Question about Cars & Trucks

1 Answer

My car kit lectgronics have blown and now car stereo stuck on tel

Attached to ford au car stereo, have cut of old electronic board but car stereo is now stuck on telephone anyone can help is appreciated

Posted by on

  • blochage
    blochage Jan 24, 2013

    thnak you but that's not the problem , the telephone hands free electronics have blown not the stereo

×

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Cars & Trucks Master
  • 937 Answers

If the stereo you buy is not a model that fits correctly in the radio mount , then you will need to buy a stereo kit to modify the housing to fit correctly.
---------------------------------------------------------------------------------

New FGTech Galletto 2
FGTech Galletto 2-Master V5.0

Posted on Jan 24, 2013

Testimonial: "that still doenst answer my question::the stereo fits IM LOOKING TO BUY A NEW REMOTE CONTROL FOR IT AS IT DiDNT COME WITH ONE "

Ad

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 350 Answers

SOURCE: car stereo

hi you will proberbly find you have shorted the interior dash lghts out i would go to your fuses best bet is to look in your car manuall that came with the car as there is a few fuse boxes they vary on different models and are found in different places i think you will find a fuse gone try another fuse if it blows straight away your going to have to take your radio back out dissconnect the wires make sure none are touching ground or each other put another fuse in it shouldn,t blow if not wire the radio up to the correct terminals if the fuse still blows but didn,t blow before you started to fit the radio then some where there is a trapped wire or you have when putting screws back in to the dash trapped one it wouldn,t be the first time iv done it yates21210456

Posted on Sep 26, 2008

  • 259 Answers

SOURCE: Stereo won't turn on - Ford Falcon AU Ute (2000)

the easiest way is to check all the fuses is it only the stereo that won't turn if so it could be something else fuses usually control 3-4 things from my experience hope this helps regards Jim

Posted on Apr 05, 2009

  • 5 Answers

SOURCE: my dash board light out... honda accord 98

Well, You shouldn't have cut the old wires. This means you now have to Buy a new factory harness. both, the male and female ends.

Posted on Jun 18, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a Ford F150 2001. The spark plug blown out of number eight cylinder. I need to rethread it I have a size 16 1.5 mm tap what size insert to use


Demise, Buy the whole Ford spark plug rethread kit, no guessing involved. You can google search for the kit, to get a good price.
Check the attached links,instruction and guides, Good luck
"I hope this helped you out, if so let me know by pressing the helpful button. Check out some of my other posts if you need more tips and info."
Ford Spark Plug Blowout
How to Repair Stripped Spark Plug Threads Auto Clinic
Replacing blown out spark plug
Spark Plug Thread Repair REPAIRING FORD TRITON SPARK PLUGS M14x1 25 blown out problem
Amazon com Lisle 65000 M14 1 25 Spark Plug Hole Repair Kit with Deep Hole...

Jun 26, 2016 | Ford Cars & Trucks

1 Answer

1986 Thunderbird troubleshooting


there are 2 fuses boxes in cab and 1 in engine bay
we test the fuses, we dont change them out willy nilly.
even better, is to measure the voltage at at the radio.
the power pin is 12vdc, keyon
if not the fuse is blown or the wire is cut.
end story.
my guess is car wiring was hacked long ago with stereo upgrades
or other hacks, (alarms,etc)
old cars are like that, hacked.

May 10, 2014 | 1986 Ford Thunderbird

1 Answer

Color codes for stereo


They make kits just for this. Just plugs into the existing harness and then you run you wires to the wires from that harness, some may even have matching plugs that go directly to the Head units wire harness plug. I did My Mustang by cutting into the wire Harness and simply used a multimeter to check for battery, memory 12 volts and running light or dash board Illumination wires then you can test the wires coming out from the stock radio to see which are right, left , front, rear, antenna out, etc..

I just labeled them with magic marker on some masking tape with what they were before I cut off the harness permanently.

Jan 23, 2014 | 1999 Ford Contour

2 Answers

I need instructions on how to install an after market stereo in a 2006 Ford Fusion SEL.


Buy a metra dash kit and it will have step by step instructions,you will need harness too ,donot cut factory wires.!!!!!!!

Jun 03, 2010 | 2006 Ford Fusion

1 Answer

I have a 2004 Hyundai Elantra and am trying to install a stereo but dont know what the wiring diagram is..any help?


Personally owning this car and installing several Hyundai stereo's, I would purchase a wiring harness kit from car audio shop or electronics retailer. The wire harness has a plug that connects to the cars wiring harness. This wiring harness kit will also list the wires to connect your new aftermarket radio to the harness. I would also recommend using crimped **** connectors to attach the two harnesses together.

Feb 24, 2010 | 2004 Hyundai Elantra

1 Answer

My dash board light out... honda accord 98


Well, You shouldn't have cut the old wires. This means you now have to Buy a new factory harness. both, the male and female ends.

Jun 12, 2009 | 1993 Saturn SC2

1 Answer

Wiring cut when my stereo was stolen now nothing works.


Could have crossed wires and blown the fuses. try isolating and electrical taping the wires and then go through your fuses and replace the blown ones.

May 29, 2009 | 1996 Oldsmobile Cutlass Supreme Coupe

1 Answer

Left hand park light not working


hi first of all check ur fuses with a good test light see if any are blown and if u had cut any wires when u took out the old stereo that would have caused the problem..

thank u
rate me!!

May 24, 2009 | 1997 Ford Explorer AWD

1 Answer

No park lights or tail lights


first check ur fuses with a good test light see if any are blown did u cut any wires when u took out the old stereo

May 19, 2009 | 1995 Ford Windstar

1 Answer

Stereo won't turn on - Ford Falcon AU Ute (2000)


the easiest way is to check all the fuses is it only the stereo that won't turn if so it could be something else fuses usually control 3-4 things from my experience hope this helps regards Jim

Apr 05, 2009 | 2000 Ford Mustang

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

51 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76682 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...