Question about 2002 Toyota 4Runner

1 Answer

Windshild liquid is not working, the tank is full

Windshild

Posted by on

  • kjosue Feb 01, 2009

    it work, it was about cold temperature

×

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 124 Answers

If you are in an area that has been experiencing extreme cold, then the fluid may be frozen in the line. To remedy this, take the vehicle to a carwash and spray the lines with the hot water until the car wash stops (1 quarter's worth). Then try the washer again.

The pump could be malfunctioning. With the key in the accessory position, have someone under the hood listen for the pump running. If the pump runs, you're in warmer climate and no fluid is being sprayed, then your pump may be defective.

Posted on Jan 28, 2009

  • Bernie Thames
    Bernie Thames Jan 30, 2009

    Is your problem resolved or do you need additional help? Your feedback would be beneficial. Thanks!

×

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Fuel capacity of the tank is 62 liters but the tank is full with 32litres what is the cause?


If the tank is actually a 62 liter tank and you are only able to put 32 liters in to it....either the instrument being used to measure the amount of liquid being dispensed is not registering correctly, or the tank is half full when you start to fill it.

Jan 10, 2017 | Cars & Trucks

1 Answer

1994 ford ranger 2.3 fuel pump has burned out after 2 weeks, Why?


how full do you keep the tank..electric pumps will cavitate when the tank is less than 1/4 full..they use the liquid tokeep cool..also have you put on a new filter? if not do so.. theclogged filter will make the pump work harder..

Jan 15, 2014 | Ford Cars & Trucks

1 Answer

The windshild washer will not work on either of my reatta's. says low fluid but the tanki is full, can anybody give me some insight as to what the problem may be. Thanks


Dont know about this american model but on our dinky toys here in europe what happens is the blus screen cleaner stuff a lot of people use makes the rubbers swell up ,so the valve cannot move across inside the washer motor pump ,so what i do rather than fit a new motor is to pull the pump out then on the bottom is a fitting with 2 outlets ,well i remove this and take the little piston with a rubber seal on each end and grind the rubber down on the bench grinder so it can move inside the chamber from side to side and refit the pump and it will live another day maybe even a couple of years ,the lever sender i think could have the same problem either the float is punctured or a rubber has swollen with the effects of this strong screen cleaner.I always use water with small squirt of genuine fairy liquid .

Jan 03, 2013 | 1989 Buick Reatta

3 Answers

How to remove winsheild


you need a windshield remover, has a piano wire on it,

or you could try to start cutting with knife inside the car all around
start at one spot apply pressure keep going.

Now make sure to disconnect neg. battery or you could pop airbags
to install new one make sure all the framing is completely clean no old urethane
cut v into urethane tube and apply high bead of about 3/4"
you have to apply alot of force to set it, professionals have suction cups that apply to glass and tye rope around both seats overnight.
dont drive for 12 hrs as your efforts will have gone to waste by breaking your urethane seal

Feb 15, 2011 | 1992 Lincoln Town Car

1 Answer

I recentally installed a brand new raidaitor in my 1995 honda passport 3.2 L 4 wheel drive ,and also replaced the theromstat with the recomended 170 degree one and now my windshild defroster dose not work...


no wonder w/a 170 it take all day put a 195 or 190 . 170 is fine for summer but winter got to have a little higher one not going to hurt nything just get warm faster & better

Dec 26, 2010 | 1995 Honda Passport

1 Answer

Check engine light indicator is on...after total


Obviously you have something above the tank that's leaking. That will result in a code the same as a bad or loose gas cap. At this point, the only way you can find the source is to take a good look at everything, even if it means dropping the tank to do that. (better than wasting fuel or having a fire start under there).

Jun 11, 2010 | 2000 Jeep Grand Cherokee

1 Answer

Windshild wipers stop intermittingly seems to


your windsheild wiper problem is the wiper module. replace the windsheild wiper module and you'll fix this problem.

Jan 21, 2010 | 1997 Chevrolet S-10 Pickup

2 Answers

2006 chevy impala windshield wiper fluid will not work. It's not frozen, and the tank is full. Do I need a new pump, and if so where is the pump located?


I just fixed the wifes 2006 Impala, windshild washer. If you look at the manual, under the hood fuse panel, you will find two fused identified as windshild wiper. The one at the bottom is the washer pump. They even conviently provide a spare (10 amp) fuse just below it. swap out and ops check okay. Hope this helps.
SundogKB

Jan 18, 2010 | Chevrolet Impala Cars & Trucks

1 Answer

Rain water leaking into driver and rear passenger floor wells - 2003 A4 CAB


this problem is most likely a sealing problem in either your doors or on your windshild. to check the doors first is the easiest, if you have had your windshild replace recently the that would give a god indecation. or you might just have a small rust hole around there. and then there is the your fresh air intake for your enviroment systems might have a hole. look around at all these places, but just know looking for holes is pretty labor intenstive because if you want to see everthing normally your taking alot apart

Dec 02, 2009 | 2003 Audi A4 Cabriolet

Not finding what you are looking for?
2002 Toyota 4Runner Logo

182 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8575 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...