Question about Dodge Durango

1 Answer

Starter diagram i need to know how i can get to the starter to jump start it.

Posted by on


1 Answer

  • Level 1:

    An expert who has achieved level 1.


    An expert that hasĀ over 10 points.


    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 7 Answers

U can try pounding on the starter while someone cranks the car. But kinda hard to find an actual diagram

Posted on Jan 23, 2013


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

2004 cadillac cts wont start only with relay jump start

What relay ? Starter relay ? Check engine light on ? Do you know how to test power and control circuit at the relay base ? where the relay plugs into ? The PCM - engine computer is suppose to energize that relay , IF it see's a input from the transmission range sensor switch (park or neutral ) or if there are no anti-theft system problems . Pull the relay and look at the bottom (where pins are ) you will see four sets of numbers . 30 & 87 and 85 & 86 .30 should have B+ voltage 87 goes down to the starter solenoid . If you used a piece of wire an jumped those two the starter should crank .(if it's good ) Pin's 86 & 85 - one should have B+ voltage and the other the ECM supply's a ground . free wiring diagrams . Enter vehicle info. year , make , model and engine size . Under system click on engine then under subsystem click starting . View the starter electrical system diagram .
VEHICLE RELAYS Testing from the relay base
Starter relay works the same

Aug 25, 2017 | Cadillac Cars & Trucks

2 Answers

I need a wire diagram of a starter for a 1989 Isuzu pickup 2.3 engine from under the truck.

If it worked a few times, the wiring is probably correct. Your symptom indicates a low battery or bad connection. Clean and tighten battery terminals as well as where the cables connect to the engine and starter. Try jump starting. If it jump starts, check the voltage at the battety with the truck running. Voltage should be at least 14vdc. If not, remove the alternator and have it tested at your local parts store.


Aug 23, 2017 | Isuzu Cars & Trucks

1 Answer

1998 Sable will start and drive then after shutting it of won't start not even try to turn over for hours maybe a day then will start right up

When it won't start testing the electrical systems is the proper way to find a fix . Using a DVOM - digital volt ohm meter and power flow diagrams . Using voltage drop testing !
How to voltage drop test starter motor circuit
How to test starter engine doesn crank GM 3800 engine
Electric Testing Techniques You Need to Know
Do you know what a wiring diagram is ? Free wiring diagrams here Enter vehicle info. year , make , model an engine size . Click on engine under system then under subsystem click on starting .Then click on the search button , then on the blue link . This is a wiring diagram of the starter electrical circuit. Do you know what ignition switch is ? the electrical part. , how about the starter relay , transmission range sensor ! There is one thing you can try , move gear selector to neutral an see if it starts then . If that does nothing ,check for B+ voltage going at the starter relay . Jumping pins 30 & 87 at the relay socket , where the relay plugs into . will cause the starter to engage an spin the engine . If you look on the bottom of the relay you will see four sets of numbers 30 & 87 - 30 should have B+ voltage , 87 goes to the S terminal on the starter solenoid . An 85 & 86 are the control side .86 at the relay socket comes from ignition switch through the trans range sensor to the starter relay coil ( electro magnet ) . Watch these videos too .
VEHICLE RELAYS Testing from the relay base

VEHICLE RELAYS Operation Diagnosis

Apr 29, 2017 | 1998 Mercury Sable

1 Answer

While driving the a/c quit getting cold and the gearshift orange indicator light disappeared. The truck ran to its destination and I shut it off. I tried to start it again but it would not turn over. I...

Starter motor relay , transmission range switch , wiring ! Do you know what a wiring diagram is ? How to read one ? How to use a DVOM - digital volt ohm meter ?
How to voltage drop test starter motor circuit
do you know what a relay is ? how to test one .
VEHICLE RELAYS Operation Diagnosis
You can view free wiring diagrams here enter the vehicle info. year , make , model , engine size . Under system click on engine , then under sub system click on charging system . click search button ,one link will pop up , click on it . First diagram is starter circuir . If starts jumping at the starter the problem is on the control side . trans range switch , starter relay ,blown # 6 40 amp fuse in the under hood fuse / relay center .

Mar 26, 2017 | 1998 Chevrolet C/K 3500

3 Answers

My 92 lincoln town car will not start i have replaced the starter, the neutral safety switch and the battery but when i turn key nothing happens but can jump starter and will crank

Yes there is a starter relay in the wiring diagram.
The yellow and lite blue wire goes from the starter solenoid to the relay. There is a yellow wire from the relay to a 30amp fuse. The key switch powers thru the neutral safety switch and then powers the relay on.

Jan 29, 2013 | Lincoln Town Car Cars & Trucks

1 Answer

I have a 79 chevy half ton 4x4 c10 with a sb 350. i just replaced the altinator and battery. it just wont start. when it does start it runs iddle at about 35 miles per hour, in order to start the vehicle i...

Did you check the starter and starter relay. If the starter is failing it will require more voltage than usual to turn over and start the truck. Heat soaking can also be a problem. Check the wiring to the starter and any wiring you reconnected when you replaced the alternator.

Sep 13, 2017 | 1978 Chevrolet C1500

2 Answers

How do i know if the starter is bad ? I just charged the battery but when i turn the key nothing happens, i haven't had this problem before,

Jump it to the battery,to see if it works. If it does,then you need a wiring diagram, to look over the starting circuit issues.
You could pull the starter and have the auto part store test it

Apr 28, 2010 | 1993 GMC Safari

1 Answer

Where is the starter solonoid located 04 aveo

You will need to verify if the starter solenoid is getting power when you are attempting to crank it. I dont have a diagram, but the clutch switch may be the problem if you must depress the clutch to start the engine.

Jan 16, 2010 | 2004 Chevrolet Aveo

1 Answer

2003 Chevy 2500HD 6.0 auto. Truck won't start. Before, while driving the door locks were locking and unlocking like when you shift into drive or into park. Shut off truck. 1 hr later it won't start. Jump...

No , it's not a trans module . Do you know how the starting system works ? Do you know what a wiring diagram is ? Do you have an know how to use a volt meter ? Going here free wiring diagrams . You need to look an see what all is involved in the starting electrical circuit before guessing as to what the problem is .
Enter your vehicle info - year , make , model and engine size. Then under system click on engine , then under subsystem click starting .Click the search button then the blue link. Looking at the wiring diagram i see IGN E fuse 10amp , the park neutral postion switch , starter relay , IGN A fuse 40 amp . I do not see a trans module , but i do see the PCM -powertrain control module . The PCM has both trans an engine control modules in one box.
The PCM will energize the starter relay if there is no anti-theft system . Do you have a security light lit on the insturment cluster ?
No crank good starter how to troubleshoot any car Hyundai

Sep 24, 2017 | 2003 Chevrolet Silverado 2500HD

1 Answer


if by bypass you mean the ignition switch. jump it at the relay, find the starter relay the relay should have a diagram on the side and numbered posts on the bottom with a jumper wire you can jump the post in the power distribution. look at the diagram there should be a switch which shows normally open you need to jump the posts that would close this switch and this will jump you starter make sure you key is on to start the vehicle. hope this helps some

Feb 13, 2009 | 1998 Saturn SL

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

34 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts


Level 3 Expert

76691 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8531 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides