Question about 2001 Ford Explorer Sport Trac

1 Answer

My 4 wheel drive just stopped working

I go into my truck to move it and turned the 4 wheel drive switch on. It worked fine. The next day I went out to use it and the light that comes on to show it has gone from 2 wheel to 4 wheel did not come on, nor did the truck go into 4 wheel drive.

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 48 Answers

The vacuum tube that operates the transfer case is stopped up or pinched

Posted on Jan 28, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Intermittent starter issues. On my boat it very hard to access the starter and solenoid. When my boat starts it runs perfect. I can start and run it and shut it off numerous times. Now twice it has refused...


replace the solenoid,but,if you are worried about being stranded,while you are there,replace the starter and on all connections,use electrical grease,to keep corrosion away,always use lock washers so nothing gets loose too.

Jul 20, 2015 | Cars & Trucks

1 Answer

96 explorer disengages 4wh low but does not engage 2wheel


Does it shift to 4wd high range ? If so then shift to 2wd . What is going on here is the transfer case motor is stopping due to the motor position sensor has gone bad which means that you replace the transfer case motor assembly. But if you wish to make it a 2wd for awhile then remove motor and manually turn shaft . This can be done by raising and supporting rear axle truck in park remove motor turn shaft slowly with pliers and rotating the play in drive shaft. There are stamped markings on back of case showing gear positions..

Mar 31, 2014 | 1996 Ford Explorer

1 Answer

Hyundai Sonata 2004 turn signal does not work properly


did you check the directional switch. sounds like you have a bad one

Nov 07, 2012 | Hyundai Sonata Cars & Trucks

1 Answer

20001 vw jetta tdi automatic transmission problem


Ok , so you got home , parked it and when you started it up the next day and shifted it into reverse... backed out... and went to shift into drive , it stayed in reverse ?
Have you checked to see that the cable has not disjoined itself from the shifter to the trans.?
Are you able to engage Park?

Nov 10, 2011 | 2001 Volkswagen Jetta TDI

1 Answer

4 wheel drive does not engage


actuator may need service[lubed ]connection or wiring loose or damaged

Feb 22, 2010 | 2003 Chevrolet TrailBlazer

1 Answer

Turning Signals keep blowing and signals cancel cruise control.


Sounds to me that the turn signal switch is bad and will have to be replaced. If you could wiggel it around and get them to work tells me that is wear the problem is.

Feb 11, 2009 | 2005 Chevrolet Cavalier

2 Answers

Service 4 wheel drive on info center


i had the same problem with my 03 silverado.it's a internal problem in the 4WD actuator.my truck would go in 4WD sometimes and some other times the service 4WD light would come on and it would not got in..after a while it wouldn't go in at all so i replaced the actuator and it fixed the problem..

Jul 07, 2008 | 2004 GMC Sierra 1500 Crew Cab

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

319 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

61037 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Fordexpert

Level 3 Expert

5331 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...