

Fuse replacement for 94 Geo Prism


just unbolt it and replace it, that easy

Mar 12, 2009 | 1994 Geo Prizm

1 Answer

How do I replace the alternator on my 95 Gep prism, 1.8l auto trans?


use a tension puller it is a special tool to adjust tension on the pulley

Aug 28, 2008 | 1995 Geo Prizm

Not finding what you are looking for?
1995 Geo Prizm Logo

Related Topics:

269 people viewed this question

Ask a Question

Usually answered in minutes!

Top Geo Experts

yadayada
yadayada

Level 3 Expert

70346 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6864 Answers

Are you a Geo Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...