Question about GMC Rally

Open Question

1991 nissan pickup d21 replace blower motor

Need to know how to fix the issue

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 82 Answers

SOURCE: AC blower motor resistor Nissan Maxima 2000

yeh its located under the passenger side glove box,its in the heater box beside the heater motor ,,2 scews hold it in and it looks like a credit card when its out,,,,

Posted on Apr 19, 2009

Ad
paconos2007
  • 19 Answers

SOURCE: How can I set ignition timing for a 1993 Nissan pickup D21 2.4L

the mark to the right of the pully will be 0 .. it will be like this. 8 6 4 2 0

Posted on Apr 21, 2009

  • 10 Answers

SOURCE: Can't get the starter out of a 1991 Nissan pickup.

The second bolt is hidden way up and tucked in near the solenoid. You need to setup a ratchet with extensions/socket (14mm) combination that is just a little longer than the starter motor. If you just can't picture where the bolt is, then go down to the parts store and look at/purchase the replacement starter to see how it mounts up.
There are two bolts for the starter mount and one nut for the main starter power lead. There is one plug for the starter key switch.
Disconnect plug. Loosen lower bolt. Remover upper bolt. Remove lower bolt. Twist starter so you can remove main power cable nut (be sure to have disconnected the battery first!) Pull starter.

Posted on May 10, 2009

  • 10865 Answers

SOURCE: I have a 1986 Nissan Pickup D21 that bogs down

your carberator is gummed up. Go to the auto parts store and get a can of seafoam fuel additive. Read the label so you get enough but as I recall you put in one ounce per gallon of gas. Run that through your pickup for a few miles and it will purr again.

Posted on Sep 16, 2009

sandman357
  • 236 Answers

SOURCE: where is fuel-filter on 2.4L D21 Nissan pickup?

it should be under the car close to the driver side door. if you can't see it trace it from the fuel tank it should be attached to the fuel line. if you have the repolacement in your hand you will know what you're looking for

Posted on Feb 28, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1991 nissan pickup d-21 blower motor cuapassator, replace


There is no capacitor on that electric motor. They are not well made and have to be replaced. http://www.autopartswarehouse.com/shop_years/nissan-d21-blower-motor-1991.html

Aug 02, 2016 | 1991 Nissan Pickup

1 Answer

Heater Switch


Switch could have burned out,but not likely.Use a hot and ground wire to the motor after unplug the wires to see if motor runs.First,after unplugging the motor,flip the switch on and check power on the plug with a test light.

Apr 17, 2014 | 1991 Nissan Pickup

1 Answer

Ignition timing



1991 Nissan/Datsun Truck D21 Truck 2WD 3.0L FI 6cyl

The Ignition Timing
15 Degrees Before top dead center*Warm idle speed 750 RPM*Transmission in neutral (Parking brake engaged)*All accessories off.

1991 Nissan/Datsun Truck D21 Truck 2WD 2.4L FI 4cyl

The Ignition Timing
10 Degrees Before top dead center*Warm idle speed 800 RPM*Transmission in neutral (Parking brake engaged)*All accessories off.

Mar 24, 2014 | 1991 Nissan Pickup

1 Answer

1991 nissan D21 truck 2.4 engine vacuum diagram


Can someone email this diagram to me I need it as well. We have a 1991 Nissan Hardbody we are putting back in today.

Jul 28, 2011 | 1991 Nissan Pickup

1 Answer

Where can i find a replacement bolt for a 1991 nissan d21 clutch pressure plate


you can get one from nissan, or you could take the bolt to a machine shop and have one made, or the junk yard. thats about the only thing i know of.

Nov 29, 2010 | 1991 Nissan Pickup

1 Answer

I need to know what the timing needs to be set to on my 1987 nissan D21 pickup


Click on the following free direct Link. It has the correct Timing Belt Diagram for your 1987 Nissan D21 Pickup with the unspecified 2.4L SOHC In-Line 4, or the 3.0L SOHC V6 Engine.

Let me know if this helped, or if you have additional information questions. Feel Free to contact me at FixYa.com!


http://www.2carpros.com/car_repair_information/year/1987/make/nissan/model/pickup/1987_nissan_pickup_timing_belt_diagram_marks.htm

Apr 10, 2010 | 1987 Nissan Pickup

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

73 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

76691 Answers

Freddy

Level 3 Expert

1311 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...