Question about 2007 Dodge Ram 3500 Quad Cab Laramie

1 Answer

My wipers are in the middle of the windshield when i turn them off can i re calibrate them

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 840 Answers

Yes you can take the cover off the end and loossen bolt and pput them where they should be/ Please rate my response thank you very much

Posted on Jan 29, 2009

6 Suggested Answers

emissionwiz
  • 70364 Answers

SOURCE: Wipers Pause on middle of windshield

Yes the solution is to replace the wiper motor, the auto park circuit is defective.

Posted on Aug 28, 2008

  • 132 Answers

SOURCE: windshield wipers stuck upright when off

It is the fuse or the pulse board. Most likly the pulse board though

Posted on Jan 30, 2009

  • 85 Answers

SOURCE: windshield wipers won't work right

The windsheild wiper relay might be stuck or broken. Try tapping it with something or replace it. Could also be the the switch (lever that you control the wipers with) i hope this helps and good luck with diagnosing your problem.

Posted on Feb 21, 2009

  • 2 Answers

SOURCE: 2000 Saturn LS, windshield wipers park in the

The wipers are parking in the middle because the timing mechanism is off. Once they start doing this it seems to continue to happen so the 1st suggestion is to replace the wiper motor. If U don't want to spend the $ right now it's a pretty easy fix to reset the timing. Park the wipers & remove the wiper arms. Then remove the plastic cowling that covers the wiper motor & the motor assembly. Turn the wiper assembly over without turning the motor. Remove the nut on the arm of the motor. Repostion the arm pointing away from the closet wiper directly inline with the short arm. reassemble.

Posted on Apr 11, 2010

  • 731 Answers

SOURCE: wipers stop in middle of windshield when turned

The control board on the wiper motor has ametal "stop" that got bent.
This usually happens when the wipers are stuck ( frozen from ice?) and turned on.
This can be readjusted bu bending back to original position or replacing the control board
About $35 for part

Posted on Jan 05, 2011

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

When I turn off my windshield wipers they stop in the middle of the windshield. Why?


There is a tab that bends and sometimes brakes. When you shut off the wipers the wiper motor reverses and is supposed to catch a tab to park the wipers. If the tab misses the catch they stop in the up position.

Feb 14, 2011 | Pontiac Grand Prix Cars & Trucks

1 Answer

My wipers when turned on intermitant stop in middle of windshield,they will start again like normal but every cycle stop in middle of windshield they park like normal when you turn them off vehicle is a...


The intermittent function for the wipers has a variable resistor that controls the timing of the wipers in this mode. Replacement of the wiper switch will resolve this issue. Over time they do become worn, and do not make contact during the entire wiper cycle.

Jan 08, 2011 | Pontiac Grand Prix Cars & Trucks

1 Answer

Wipers automaticly turn and stop in the middle of windshield


Bad circuit board. Can't think of the name. Someone familiar with your veh will tell us. Any repair shop can fix it for you
Don't ever push on the wiper arms or you'll damage the linkage

May 06, 2010 | 1997 Chevrolet Cavalier

1 Answer

How to take off windshield wipers on camry 2008


turn on wipers till they are half way across the windshield. turn off car. there is a little push clip in the middle of the wipers. push in smartly and pull off the wiper at the same time. the new wipers with have replacements with them.

Feb 16, 2010 | 2008 Toyota Camry

4 Answers

2000 Saturn LS, windshield wipers park in the middle of the windshield. How can I fix this?


The wipers are parking in the middle because the timing mechanism is off. Once they start doing this it seems to continue to happen so the 1st suggestion is to replace the wiper motor. If U don't want to spend the $ right now it's a pretty easy fix to reset the timing. Park the wipers & remove the wiper arms. Then remove the plastic cowling that covers the wiper motor & the motor assembly. Turn the wiper assembly over without turning the motor. Remove the nut on the arm of the motor. Repostion the arm pointing away from the closet wiper directly inline with the short arm. reassemble.

Oct 24, 2009 | 2000 Saturn Ls 4dr Sedan

1 Answer

Wipers stop in the middle of windshield when turned off


check to make sure the wipers are at its right angle on the vehicle, loose the nuts and place both wipers close to the bottom of the wind screen

Jul 16, 2009 | 2006 Chevrolet Impala

1 Answer

2006 kia wipper works but stops in the middle of the windshield


It sounds like the the circuit board has gone bad and does not know where the base is any more so it will stop at the middle or the windshield. Auto Zone should have a new board if it's replaceable like the GM products. Good luck and hope this helps, In the mean time you can always turn your wipers on and pull the fuse out when it's at the down position so it's not up.

Jul 11, 2009 | 2006 Kia Amanti

2 Answers

Instructions aligning wipers on a 1998 Gran Prix GT


Loosen the nut on top then realign them then tighten the nut. I have to do mine every time they get frozen.

Apr 04, 2009 | 1998 Pontiac Grand Prix

Not finding what you are looking for?
2007 Dodge Ram 3500 Quad Cab Laramie Logo

133 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

70347 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6876 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...