Mini odo\ compas\ dte guage turns on but only reads ccd on the screen

ODO... wasn't he in Star Wars? Seriously though, ODO can mean Odometer. Where are you reading this at?

The DTE is automatic and is the result of your previous miles per gallon multiplied by the gallons of gas registered in your tank.

Unlike the Trip miles, this DTE number can not be reset. It will vary by the fuel mileage per gallon recorded at each startup. That is why if you filled the tank and showed 400DTE you may have had 20 Gallons multiplied by 20 MPG. But if your new average is 16 MPG then it would show 320 DTE.

It needs to be reset, here is how to do it:
turn the key on
set the odo/trip meter to read odopush and holsd the RESET switch
turn the key off while holding the switchturn the key back on
some lines will flash on the display
when the odometer reading comes back release the switch

if this doesn't work use the "trip A" setting instead of ODO
either one should work

you need and OBD2 diagnostic tool to reset

Here's how you reset your maintenance light.

To reset the light,
Turn the ignition on
Make sure the odometer displays "ODO"
1.Turn the key off
2.Press and hold down the same button you use to get to "ODO"
3.Turn the key back to ON ( while still holding down the button)
4.Hold the button in until all the flashing lines on the odometer go away and the bunch of "000000" shows up and the maint reset light will turn off.
Your'e done.

If this doesn't work, you would have to try it on "trip A" instead of "ODO".

You don' t have trip computer built in. All cars have Odo and Trip A and B. But not all of them have computer build il to show temperatute, to calculate your mpg and DTE and ect.

Problem is in the guage cluster assy.The ODO is mechanical,serviced by replacing guage cluster.

Check to make sure that you aren't changing between km/mph readings. I had the same problem when it was 90 degrees out side and the temp was registering in the thirties. It's the button on the left, should say something about KM/IMP or something...

When you start the van, Does you gas, battery and tach gagues work? If you have an instrument display above for trip comuter (DTE, MPG) does it read anything?

You have to reset the information or it just continues to do average calculations, but you can reset it but holding down the same knob you use to read the information. When you restart your pathfinder the dte recalculates according to what was previously used, mine does it too!!