Question about 2011 Ford Transit Connect

Open Question

04 transit connect heater resistor location - 2011 Ford Transit Connect

Posted by Anonymous on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I remove and install heater blower motor


04-08 Pontiac Grand Prix - Blower Motor Resistor ... - YouTube

? 7:32
https://www.youtube.com/watch?v=Cn0HeJP8bZQ
Oct 8, 2012 - Uploaded by GPVlog
04-08 Pontiac Grand Prix - Blower Motor Resistor ReplacementPart 1 ..... Loosen, but do not remove the two frontward screws, then remove the single rearward .... Pontiac Grand Prix StereoRemoval 2004-2008 - Duration: 4:27. by Factory Car Stereo ...Pontiac Grand Am ,HVAC, Heater Fan will not turn on.

04-08 Pontiac Grand Prix - Blower Motor Repair (Part 1 ...




Dec 03, 2015 | 2004 Pontiac Grand Prix

1 Answer

Would like to know what fuse is for my blow heater in my 54 plate ford transit


If your blower has multiple speeds, a fuse may not be at fault.

The speeds are set using a tapped resistor which may be on the firewall of the engine compartment.
If these fail. often the highest speed will still work but none of the others.

There are too many shapes and sizes for these but many are shown here if you find the fuse is OK:

heater blower resistor Bing images

Feb 03, 2015 | Ford Cars & Trucks

1 Answer

Where is the heater blower resisitor located on a 07 transit connect?


I'd say under the hood, passenger side firewall near the heater blower. A plate with multiple wires attached mounted on the air plenum. It is usually mounted in the airstream of the heater fan to keep it cooled.

Oct 19, 2014 | Ford Transit Connect Cars & Trucks

1 Answer

Remove heater control switch


Before removing the heater switch on this 2006 citroen hdi I would first have the blower motor checked and the most common reason for this and other blower problems would be the blower resistor.

Your blower works on and off at times, first locate the blower motor and the resistor. the blower motor is located on the heater box, look under the pass/side of the dash, you may have to remove under dash cover to see blower.
When you have located the blower now look to the side on the heater box, there you will see a connector plug, it plugs into a connection on the heater box, this will be the resistor, the resistor slides into heater box and the end of it bolts to box to hold it in place and then the connector plugs into it, if you can not locate it then follow wires that plug into blower , follow wires back they will lead you to resistor,
next time blower does not work wiggle connector to resistor and see if blower turns on, if it does then resistor is the problem. also unplug resistor plug at resistor and check for any burning of connectors at plug and inside resistor.

I would bet its a bad resistor or the plug is brunt due to high draw from bad connections, if plug has burn damage to connectors then replace the plug along with resistor.

Jul 08, 2012 | 2006 Citroen C5 HDi

1 Answer

Heater works sometimes


Sounds like a loose connection. Pull the connector off at the blower motor and check that the wires still fit tight in the plastic connector. Look for any chance that a wire might pull back and lose connection. You also might want to pull off and check the connection to the resistor pack located close by. The resistor pack is screwed or bolted into the heater case. Take that out and check that it is alright. A broken resistor wire might cause this, also.

Nov 04, 2011 | 1993 Chevrolet Cavalier

2 Answers

Heater fan only blows on high


I believe there are TWO fuses for the heater blower. One for the lower speeds and one for the high speed ONLY. REcheck the fuses or refer to the owner's manual for the location...

Dec 15, 2009 | 1998 Chevrolet K1500

1 Answer

Blower motor fuse is located 99 mercury cougar


SECTION 412-04: Control Components 1999 Cougar Workshop Manual REMOVAL AND INSTALLATION Blower Motor Resistor Removal
  1. Remove the upper footwell trim panel (passenger side).
    • Remove the pushpins.
  1. Disconnect the blower motor resistor electrical connector.
  1. Remove the blower motor resistor.
-------------------------------------------------------------------------
f9d16f6.gif

May 06, 2009 | 1999 Mercury Cougar

1 Answer

Heater won't turn on


replace your blower motor resistor its about 20 bucks and i could only find one at the dealer i had the same problem 4 months ago if that doesnt work your next option is the blower motor but im 90% sure its the resistor 04 dodges have alot of problems with that resistor burning out it is located on the passenger side beside the blower motor two bolts holding it in it will be a rectangle shaped piece of plastic just un clip it and clip the new 1 in

Mar 24, 2009 | 2004 Dodge Dakota

1 Answer

A/c heater fan no blow


sounds to me like the blower motor resistor, and if I'm not mistaken the resistor and the blower motor are located under the dash on the passengers side. the resistor should have a wiring connection and 2 screws attaching it to the blower case. The a/c and heater blower will not work if the resistor goes out. hope this helps you out a little. Best wishes.

Jan 16, 2009 | 2006 Jeep Grand Cherokee

Not finding what you are looking for?
2011 Ford Transit Connect Logo

Related Topics:

513 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5501 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...