Question about 1995 Chevrolet Camaro

1 Answer

I have a 1995 camaro i bought as a project car it originally had a v-6 but when i bought it the motor and transmission were pulled also the wiring harness is cut just outside of the "underhood fuse box" i would like to install a 383 stroker moter but really dont know where to start as far as wiring goes. In the end i also want all the cars factory electronics like radio and windows to work to. what do i do and what are my best options as far as re-wiring?

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 61 Answers

This site might be able to help u. http://www.ls1tech.com/forums/

Posted on Jan 28, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1993 camaro no secrty light wont crank


Most all mechanics pull the dome light fuse before working in the interior to avoid draining the battery.. On the 1994-95 Camaro the 20 Amp fuse courtesy light, also illuminates the orange security light in the dash cluster. If the security light is out, and your car won't start, it's because the VATS is in theft mode and you don't see it. Clean the key, if that don't work you may have an open short or broken wire in the orange jacket of the ignition (key) switch. Disconnect the harness connector and connect a matching resistor with the correct ohms of your key inline with the purple and white wires without cutting the connectors off, because you may latter need them. - Original Owner of 1995 Camaro.

Apr 14, 2014 | 1993 Chevrolet Camaro

1 Answer

Do you have to loosen the motor mounts to remove a transmission from a 1999 SS Camaro? I had a transmission replaced and then I found one of my wire harnesses with the positive battery cable loose and...


if they were replacing the transmission yes they had to pull off all the sensors connected to the tranny and then pull some off the motor to get the old tranny out new in they should replace the harness if they left it loose which they probably did and they had to pull battery wires to replace tranny

Sep 24, 2010 | 1999 Chevrolet Camaro

1 Answer

Where is the dip stick to check the transmission fluid on my 1995 Camaro?


The rear wheel drive gm's, Faceing the front,dipstick tube just behind the left side of the engine,and crouded there in front of the firewall. Check the fluid level with the engine warm, idleing in park.Pull the dipstick ,wipe it dry and insert it back,pull out and check the fluid level ,it should be on the full mark,if not add some,a cup at a time,careful not to add too much. ,

Sep 17, 2010 | 1995 Chevrolet Camaro

1 Answer

Camaro spark plug wires


any parts house will have a picture of the routing in there manual

Dec 18, 2009 | 1995 Chevrolet Camaro

1 Answer

What stock transmission and rear end are on the 95 camaro coupe? Will any year corvette rear end and transmission fit on 95 camaro? Will a 3.8 v6 supercharged motor fit under the hood of 95 camaro?


What you are thinking about doing is all "custom mods"...Nothing is impossible but what you are asking will take a huge pile of money and a lot of expertise. Corvette differentials are completely different and require extensive modifications to install, with very little benefit other than being "different" and a good conversation piece. Likely you would be better served by installing a diff made by Strange Engineering which would be far stronger. In a Camaro, you would also benefit more by using a good 350 engine (performance crate version) with a 700r4 transmission behind it (more reliable and less aggravation) The biggest problem would be getting a wiring harness and ignition system to operate the whole thing, but being a Chevy, there are a great number of suppliers of aftermarket harnesses to work with. That said, it will still take a heap of $ and experience to get it all together!!!
Good luck though!!!

Jun 18, 2009 | 1995 Chevrolet Camaro

1 Answer

1995 camaro just bought the car driver side


sounds like nu window motor replacement time if you get voltage to motor ( test light ) its motor

Apr 12, 2009 | 1995 Chevrolet Camaro

4 Answers

Rebuild manual


check ebay for a genuine GM service manual.

this should work, ask the seller to make sure it covers transmission rebuild. (it should)

http://cgi.ebay.com/ebaymotors/1995-Camaro-Firebird-Service-Manual_W0QQcmdZViewItemQQ_trkparmsZ72Q3a317Q7c66Q3a2Q7c65Q3a12Q7c39Q3a1Q7c240Q3a1318Q7c301Q3a0Q7c293Q3a1Q7c294Q3a50QQ_trksidZp3286Q2ec0Q2em14QQhashZitem280314278442QQitemZ280314278442QQptZMotorsQ5fManualsQ5fLiterature

Feb 21, 2009 | 1995 Chevrolet Camaro

1 Answer

1995 camaro wiring problems


PAINLESS WIRING makes aftermarket harnesses, check them out

Jan 28, 2009 | 1995 Chevrolet Camaro

1 Answer

Ignition wiring


firingorder6a.gif firingorder6.gif 1991-1994 2.9L and 3.0L Engines Firing Order 1-4-2-5-3-6 1995 And Later 3.0L V-6 With DIS Ignition System Firing Order 1-4-2-5-3-6
4.0L Engines Firing Order: 1-4-2-5-3-6 DIS Ignition System

Nov 22, 2008 | 1995 Ford Ranger Supercab

Not finding what you are looking for?
1995 Chevrolet Camaro Logo

234 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

61249 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...