Question about Peugeot 405
Air bag light stays on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: air bag warning light
It is malfunction indicator
DIAGNOSIS WITH SCAN TOOL
CHECK PROCEDURES 1. Connect the Hi-Scan Pro to the vehicle data link connector located underneath the dash panel. 2. Turn the ignition key to the "ON" position and turn on the Hi-Scan Pro . 3. Check for diagnostic trouble codes. 4. If a fault code is found, then replace the appropriate component. Never attempt to repair the component. 5. If the Hi-Scan Pro finds that a component of the system is faulty, there is a possibility that the fault is not in the components but in the SRS wiring or connector.
The SRS airbag system has sophisticated electrical and electronic components. Therefore the airbag operating components should be handled very carefully. SRSCM (Supplement Restraint System Control Module) SRSCM determines when to deploy the airbag module by sensing the frontal and side impact force through the built in sensor SRSCM.
Posted on Jun 03, 2008
SOURCE: Air bag warning light stays on
You have to use VagCom (the diagnostic software that Audi uses) to turn off an airbag warning light. If you have a laptop that can go out to your driveway, go to www.ross-tech.com and download VagCom (it's free). Go on eBay and do a search for "Audi TT vagcom cable" and you'll find the interface cable for about $20. Buy that, and then you'll have the software to do it.
If you're not able or interested in it, you can go to the dealership and have them turn off the light - they'll charge you an hour's labor to do it (it takes less than four minutes, but they don't care - you're going to pay them between $60-100 to do it).
What you need to see is which bag is tripping the warning. On the A4s, it's usually the driver's side airbag (built into the seat). Moving the seat too far back or down tends to pull on the electrical connector for the airbag, separating it just enough to trip a warning light. When mine did this in my A4, I zip-tied the connector tightly to keep it from separating, then turned off the light, and have had no problems since. When you look under the seat for the connector, it's the yellow one (airbag wiring connectors are always yellow, as mandated by law). Just be careful not to pinch the wires when you tie it.
Posted on Aug 31, 2008
the air bag light will only show if the ignition was turned on while it was disconnected.
it will defo need to be pluged into the computer to be put out but some smaller garages will have the software to do this and will be a little cheaper.here in ireland VW wanted 50euro to do mine but a small garage done it for 30euro.
you can buy code finders/reset gadgets on ebay but might not be worth it for one job compared to $130.
my suggestion would be to get the main dealer to do it if a normal automotive shop cannot access it.
Posted on Mar 01, 2009
Common fault on FORD
Usually due to a poor connection in the YELLOW PLASTIC CONNECTOR underneath the passenger seat.
Just push it together properly and it should clear the AirBag fault
Posted on Sep 06, 2009
have you plugged the air bag wires back in under the seat?
if you have put after market of non genuine seats in you will not be able to turn light off
you could remove the bulb from the dash or just leave it (it will not affect the mot)
Posted on Dec 09, 2009
Tips for a great answer:
Sep 18, 2011 | Hyundai XG300 Cars & Trucks
Jun 17, 2011 | 1999 Volkswagen Passat
Jan 22, 2010 | Toyota Passenger Cars & Trucks
Nov 10, 2009 | Cars & Trucks
Nov 03, 2009 | 2004 GMC Yukon
Oct 14, 2009 | 1999 BMW 328 Series
Jun 09, 2009 | 1997 BMW Z3 Roadster
May 20, 2009 | 2004 Volkswagen Eurovan
Jul 03, 2008 | 2006 Chevrolet Uplander
60 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: