Question about 1994 Oldsmobile Ninety Eight

Open Question

Harmonic balancer 1994 Oldsmobile (car wont start) please help

I have a 1994 Oldsmobile Regency Ninty-eight. I replaced the harmonic balancer with a used harmonic balancer from pick and pull. BEFORE I replaced the harmonic balancer the car ran fine (but was just noisy). AFTER I replaced the harmonic balancer the car will only turn over but will not fire and is not getting gas. I was told maybe the harmonic balancer was not the right one, so I put the old one back on. But, still nothing. The car just turns over but will not fire and is not getting gas. I checked all fuses & all good. NOTE--before I took the old harmonic balancer off the car ran fine just make noise from the harmonic balancer that was broke. Someone please please please help me. I cannot get my children to school now.

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

fixyadude1
  • 57 Answers

SOURCE: cutlass supreme wont start

It could possibly be the starter, but before you get that far make sure the Battery cables are connected very tight. If loose the car won't start or do anything. Also make sure the battery cable is grounded.

Posted on Sep 24, 2008

csmock132
  • 4669 Answers

SOURCE: 1992 olds cutlass ciera 3.3 l v6 wont start

Lets start from scratch. Have you check for spark? On all cylinders?

Posted on May 13, 2009

  • 1118 Answers

SOURCE: 89 oldsmobile 98 won't start

If you suspect its a fuel problem best to do a fuel pressure test, you can rent a tester at auto zone and do it yourself. They also can show you how to use it and what pressure it should be. Also if you turn the key to on position you should hear a hum from the gas tank and then a click that is the pump running and the click is the relay, if you don't then the pump isent running, also chk. the fuse and relay, it could be as simple as a blowen fuse or a bad relay.

Posted on May 26, 2009

ourhowse
  • 2007 Answers

SOURCE: 97 oldsmobile regency starter

Check fusable links in your battery cable and starter wires. Do you have power at the starter where the positive cable attaches? Your battery is good? Do you have any power anywhere else?

Posted on Jun 17, 2009

  • 66 Answers

SOURCE: replacement time harmonic balancer 1994 olds 98

not sure abot book time. actual time is about 45 minutes with proper tools

Posted on Jun 29, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Need to replace the harmonic balancer on a 1992 odlsmobile 98 regency


A harmonic balancer puller-cheap and easy to use-available at any auto parts store. The hardest part is getting the crankshaft pulley bolt loose. An impact tool is best, but not absolutely necessary. Old school way: not recommended, but I've done it this way: put a socket and long stout breaker bar on the crank bolt. Let the breaker bar end rest on the ground. Now use the starter to just bump the engine over one quick time-just one little bump is all it takes to loosen the crank bolt- if you positioned the breaker bar right. Good luck, Joe.

Sep 26, 2012 | 1992 Oldsmobile Ninety Eight Regency

1 Answer

I need to replace the crank shaft sensor


Yes. Jack the car up securely. you need to take passenger wheel off.remove caliper off . remove rotor. remove shock assembly and wheel bearing assembly slide.axleshaft out of the way.take serpinetine belt off. remove cover so you can see and access harmonic balancer.use impact to take bolt out of harmonic balancer.use wheel puller to take off harmonic balancer. Crank sensor should be right under harmonic balancer.

Jan 05, 2012 | 1994 Oldsmobile 88

1 Answer

How to pull the crank shaft pulley on 91 oldsmobile


You will need to remove the bolt(s) and then use a gear puller. The crankshaft pulley normally a harmonic balancer also and will be keyed with a drift pin. You should be able rent a puller from Auto Zone or other automotive store.

Jun 21, 2011 | 1991 Oldsmobile Ninety Eight Regency

2 Answers

I have a knock in the front of the moter in the pullys or harmonic balncer should you have free play in the balncer


No there should be no free play in the balancer. There is a rubber ring in the middle of two steel sections on that balancer that will rot out and cause a knockign issue and free play as you describe.

Jan 21, 2011 | 1994 Oldsmobile Ninety Eight Regency

1 Answer

How to replace 1991 olds regency 98 elite crankshaft sensor?


Remove the crankshaft pulley,the harmonic balance,with a puller made for this,then you can replace the sensor,and align it,if it is not aligned,it will break it.

Aug 22, 2010 | 1991 Oldsmobile Ninety Eight Regency

1 Answer

Locating the crank sensor in a 1994 olds delta 88v6 3.8 ltr w/automatic


if i'm not mistaking on the year look on drivers side, right above harmonic balancer close next to engine... it will be a little round sensor... hope this is correct on the year....

Mar 23, 2010 | 1994 Oldsmobile Eighty Eight

1 Answer

Replacement time harmonic balancer 1994 olds 98


not sure abot book time. actual time is about 45 minutes with proper tools

Jun 29, 2009 | 1994 Oldsmobile Ninety Eight Regency

1 Answer

How do i remove the harmonic balance in my 1988 oldsmobile 98 regency?


Your going to need to use a harmonic balancer puller to take it off, if you don't have one you can lone one out from Auto Zone and they can give you the step by step instructions to getting the job done, keep me posted, be glad to help.

Jun 28, 2009 | 1989 Oldsmobile Ninety Eight

1 Answer

I removed the harmonic balancer bolt, but cant get pulley off.


yes you can get a puller at any local parts store or harbor freight to pull it off

Mar 24, 2009 | 1991 Oldsmobile Ninety Eight Regency

Not finding what you are looking for?
1994 Oldsmobile Ninety Eight Logo

Related Topics:

44 people viewed this question

Ask a Question

Usually answered in minutes!

Top Oldsmobile Experts

yadayada
yadayada

Level 3 Expert

74896 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7688 Answers

Are you an Oldsmobile Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...