Question about 2001 Daewoo Nubira

1 Answer

Specs for map sensor on 2001 daewoo nubira

Map sensor possibly bad what should it read on ohm meter i got a 31.1 reading??????????

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 9 Answers

Not sure . check with dealer . i thought you only check the reading on the throttle position sensor. i thought map sensors were just direct continuity.

Posted on Jan 24, 2013

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

stevenhurc
  • 450 Answers

SOURCE: need 2001 daewoo nubira map

stevenhurc_30.jpg
map sensor has 3 wires a 5volt supply on terminal C, A is earth(ground), and B is signal voltage to engine ECU.

Posted on Sep 10, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What should the ohms reading be on a front wheel speed sensor for a Chevy Silverado 2006 model


Why are you checking wss, was there a code, if so, what was the code number?
I don't have the exact ohms spec for that component, on your vehicle? The generic spec says 450--2200ohms. You can check reading on your other wss, see if readings are close to the same?
You can use digital multimeter on the sensor terminals, sensor unplugged, spin the rotor, take reading. Meter set on ac mv, 50--700mv. The reading may differ depending on how fast you spin it. You can do same at other tires.

Mar 10, 2017 | Chevrolet Silverado Cars & Trucks

1 Answer

06 Torrent changed the map sensor and erased the code.p0107 returned.Checked all vacuum hoses and cleaned the MAF sensor code came back checked the wiring to for ground Please help me solve this.


Check the continuity of the wires. Pull the tape off the wires and using the ohm meter lowest setting, probe the wires a couple inches back and check the reading to the corresponding pin. Being this close the readings should be .01 , maybe .02 ohms. If it reads OL, the wire is broken or has so much resistance it is out of range Either way, fix or place the plug.

Oct 09, 2016 | Cars & Trucks

1 Answer

I have a daewoo nubira 1.6 KLAN and it has just been diagnosed as having faUlt code PO107 manifold pressure sensor low


MAP sensor sending low voltage back to ecu.
possible causes....vacuum leak to sensor, broken wiring, faulty map sensor...can also be blocked with carbon...remove and clean first

DAEWOO NUBIRA 2 0 16V FROM 1997 AIR MANIFOLD PRESSURE MAP SENSOR ULTRA...

Feb 24, 2015 | Daewoo Cars & Trucks

1 Answer

Need 2001 daewoo nubira map sensor manufactures specs


stevenhurc_30.jpg
map sensor has 3 wires a 5volt supply on terminal C, A is earth(ground), and B is signal voltage to engine ECU.

Sep 08, 2011 | Daewoo Nubira Cars & Trucks

1 Answer

Need manufactures specs for nubira map sensor


A low voltage (high vacuum) output of 1 to 2V is present at idle. A high voltage (low vacuum)

output of 4.0 to 4.8V is present at wide open throttle. The MAP sensor is also used under certain conditions to measure barometric attitude changes. The ECM uses the MAP sensor for the delivery and ignition timing changes.


stevenhurc_28.jpg

Sep 08, 2011 | 2001 Daewoo Nubira

1 Answer

What are the torque specifications and tightening sequence for cam journal and cylinder head for 2001 daewoo nubira 2.0 :(


  1. The torque settings for the cylinder head bolts on a daewoo ...

    www.answers.com > ... > Categories > Cars & Vehicles > Asian Car i need how much pression (torque) for head daewoo nubira 2001 2.0 ... What is the cylinder head torque specs for a 2001 daewoo nubira 2.0 litre engine and ...

Apr 15, 2011 | 2001 Daewoo Nubira

1 Answer

Code pooo1 fuel volume regulator control curcuit open map sensor reading 99 this is on xtype diesel this reading is with just ingnition on when runnig reading goes up but never below 99 is map sensor...


Hello! The PERCUS...E...Code is an Electronic Control Module (ECM) programming error or failure...The grounding may be at fault...Using an ohm meter set on X10 scale...Read from center of negative battery post to bare metal on chassis and then to engine block...Should read very near zero ohms...If these readings are OK...The ECM needs to be re-flashed (reload software) at a dealership.

MAP reading across wire colors Black/White (+) and Black/Green (-) at idle should be 1.1 volts...(.99 is a correct reading)...Throttle up and voltage increases to 3.75 volts w/o erratic movement...This indicates MAP is OK...

Guru.............Saailer

Sep 19, 2010 | 2003 Jaguar X-Type

1 Answer

What are the specs on head bolts


2001 Daewoo Nubira 2.0L MFI DOHC 4cyl

The Head Bolt Torque ...

Torque sequence ------------------------- Front | 10 6 2 3 7 | of | 9 5 1 4 8 | Engine --------------------------

Step 1 - Torque to 18 ft/lbs Steps 2 - Turn 90 degrees Steps 3 - turn 90 degrees Steps 4 - turn 90 degrees Recheck final torque in sequence


Hope helps (remember rated and comment this).

May 27, 2010 | 2001 Daewoo Nubira

3 Answers

Need cam torque specs


1999 to 2002 - 2.0L DOHC

Camshaft bearing cap bolts intake and exhaust.

N.m (INCH LBS)
8 ( 71 )

Jan 23, 2010 | 2001 Daewoo Nubira

1 Answer

2001 Pontiac Sunfire has one injector dumping fuel. Have changed fuel pump, pressure regulator map sensor and run exterior ground and problem still exist.


check other injectors, use an ohm meter, use readings form good injector and compare, to find bad ones, also use a noid light to see if they are getting power start there,

Oct 14, 2009 | 2001 Pontiac Sunfire

Not finding what you are looking for?
2001 Daewoo Nubira Logo

Related Topics:

212 people viewed this question

Ask a Question

Usually answered in minutes!

Top Daewoo Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

yadayada
yadayada

Level 3 Expert

75822 Answers

Steve Hurc
Steve Hurc

Level 3 Expert

450 Answers

Are you a Daewoo Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...