Question about 1992 Ford Explorer

1 Answer

1997 ford f 150 bogging down

I replaced the cats and now it only boggs down when you drive normal if you gas hard it is fine just drive normal wants to bogg down and will not go over 75 miles per hour

Posted by on

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 24 Answers

Check the exhaust compression. Remove the O2 sensors before the cataylic converts and see if it improves. If it does that means your cats are cloged and need to be replaced.

Posted on Feb 21, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 2011 Ford Escape boggs down then dies


if the engine light is still on take somewhere and find out what the problem is

Mar 02, 2014 | 2011 Ford Escape

1 Answer

5.7 liter vortec runs fine on startup then boggs down


check the fuel pump pressure you might not be getting the amount of fuel your truck needs to keep running an easy way to check is to tap the gas when it starts to bog if it picks back up thats what the problem is.

Jul 24, 2012 | Cars & Trucks

1 Answer

Bogs down when i accelerate


Make sure your injectors are all working i had a s10 with two injectors and one was not working right and it bogged down. And fuel pressure can cause this.

Dec 22, 2011 | 1997 Oldsmobile Eighty Eight

1 Answer

Bogging


So who told you that, did they check it, or just guessing? Whats the fuel pressure? Cat converter ok?

Mar 19, 2010 | 1995 GMC Jimmy

3 Answers

1998 Ford F-150 4.2 V6 starts and idles fine ibut bogs when step


i had a van do this same thing to a tee turned out to be a broken key pin in the harmonic balencer causing the timing to ****** replaced balencer and ran like a dream there is a crank sensor grid on the balencer when the key pin broke it trew the timing off

Feb 28, 2010 | 1998 Ford F150 Regular Cab

1 Answer

I have an 1988 ford bronco 2 automatic V6 i pulled


There are shift solenoids in the transmission and apparently there's a problem them. I would get it to a trany shop and have it checked right away. If you continue to drive it you will ruin the transmission. Are sure you put the right computer in the vehicle? If you put a computer from a Bronco II with a manual trans in a vehicle with an automatic trans, the trans won't work right.

Jan 22, 2010 | 1988 Ford Bronco

1 Answer

Grinding when in reverse and tries bogging down at lights


stop shifting so hard. your reverse gear is the same exact gear as your first, so if you shift hard and grind that gear a little then reverse will be harder to get into. you probably need your transmission rebuilt the harder your engine has to work the more its going to bogg down

May 14, 2009 | 1987 Ford Ranger

1 Answer

My 1989 dodge dakota 3.9 V6 isn't acting right.


make sure that the exhaust system is not restricted at one of the cat converters,either plugged or damaged.

Feb 20, 2009 | 1989 Dodge Dakota 2WD

1 Answer

1976 Ford F150 Bogs down when accelerater is pressed.


if it has a converter on it.....it may be stopped up, but before you replace it have the fuel pump checked, as it may not be getting enough gas at higher rpms. It will start and idle fine, but starve out when you press the pedal. Have you changed the fuel filter?That will cause the same problem.....

Jan 30, 2009 | 1983 Ford F150

Not finding what you are looking for?
1992 Ford Explorer Logo

Related Topics:

147 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

61168 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Fordexpert

Level 3 Expert

5331 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...