Question about 1998 Isuzu Trooper

Open Question

Engine number location of 4jx1 engine - 1998 Isuzu Trooper

Posted by Anonymous on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

What is crank position sensor on Isuzu trooper 2002 3tdi


What is? It tells the ECU what position the crank is in to control timing.

Feb 13, 2015 | 2002 Isuzu Trooper

2 Answers

Hello, can l use the 4jx1 gearbox if l was to replace it with 4jg2 engine .or l should change both with the gear box, advise.


Kindly did you managed to change 4jx1 with 4jg2? Did you changed the gearbox? What modification is needed for this change?
thanks.

Nov 23, 2012 | Isuzu Trooper Cars & Trucks

2 Answers

Where is the oil filter and the bolt on a 1995 Isuzu trooper


Hi Cortina,
The oil filter is located on the opposite side of the engine to the intake manifold and is situated facing downwards. If you're talking about the sump drain plug, it will be situated at the lowest part of the sump. If you have the 4JX1 engine there are two oil filters, one of them is for the engine lubrication system and the other is for the oil rail lubrication and activation system. The latter is the larger of the two and is located between pistons two and three about half way down the side of the block on the same side as the intake manifold. If you have the 4JX1 engine the type of oil you use is critical in maintaining trouble free motoring, check and use only the oil type stipulated.
Regards Johngee10

Mar 03, 2011 | Isuzu Trooper Cars & Trucks

2 Answers

Our engine is running rough we have a 1999 Isuzu wizard 4jx1 - we think we have an injector problem - how can I check this fault - I need to establish if it needs a replacement injector or is it an...


Buy a can of throttle body cleaner take off the air filter box, follow the tube and then spray the throttle body and wipe it out first before condemning the injectors

Dec 01, 2010 | 1999 Isuzu Trooper

2 Answers

Isuzu tropper 4jx1


You have no injection pump ,each injector does that job .
You have a faulty rail oil pressure sensor I think ,read my tips to test this sensor .

Feb 06, 2010 | 1998 Isuzu Trooper

2 Answers

I cant find the location of diagnostic socket of Isuzu 4jx1


The ODB socket is just under the plastic trim that goes over the gearlever cover by your right foot , no tools needed to get it out .
The 4JX1 is a HUEI type engine so the diesel is not under high pressure until injected .
To prove if the fuel is starved put fuel in a can and pipe it into the hand primer pump direct .
Most likely cause is the Rail Oil Presure Sensor as this controls the amount of fuel injected via the ECU .

Jun 18, 2009 | 1999 Isuzu Trooper

1 Answer

Y 4jx1 engine check engine light on and blink after i change the motoroil and the engine some times not smooth but engine temp normal guru what is the problem


disconnect the + treminal of the battery for about 2 min. if it doesnt cure the problem go to a place with a scanner to get the trouble codes.

May 28, 2009 | 2001 Isuzu Trooper

4 Answers

Isuzu 4JX1 EngineWont Start after replacing new injector


my isuzu bighorn will not start after changing valve seals and head gasket and after setting timing it still will not start. do you have a solution.

Aug 09, 2008 | 1999 Isuzu Trooper

Not finding what you are looking for?
1998 Isuzu Trooper Logo

Related Topics:

44 people viewed this question

Ask a Question

Usually answered in minutes!

Top Isuzu Experts

yadayada
yadayada

Level 3 Expert

75077 Answers

Steve Hurc
Steve Hurc

Level 3 Expert

450 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you an Isuzu Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...