Question about 2005 Nissan Murano

Open Question

2005 Murano lift gate won't open with exterior switch

Has new switch and lock aasembly

Posted by Anonymous on

Ad

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
  • 6 Answers

SOURCE: 2005 Murano windows open by themselves

I had that happen too and found out that if you hold the unlock button down on your FOB for about 4-5 seconds then it will roll down the front windows. It's actually a feature, not a problem. You may have accidentally mashed something up against the FOB while it was in your pocket and you were within range of the car. That's what I did. Freaked me out the first time I walked out in the driveway and both front windows were down and I know I didn't leave them open.

Posted on Jul 21, 2009

Ad
s_s_m_o_k_i_
  • 162 Answers

SOURCE: 2003 Nissan Murano Driver door won't lock or unlock with keyfob

about 14 bux at this link
http://www.autopartswarehouse.com/search/?N=5716+776&Nr=AND(wpn_tl_name:Auto+Body+Parts+%26+Mirrors,wpn_scat_name:Door+Lock,wpn_cat_name:Doors+%26+Components)&refType=Brand&refValue=Replacement

Posted on Jul 31, 2009

  • 60 Answers

SOURCE: I have a 2005 Murano three of my locks are not

Locks are supplying whith pneumatic comp. make sure all the hosue are not have hole

Posted on Aug 08, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do you open the lift gate wont work? I have a 2007 Acadia and there is no silver lever visible through the access hole. is there a way to mechanic a way to jumper it?


Has to have it .
Liftgate Trim Panel Plug
Procedure
From inside the vehicle lower the second and third, if applicable, row seats.
Use a small flat-bladed tool to remove the access plug from the liftgate lower interior trim panel.
Push on a silver lever located on the right just through the access hole to unlock the liftgate.
Open the liftgate from the outside of the vehicle using the exterior handle.

Outlook Traverse Acadia Enclave Lift Gate Won Open

Aug 24, 2017 | Cars & Trucks

1 Answer

I have 2005 chevy tahoe my doors all licks but my liftgate door with window stays open use to lock w all my doors? I havent check anytjing yet? I cant lock it.


Here is how it works !
Liftgate Locking Operation
The lift gate will lock any time the vehicle is shifted out of park on vehicles equipped with an automatic transmission and at vehicle speeds exceeding 5 kph with manual transmission. This happens in conjunction with auto door locks if enabled or independently of auto door locks if the feature is disabled. This ensures that the lift gate is locked anytime the vehicle is shifted out of park or when the vehicle is in motion.
The lift gate lock relay supply and coil sides receive a constant voltage through the battery voltage supply circuit and the ECC fuse. The normally closed contact is connected to ground and the control side is connected to the body control module (BCM). A lock function will occur when a door lock switch activation, keyless entry lock transmission, auto door lock function or a lift gate lock function has been received by the BCM. The BCM will then ground the control side of the lift gate lock relay. This energizes the relay and allows voltage to be applied to the lift gate lock actuator lock control circuit. Since the other side of the lift gate lock actuator is connected to the normally closed contacts of the door unlock relay to ground, the lift gate will lock. When an unlock function occurs the BCM will ground the control side of the unlock relay and the rear doors and lift gate will unlock.
The BCM also runs diagnostics on the lift gate lock relay control circuit and will set DTC B3825 as current and also send a Class 2 message to the DIC. The DIC will display REPLACE LIFTGATE FUSE to inform the driver that a fault has been detected in the lift gate lock circuit and that the lift gate is not locked. Faults that will set the DTC and cause the DIC to display the message could be any of the following:
?€¢
An open ECC fuse


?€¢
An open or short to ground in the lift gate lock relay battery positive voltage circuit


?€¢
A faulty lift gate lock relay


?€¢
An open or short to ground in the lift gate lock relay control circuit


?€¢
A short to ground in the lift gate lock actuator lock control circuit


?€¢
A faulty BCM

May 14, 2016 | Cars & Trucks

1 Answer

How do I opened locked tailgate buttons don't work or key switch?


will glass pop open with remote or key ,whe nyou turn handle if so you may need to remove tailgate trim panel to acess handle assy so you can open it by moving lock rods inside tailgate panel

Dec 17, 2014 | 2008 Lincoln Navigator

1 Answer

Get 2009 nissan murano lift gate out of safe mode so I can replace the shocks.


please explain the language here as iam at a loss -LIFT GATE??? do you mean the back door or tailgate ,sorry its getting late in this time zone and i think its near my bedtime

Nov 20, 2014 | 2009 Nissan Murano SL

1 Answer

Toyota 4runner Lift Gate Won't Close/Open


Insert the key and turn the lock cylinder while lifting up on the lift gate. You have to get the gate open. Once open, The strike plate (where the locking mechanism hits) is bolted to the jamb. Loosen the bolts and slightly move it toward the rear of the vehicle. NOT TOO MUCH!
Tighten the bolts, and try it. Hope this helps.

Jan 30, 2018 | 1996 Toyota 4Runner

1 Answer

Liftgate on 2005 uplander won't open


The locking mechanism on the rear lift gate for the Chevy Uplander has some plastic and rubber-coated parts that can get jammed. If you can pull back the panel from the inside top near the glass, you can reach down and try to spray some silicone lubricant into the lock. This could help get those parts unstuck so they spring back when you pull on the handle latch from the outside. Once you get the rear hatch open, I recommend taking out the locking mechanism and thoroughly lubricating it. Your rear lift gate will start to release very easily from then on.

Apr 08, 2012 | 2005 Chevrolet Uplander

1 Answer

I purchased a new support for the lift gate. It pops in easily but the lift gate won't close now. What am I doing wrong? I can't see any other way to put it in.


Did you remove the safety clip that stops it from collapsing during installation? Some of these need to be installed compressed and if they extend too far out they will lock up. I would remove the support, compress it at least halfway and then put it back in place with the hatch halfway closed if possible. Then lift the gate and see if that helps in the operation. This assumes you are talking about the spring tension Hydraulic lift bar on the hatch and that you can reach the connecting points with the hatch partially closed.

Jul 07, 2011 | 2011 Kia Sorento

1 Answer

The computer keeps telling us the lift gate is open, when it's not. It also has an abs light that comes on all the time. It tells me the air sensor needs to be replaced...even after it's been...


The lift gate has a door open senser ( switch) in both latches that hold it shut. You may have to remove the door panel and manually remove and replace the faultty switch but you might get lucky by spraying bothe the latches with Blaster or other pentrating oil and repeatly closing tand opening the door what'ing the door open indicator on the dash till the switch finally opens as it's cleaned otherwise you'llneed to manually clean the switch or replace it with a new one. They have one wire and 1.4 turn into the side of the door latch. Just unplugginthem does'ntr work either as the security system won't reset if the switch is disconnected.

May 09, 2011 | 1997 Jeep Grand Cherokee

1 Answer

Rear door on 2001 sienna won't open


The door handle might be broken, you need a new part. I got mine online for $40. keywords: 2001 2002 2003 2004 2005 2006 2007 Toyota Sequoia Metal Lift Gate Exterior Door Handle for Rear Outside Van Tailgate Handle. You need to remove the back door panel to replace this.

Mar 06, 2010 | 2001 Toyota Sienna

Not finding what you are looking for?
2005 Nissan Murano Logo

Related Topics:

166 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

80339 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...