SOURCE: 2005 buick leSabre whine or humming noise from front end.
I had the same problem with my 2000 Buick LeSabre last year. Took it in and they determined the wheel bearing needed to be replaced. Costs about $300 per bearing, but definitely needs to be replaced as you'd be in serious trouble if the thing went out at highway speeds.
SOURCE: location of spark plugs in 2005 dodge dakota
To change the sparks on a 2005 4.7L Dodge Dakota you will need the following:
Note you will have to remove the air intake located at the top of the engine, and will have to move some of the coolant lines out of the way.
At the top of the engine there are 4 sparks on each side. The coils are held in place with a 10mm bolt. Undo the 10mm bolt and unclip the coil. Next pull out the coil.
Insert the socket, with extension into the spark plug hole.
Remove spark plug.
Check the gap on new spark plug, it should match stock.
tighten to approximately 25ft.lbs. (check spark-plug packaging for exact torque requirements).
repeat this process with all other sparks.
be sure that no dirt gets into the spark plug holes.
SOURCE: 2004 dodge ram rear end noise
while you had the cover off did you by chance look at the condition of the ring gear and spider gears...if it was run for any length of time low on fluid or with two different sized tires you may need some repairs but first inspect the ring gear and rotate till you can see the 4 little beveled gears inside the differential ....use a screwdriver and check for excess movement...look at the crossshaft and look for wear.....hope this points you in the right direction.
SOURCE: 2006 Dodge Gr. Caravan. Loud humming noise upon
Misalignment of the belt, incorrect belt, worn or loose tensioner, Too tight of an adjustment (many service centers do this on purpose so when the belt breaks in it becomes properly adjusted, I do not believe in this philosophy), The belt is actually one long belt called a serpentine belt.....
SOURCE: LOUD CLUNKING NOISE IN REAR WHEEL AREA WHEN TURNING LEFT
sounds like either a sway bar end link or shock, more towards the end link tho
152 views
Usually answered in minutes!
×