Question about 1999 Jeep Grand Cherokee

1 Answer

How can I reset my Factory Alarm on my Jeep it wont run

My 1999 jeep grand cherokee horn started blowing and i had to put the fuse to stop it now my jeep will run for a few minutes then shut down or it wont start...

Posted by on

  • 1 more comment 
  • patrioticbab Jan 29, 2009

    Thank You very much I did what you said and it started right up..

  • mosaicart May 10, 2009

    o.k I do not have a disarming thing! and I do not want to have to jump in my car and drive real fast to get it to stop!
    Every time I open my car door with the key it starts blowing ansd I can not get it to stop without taking out the horn fuse, so how do I fix or take out this alarm and also I lost the unlock key chain I only have a key :-0

  • Anonymous Mar 23, 2014

    TURNS OVER BUT WON,T START AND GAGES DON,T WORK

×

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 118 Answers

Alarm Module Reset Procedure
NOTE: This information applies to a Vehicle Theft Security System (VTSS) that was armed when the battery was disconnected and reconnected.
When the armed VTSS senses that the battery has been disconnected and reconnected, it enters its power-up mode. In the power-up mode the alarm system remains armed following a battery failure or disconnect. If the VTSS was armed prior to a battery disconnect or failure, the system will have to be actively or passively disarmed following a battery reconnection.
The power-up mode will also apply if the battery goes dead while the system is armed and battery jump-starting is attempted. The engine no-run feature will prevent the engine from starting until the alarm system has been actively or passively disarmed.
Passive disarming of the Vehicle Theft Security System (VTSS) occurs when the vehicle is unlocked using the key to unlock either front door or the lift gate. Active disarming of the VTSS occurs when the vehicle is unlocked by depressing the Unlock button of the Remote Keyless Entry (RKE) transmitter.
Once the alarm has been activated (horn sounding, lights flashing, and the engine no-run feature), either disarming method will deactivate the alarm.
Depressing the Panic button (if equipped) on the RKE transmitter will also disarm the VTSS, but the horn will sound and the lights will flash for about three minutes as part of the Panic feature. The horn and lights can be stopped by pressing any of the RKE transmitter's buttons or driving the vehicle above 15 mph.

Posted on Jan 28, 2009

  • Darrell Feb 01, 2009

    thanks for the comment if ya need any more info let me know always waiting to help a brother in need DB

×

Ad

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

Ad
walt36
  • 4 Answers

SOURCE: 1999 JEEP GRAND CHEROKEE LAREDO

i have a 95 jeep grand cherokee lerado from time to time my alarm goes off i dont have a remote 4 my alarm but i found out that if you put the key in the driver door and unlock it. it will reset the alarm!!!!!

Posted on Dec 12, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 1994 jeep grand cherokee and it always starts up, but sometimes it just shuts off randomly while I'm driving and after a few minutes of rest turns back on, the battery will still be worki


Install a new crank shaft sensor. I had the same problem with my wife's Jeep. It would run fine fore days at a time then quit. When the crank sensor goes out their is no spark or injection of fuel into the engine. This is a Hall Sensor. They can be intermittent, and affected bu heat. If your Jeep will not start, try freeing the sensor and see if it starts. Cold Freeze is used in electronics to test

Apr 17, 2013 | 1999 Jeep Grand Cherokee

1 Answer

Jeep alarm goes off for no reason after a few minutes


IT is probably just letting you know that it has received the lock signal and has secured the vehicle. Horn beps or clearence lights flask

Feb 03, 2013 | 1999 Jeep Grand Cherokee

2 Answers

Constant horn that won't shut off


This could be three things.
1. The relay is stuck, this is under the hood and is probably not the issue.
2. There is a wire in the steering column called a coil spring and it could be broken or damaged.
3. The actual switch on the steering wheel has a short in it.

Jan 17, 2013 | 2000 Jeep Grand Cherokee

1 Answer

My jeep grand Cherokee will shut off and all the gauge on dashboard turn on


It could be the O2 sensor and the camshaft sensor. I have the same Jeep and having the same issues. Auto Parts stores have the sensor, just need to find a good mechanic that wont over charge you. When you do, ask then to run the codes to make sure.

Mar 21, 2012 | 1999 Jeep Grand Cherokee

1 Answer

My jeep horn has stopped working the fuse is fine but I dont know where the horn is to check any wires


its usually under the front bumper my horn doesn't work either in my 1999 Jeep Grand Cherokee but it bother me its just a horn and i like it disabled because when i unlock my car the flasher go off so i disabled the horn so it wouldn't beep when every-time i unlock it just the flashers go off which doesn't bother me

Nov 10, 2009 | 1999 Jeep Grand Cherokee

1 Answer

Shuts off goin down the road and blows a fuse


you have a short,a hot wire touching ground.

Aug 15, 2009 | 1996 Jeep Grand Cherokee

1 Answer

No horn in '94 Jeep Grand Cherokee


go to the horn under your hood, check it for any thing wrong, then follow the power wire and follow it back to your steering wheal. this is where your problem is you just have to find out where the short is. and fix it.

tepfy

Apr 04, 2009 | 1994 Jeep Grand Cherokee

1 Answer

Radiator fan wont shut down run constantly not running hot


its most likly your fan relay switch located behind the right headlite

Mar 23, 2009 | 1999 Jeep Grand Cherokee

2 Answers

1999 4.0L Jeep Grand Cherokee shuts down after 20-30 minutes.


I'd suggest the ignition control module, however I'd have a certified mechanic check it out just in case...

Feb 01, 2009 | 1991 Jeep Cherokee Briarwood

1 Answer

Disarm malfunctioning alarm system jeep cherokee 1999


try to find a fuse and take it out it may have one just a guess

Dec 28, 2008 | 1999 Jeep Grand Cherokee

Not finding what you are looking for?
1999 Jeep Grand Cherokee Logo

3,900 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

78267 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...