Question about 1983 Chevrolet Malibu

1 Answer

I have a 2004 grand am , check coolent level warning light.

The fluid level is good , what could be causing this warning light to come on ??

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 1,990 Answers

Open the Radiator Cap and Start the Car. If the Waterpump is Bad it will send this Light, Check inside the Radiator and make sure the Coolant is Flowing Through good. Let Me Know! Please Rate my Solution, I need all the Help that I can Get! Thanks!

Posted on Jan 29, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1996 dodge grand caravan , hear a ding ding ding when pressing brake, no warning lights , whats causing that ?


Safety systems can be surprising...my first inspection would be to check the fluid level in your brake master cylinder...the warning light may not be working...Hope this helps.

Dec 05, 2014 | 1996 Dodge Grand Caravan

1 Answer

IP Brake light has come on in my 2004 Kia Sorento.. what does this mean?


Kia Sorento parking brake or brake fluid dash warning light - this light is illuminated when the park brake is applied, the warning light should go out when the parking brake is released. If the light does not go out it indicates that the brake fluid level in the reservoir is low and you need to pull over and top up at your first opportunity.

1-check parking brakes not applied
2-check brake fluid
3-if it is too low have the brakes checked they might be wearing out it doesn't mean you have a leak but when the brakes wear out the become thin causing the caliber piston to push out more lowering the oil level in the reservoir

Nov 01, 2013 | Cars & Trucks

1 Answer

Abs & brake warning lights come on. if i push the hand/emergency brake and then release it the warning lights turn off. when i ride the brake as i am coming to a stop and release the brake to drive...


{: ) Check first if your brake fluid is low. Better top it up at maximum level. Look also for possible brake fluid leaks. It can also be a fluid sensor or wheel speed sensors at fault. If the warning lights persist, I suggest a scan tool vehicle check to effectively pinpoint the main cause of the warning light issue.

Aug 31, 2011 | 2004 Chevrolet Astro

1 Answer

Warning light for brakes is on,will to much brake fluid in the system cause this


Check if the wires to the level sensor has come off, this can result in the brake warning to come ON.
Also check if the level is low or the sensor float is faulty.

Jun 13, 2011 | 2004 Ford Freestar

1 Answer

Check engine light on


well without more information do what its telling you, after its cooled down check oil level, coolent level, break fluid, transmition fluid, power stering fluid, when checking the transmition fluid you may have to start the car and let the engine warm up, check owners manuel to be sure. and dont forget to check your air filter. all these thing should be labled under the hood. and remember NEVER check radiator coolent while car is hott.. MAKE SURE THE CAR IS COLD AND HAS NOT RUN.. usualy check it in the morning after the car has cooled down over night..

Jun 02, 2011 | 2004 Ford Thunderbird

1 Answer

Red light on dash panel for brakes on what to do


check to make sure the e-brake is not on enough to turn the light on then check the brake fluid level in the master cylinder.if the level is good check the fluid level sensor in the master and make sure its not stuck at the bottom.if the level is low then check for a brake fluid leak and check the brakes as sometimes if the brakes are worn so much the fluid will be low and the sensor will turn on the light as the fluid level in the master is low to take up the worn brakes.as brakes wear the fluid lowers in the master.

May 21, 2011 | 2004 Jeep Grand Cherokee

1 Answer

Check automatic transmission fluid level 2004 Pontiac grand am


TRANSAXLE FLUID CHECKING PROCEDURE



The fluid level screw is intended to be used for diagnosing a transaxle fluid leak or resetting the transaxle fluid level after service that involves a loss of fluid.

Inspect
The fluid level should be checked when the transaxle is near Room temperature or at 40°C (104°F) .

CAUTION: Removal of the fluid level screw when the transaxle fluid is hot may cause injury. Use care to avoid contact of transaxle fluid to exhaust pipe.

The engine must be running when the transaxle fluid level screw is removed, or excessive fluid loss will occur. Since the actual fluid level is unknown, stand clear when removing the fluid level screw. Have a container ready to capture any lost fluid.

WARNING: Do not turn the engine off with the fluid level screw removed as you can be injured by hot transaxle fluid being expelled out of the fluid check hole.

  1. Let vehicle idle for three to five minutes with accessories off.
  2. Apply brake
  3. Move shift lever through all gear ranges, pausing three seconds in each range.
  4. Place shift lever in Park.
Important: Vehicle must be kept level on the hoist.

  1. Raise vehicle on hoist.
  2. Place oil container under fluid level screw.
  3. Remove the fluid level screw with the engine running at idle.
  4. Fluid level should be at the bottom of the fluid check hole. Because the transaxle operates correctly over a range of fluid levels, fluid may or may not drain out of the fluid check hole when the fluid level screw is removed. If fluid drains through the fluid check hole, this transaxle may have been overfilled. When fluid stops draining, the fluid level is correct and the fluid level screw may be installed. If fluid does not drain through the fluid check hole, the transaxle fluid level may be low. Proceed to ADDING TRANSAXLE FLUID.
  5. Install fluid level screw.
Tighten 12 Nm (106 lb. in.)

  1. Lower vehicle.
  2. Shut off engine.
Adding Transaxle Fluid:

With the engine running, add fluid at the vent cap location in half liter (1 pint) increments until fluid drains through the fluid check hole. Allow the fluid to finish draining through the fluid check hole.

  1. Install fluid level screw.
Tighten 12 Nm (106 lb. in.)

  1. Lower vehicle.

Oct 20, 2010 | 2004 Pontiac Grand Am

1 Answer

Brake light on the instrumentation panel on my Toyota Sienna 2004 is "on". The "foot brake" is not engaged. What should I do?


If your brake system seems to be operating ok, then more than likely the system is low on fluid. As brake pads wear, this allows greater travel in the caliper and thus the caliper piston has to travel further to make the pads come into contact with the brake rotor, causing the fluid level to drop in the reservoir. Once the fluid level drops so far, the brake warning lamp will illuminate. When you check the fluid level, also inspect under the vehicle and around the brake lines for and sign of brake fluid leakage that could be causing you to lose fluid as well.

Jun 18, 2010 | 2004 Toyota Sienna

1 Answer

Hi, i drive a Megane Dynamique for about a week now. When I drive it gives me a warning sound for a good few seconds with nothing that comes up on the dashboard. Please help.


hi not sure but check the level of your check fluid make sure its ok and to the level.also your washer fluid level and main coolent water level.it may be slightly low setting off a low level warning.worth a look first.

Jun 08, 2009 | 2003 Renault 181

2 Answers

Temperature warning light coming on,on a 1992 Volkswagen Golf GTI


The thermostat will show what the guage shows. the seal on the coolent bottle can be checked for tightness. so it could be a faulty sensor?

Apr 28, 2009 | 1992 Volkswagen GTI

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

51 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

70387 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6880 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...