Question about Pontiac G6

Open Question

2007 Pontiac G6 GT remote starter only beeps 3 times and will not start. All other buttons work fine. Is this programming, a bad relay or something else?

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: 2007 jeep wrangler sahara with a mopar remote starter just beeps

That's not a remote starter on your key chain, it's a keyless entry for an alarm system.

Posted on Dec 17, 2008

Ad
emissionwiz
  • 76164 Answers

SOURCE: transmission fluid for 2007 pontiac G6 GT

This car does not have a auto trans dipstick, the level can only be checked by the dealer, this is a growing trend that started with most German cars, the filter is inside the trans pan and only needs changing every 60,000 miles.

Posted on Jan 06, 2009

  • 10 Answers

SOURCE: Key Fob Programming

key fobs have to be the same gm id number on back of fob and need to be programmed for your car by the dealer. its expensive . i had to have it done on my car. other fob i had could not be programmed to work, wrong gm id number

Posted on Apr 23, 2009

  • 400 Answers

SOURCE: 2006 pontiac g6 needs a hood latch to make the

No it does NOT need to programed.
BUT the code will need to be cleared from the moduals for the remote start to work.

Posted on Oct 18, 2009

  • 3 Answers

SOURCE: have a pontiac montana, but lately when I press ths remote start button, the alarm goes off. Door locks work fine.

Dec 2009.
I also have a 2006 sv6 witht he exact same problem. The battery diesd in the remote and after changing it only sets off the alarm now instead of starting? Di dyou figure out the problem?

Posted on Dec 17, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Instructions on how to program GM remote key OEM 22733524


Switch ignition ON.

Repeatedly press vehicle information button (it is usually located on the right or left from the steering column depending on year make and model until PRESS TO RELEARN REMOTE KEY is displayed.

Press set/reset button until REMOTE KEY LEARNING ACTIVE is displayed.

Programming mode activated, proceed as follows:

Press and hold LOCK and UNLOCK remote buttons on first remote transmitter simultaneously for 15 seconds.

Wait for acoustic signal (indicates correct programming).

Repeat above procedure to program remaining remote transmitters.

Switch ignition OFF to exit programming mode.

May 17, 2015 | 2007 Pontiac G6 GT Convertible

1 Answer

Remote starter not working but unlock does Pontiac G6 2007


might be gas cap, had same problem. when the gas cap was not on tight the car would not remote start

Feb 05, 2011 | 2005 Pontiac G6

3 Answers

How do you remove the headlight assembly on a 05 Pontiac G6 GT to replace headlight bulb? When unlocking car, the bulb works, but when starting or putting car in drive light goes off. Is the bulb the...


real interesting... there should be no relation to the "drive" and the head light. current drawn by the starter causes the lights to go out or dim. Check the headlamp relay and for corrosion on connector to lamp assemblies in the engine compartment. On back of assemblies there is a large diameter plastic retainer after you remove the wire clip. Turn counter clockwise and pull back. a wire clip should retain the bulb itself

Oct 02, 2010 | 2005 Pontiac G6

1 Answer

I have a 2007 pontiac g6, 4 door. i changed the


Check the wiring on the headlight. You may have a damaged wire or bad ground.

Dec 30, 2009 | 2007 Pontiac G6 GT Convertible

2 Answers

G6 GT2007 Blower fan does not work at all. All


check relay HVAC relay.if all is good.blower motor is bad or HVAC control switch is bad.

Nov 22, 2009 | 2007 Pontiac G6 GT Convertible

2 Answers

I have a 2006 G6 and the remote starter recently stopped working. The remote will lock and unlock the doors but when I hit the lock and then starter button on the remote the lights will just flash and you...


you can only start the car starter three time before pcm disables the function must start agin with key to get working. also may have diabled car starter by dic comands on radio also if you have engine light on will not operate car starter due to light.

Jan 02, 2009 | 2005 Pontiac G6

4 Answers

Remote starter does not work but will unlock and lock doors.


I have a 2003 sierra and my remote starter would not work, it would lock and unlock only, checked out this site found the solution, tried it and in two seconds i solved the problem, Just press the lock button and the start button and viola it works again, thanks for all your help , GGGreat site glad i found it John

Dec 08, 2008 | 2005 Pontiac G6

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

100 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

yadayada
yadayada

Level 3 Expert

76132 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...