Question about 1999 Ford Crown Victoria

1 Answer

How do you remove the radio

Replacing the radio

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Ford Master
  • 3,904 Answers

You will notice 4 small holes on the face of the radio. There is a special set of wrenches that you can get from an auto store that you push into these holes to release the tabs and pull out the stereo. These tools are not expensive at all but you could get creative and make your own out of something like small knitting needles. All for tabs have to be depressed at the same time to release it cleanly.

Posted on Jan 24, 2013

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Trying to replace a radio in an Nissan Almera n16 (2003), I Is it possible to replace this radio, or because the dash radio/Air-con is all the one?


Look at the bezel around the radio. It just pops off. If it goes up around the instrument panel, look for screws around there. Under the bezel, there will be screws to remove.

Sep 07, 2015 | Nissan Cars & Trucks

1 Answer

Factory stereo not working and needs replaced. how does dash come apart to do this


REMOVAL

  1. Disconnect and isolate the battery negative cable.
  2. Remove cup holder.
  3. Remove trim panel above cupholder by pulling straight out.
  4. Remove center instrument panel trim panel.
  5. Remove screws holding radio to instrument panel.
  6. Pull radio rearward to gain access to the back of radio (RADIO). CAUTION: Pulling the antenna cable straight out of the radio without pulling on the locking antenna connector could damage the cable or radio.
  7. Disconnect the antenna cable by pulling the locking antenna connector away from the radio (ANTENNA TO RADIO).
  8. Disconnect bolt holding ground strap to the radio (if equipped).
  9. Disconnect the wire connectors from the back of the radio.

Nov 19, 2013 | 2002 Dodge Grand Caravan

1 Answer

How to replace a radio in a 2005 impale


Yes the radio can be removed and replaced.But for that dash has to be removed, then the radio slides out easily by just removing few screws and few wiring connections.Take care you just dont pull the radio forcibly, otherwise wires from other sides gets pulled out.-------- Click this link below and follow the procedure to remove the radio:-- http://technoanswers.blogspot.com/2011/07/how-to-replace-radio-in-2005-chevy.html ---------- This should help.Thanks.Helpmech.

Jul 08, 2011 | Chevrolet Chevy Cars & Trucks

2 Answers

How to replace 2002 radio light pont bonnieville and part number


Hello
I have repaired these burnt out display bulbs (3 of them) in GM Delco radio's, it is not a simple repair by any means, the radio must be removed from the car and then the radio chassis taken apart, the very tiny bulbs (size of a pencil point) are soldered to the front of the radio's main circuit board for the display, this job requires special pin point cordless low heat solder gun and a printed circuit board solder removal vacuum, The GM dealer does not service these bulbs, all they will do is remove the radio and send it out for repair to a GM radio repair center, if you do wish to attempt the replacement of the display bulbs they are a 12 volt 60ma, you will need 3 for the display, you can buy them from Radio Shack, the Radio Shack part # is #7219. You can also remove the Radio and send it in yourself for replacement of the display bulbs, this is what I recommend, if you damage the circuit board by applying to much heat the radio is so much junk.

Dec 12, 2010 | 2002 Pontiac Bonneville

1 Answer

How do I remove a dashboard in a 1993 F-150 XLT to replace the stereo?


You do not need to remove the dashboard in your truck to replace the stereo.All you need to do is remove the radio.This is done by going down to your local auto parts store and buying a set of ford radio removal tools.They look like u-bolts with a nipple at the end on both sides.There is two of them to remove the radio.You simply press them in on the radio, you will see four holes on the radio, that's where they press in.Then you push them in till they "click", then pull the u bolts towards the sides and pull the radio out.Disconnect your antenna and power leads and you can install your new radio.I hope I couldhelp

Dec 24, 2009 | 1993 Ford F150 SuperCab

1 Answer

Replaced factory radio one week ago with


sounds like its wired up wrong, remove the radio unplug the connector and remove the radio, then check all your fuses must have blown one when radio was installed, after that charge battery and with radio removed see if battery goes dead, if not recheck wiring to radio, common problem with vw aftermarket radio,they are installed wrong,good luck,

Nov 16, 2009 | 2003 Volkswagen New Beetle Convertible

1 Answer

My radio quit working, how do I go about replacing


remove cup holder remove two philips screws and pull face plate off remove two 10 mm (wrenchsize) screws from radio pull radio out and unpluge wires (face pulls off it has clips )

Oct 24, 2009 | 2001 Dodge Caravan

1 Answer

I have a 1996 Cadillac Seville SLS and I want to remove the radio and a website said I would just have to pull the trim around the radio and heater out and it would expose screws that would allow me to...


  • Remove the heater and A/C control and radio bracket fasteners.
  • Partially remove the radio and A/C control assembly.
  • Disconnect the electrical connectors from the radio and A/C control assembly.
  • Remove the radio and A/C control assembly.

  • 288103.gif
    tif.gif
  • Remove the radio retaining nuts.
  • Remove the radio from the radio bracket.
  • Installation Procedure Install the radio to the radio bracket.

    288103.gif

      tif.gif
      Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
    Install the radio retaining nuts.
      Tighten
      Tighten the radio retaining nuts to 10 N·m (88 lb in).

      287815.gif
      tif.gif
    Partially install the radio and A/C control assembly.
    Connect the electrical connectors to the radio and A/C control assembly.
    Install the radio and A/C control assembly.
    Install the heater and A/C control and radio bracket fasteners.
    Install the console trim plate. Refer to Console Trim Plate Replacement in Instrument Panel, Gauges and Console.
    Install the instrument panel center trim plate. Refer to Instrument Panel Center Trim Panel Replacement in Instrument Panel, Gauges and Console.

    Jun 29, 2009 | 2001 Cadillac DeVille

    1 Answer

    A/C Head unit replacement on a 99 Beetle GL


    Hi, there are 2 special keys inserted to radio and radio come out.I think you do not need to remove radio to replace a/c unit in beetle.

    Mar 07, 2009 | 1999 Volkswagen Beetle

    1 Answer

    Radio and dash lights


    Remove radio from vehicle. remove T15 torx screws on top and sides of radio. Remove knobs and outer bezels around knobs. Face has retainer clips top and bottom. Unsnap the face of radio and remove old bulbs there are five or six in a gm radio.

    Jan 12, 2009 | 2001 Chevrolet Blazer

    Not finding what you are looking for?
    1999 Ford Crown Victoria Logo

    Related Topics:

    29 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Ford Experts

    yadayada
    yadayada

    Level 3 Expert

    76630 Answers

    Colin Stickland
    Colin Stickland

    Level 3 Expert

    22219 Answers

    fordexpert

    Level 3 Expert

    5530 Answers

    Are you a Ford Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    Loading...