Question about 2006 Dodge Charger

Open Question

2006 Dodge Charger ECM/PCM - 2006 Dodge Charger

Posted by Anonymous on

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

emissionwiz
  • 75108 Answers

SOURCE: Troubleshooting code PO753 ECM or PCM.

It is more likely the solenoid, the PCM is very seldom the problem, about 3% of the time to be exact.

Posted on Oct 16, 2008

  • 61 Answers

SOURCE: SPARK PLUG INSTALLATION ON 2006 DODGE CHARGER 2.7L

In my experience with the 2.7L engine, the spark plugs are located on the top of the engine below the individual ignition coils. The coils are placed between the intake manifold and the valve covers, 3 per side. The coils are held in with "torx" screws. Simply remove the screws, and disconnect the connectors to remove the coils. The spark plugs will be underneath. Be sure to properly gap the spark plugs for maximum life and emissions compliance. Also, an improperly gapped plug can shorten the life of the coil packs.
Hope this helps!

Posted on Jul 25, 2009

SOURCE: How do u check the

You need a repair professional at your
local repair shop. That is not a driveway job
as you know ,since you had to ask

Posted on Apr 22, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 2013 dodge avenger wont start. Im getting a p0688 ECM/PCM code. What should I do


P0688 (generic) = ECM/PCM Power Relay Sense Circuit /Open
P0688 DODGE - Auto Shutdown Relay Control Circuit Low

Check all the ECM fuses, if the fuses are OK try replacing the ASD (Auto Shut Down) relay.

Read more: http://www.autocodes.com/p0688_dodge.html#ixzz405J7vpq8

Possible causes:

- Weak battery - Low voltage while cranking
- Faulty Engine Control Module (ECM) relay
- Blown ECM fuse
- Faulty ECM
- ECM harness is open or shorted
- ECM circuit poor electrical connection

Feb 13, 2016 | Dodge Cars & Trucks

3 Answers

If I replaced the PCM on the 2005 dodge ram truck would I have to reprogram the keys to make the truck run?


If you key has a chip in it, you will probably have to get your ECM reprogrammed with the proper VIN, since it no longer matches the original VIN on your Vehicle. I don't think the dealer would program your keys to a mismatched VIN number, so more than likely you will need your ECM reprogrammed with the proper VIN. This will need to be taken to the Dodge Dealership to be fixed.

Mar 14, 2011 | 2005 Dodge Ram 1500

1 Answer

Hyundai diesel has a problem in the throttle i have cod P 201


P0201 - Injector Circuit Malfunction Cylinder 1

The Powertrain Control Module (PCM) or Electronic Control Module (ECM) checks the injectors circuit resistance and monitors the voltage drop during normal operation. The PCM/ECM will trigger the P0201 code when the resistance or voltage drop at the injector #1 is out of specifications.

Causes:
- Open or shorted wiring harness to the injector #1
- Bad injector #1
- Bad PCM or ECM

Solutions:
- If damaged, repair injector wire harness or connector
- Replace injector
- Replace PCM or ECM

Feb 04, 2011 | 2006 Hyundai Sonata

1 Answer

What do the code u0100 mean on dodge charger 2006


Hi,


The U0100 code means there is Loss in communication with the ECM/PCM,which might be as a result of one of the following reasons listed below.

1. You had flash downloads applied to your vehicle. Many erroneous DTC codes are generated during flashing and should be cleared after flashing 2. You disconnected/reconnected computers in the car with the power still applied 3. An interruption (break or short) in the CAN network caused communication errors.


a simple software update will help you resolve the issue.




Good luck,

Aug 28, 2010 | 2006 Dodge Charger

1 Answer

How many computers are in a 2006 Chevy Cobolt?


Typically there are 2 and ECM/PCM and a TCM. The ECM/PCM controls all engine and interior operations while the TCM -Transmission Control Module - Controls the transmission.

Jul 23, 2010 | 2006 Chevrolet Cobalt

1 Answer

TACHOMETER WORKS INTERMITTENT


Do you have engine code showing by chance? It's possible the crank sensor is bad or the connection to the ecm or pcm to the instrument cluster circuit board needs a look. If you need schematics check out www.promanuals.net they specialize in Dodge Ram service manuals.

Jun 24, 2009 | 2006 Dodge Ram

Not finding what you are looking for?
2006 Dodge Charger Logo

Related Topics:

24 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

75077 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7768 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...