Question about 1998 Dodge Dakota
You will need to remove fan shroud and transmission line along with upper and lower radiator hoses then unbolt the radiator the lift it up thru the top of engin compartment and do a reverse install.
Posted on Jan 24, 2013
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: 1998 Dodge Dakota Brake Fuse
If you have a trailer plug installed trace the wires to see if there is a bare spot or broken wire.If no plug then you need to check for bare wire or broken wire from tail lamp assemblys to where the wire plugs into main wireing harness.
Posted on Aug 27, 2008
You have a wheel hub assembly with bad needle bearings. Make sure by getting the vehicle up to operating speed and cruise a curvy road. A quieting down on a right hand turn will indicate a left wheel bearing assembly,(and vice versa) and you have to put some force into the turn in order to notice the changes in the sound. You'll find one turn will be quieter than the other. I had this problem with a similar vehicle and purchased the wheel hub assembly through Rock Auto (google them. You'll be glad you did). Thirty percent cheaper than the local parts house, and they shipped the part quite quickly. Make sure, by the way, to clean out the pocket where the assembly goes in. Simply pull the wheel off, drop the caliper, and you'll see three bolts holding the assembly. Take the nut off the end of the axle shaft and be prepared to beat the old assembly off with a heavy hammer. You will not have to drop either ball joint, although you should inspect them for wear at that time. Slip the replacement assembly onto the shaft and line up the splines before trying to mount the assembly. The whole job should take you maybe about an hour, and you may not break all that much of a sweat while you're at it. Good luck and be confident. You can do this!
Posted on May 12, 2009
with the use of a special socket that fits over the drain plug You can remove it from the bottom of the vehicle... obviously you will need to drain the radiator fluid first with the use of a drain pan to catch the fluid. Install is the reverse procedure
Posted on Nov 14, 2009
Tips for a great answer:
Oct 14, 2016 | 1998 Dodge Dakota
Nov 11, 2015 | Dodge Cars & Trucks
Oct 23, 2010 | Dodge Dakota Cars & Trucks
Jun 29, 2010 | 1997 Dodge Dakota
May 15, 2010 | 1998 Dodge Dakota
Aug 27, 2009 | 1998 Dodge Dakota
Jun 24, 2008 | 1998 Dodge Dakota
102 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: