Question about Buick Rendezvous

Open Question

Does 2002 Buick Rendezvous V6 AWD have a timing belt or chain?

V6 AWD

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

c17hydro
  • 2984 Answers

SOURCE: How to change the fuel filter in fuel tank 2006

3.4L & 3.5L Engines

  1. Before servicing the vehicle, refer to the Precautions Section.
  2. Relieve fuel system pressure.
  3. Remove or disconnect the following:
    • Negative battery cable
    • Quick connect fittings at the inlet/outlet sides of the in-pipe fuel filter
    • Fuel filter mounting bracket nut
    • Fuel filter and drain any remaining fuel

61788c9.gif
The fuel filter is located on the frame rail near the tank—with 3.4L and 3.5L Engines

To install:
  1. Install or connect the following:
    • Fuel filter to the bracket
    • Fuel filter assembly to the side rail near the fuel tank. Torque the nut to 89 inch lbs. (10 Nm).
    • Inlet/outlet quick connectors to the fuel filter
    • Negative battery cable
  2. Start the vehicle and checks for leaks, repair if necessary.

Posted on Oct 11, 2009

Testimonial: "Thank you for your reply, but my car is not the fuel filter in the fuel line underneath the body."

  • 54 Answers

SOURCE: O2 sensors on 2002 buick rendezvous

hi im wes the o2 sensor is always in the exaust newer buicks have one before the converter (sometimes in the exaust manifold) one after the converter if it has duall exaust it could have four
left bank sensor one is before the converter on drivers side bank two sensor 2 would be passanger side after the converter does this help?

Posted on Mar 12, 2009

Mr BrokRench
  • 1623 Answers

SOURCE: timing belt or chain

Ummmm woahhh hold up here...every 2.7 litre V6 i've been associated with had timing CHAINS. The chains ran the water pump and dual over head camshafts.
The 2.7l engine was manufactured by Mitsubishi for Chrysler and had an internal water pump with defective seals that allowed coolant to leak & mix with the oil causing severe sludging problems and eventual engine FAILURE...This has been a nightmare for Chrysler AND OWNERS !
MANY owners have contacted ISG Impartial Services Group 1-(866)332-3746 for a settlement with Chrysler
Attached is a cutaway view of the 2.7 litre, and as you can clearly see it is chain driven.
I've been a MOPAR enthusiast all my life...sadly, this engine was one of the worst to ever hit the streets.
Good luck Doug...i hope this helps.

2519ac2.jpg

Posted on May 26, 2009

  • 2841 Answers

SOURCE: Timing belt on Accord 2004 v6 models

2003 and up Honda Accord with 4 cylinder engines do indeed have a chain and the V6 has a belt which must be replaced at 110,000 miles. Why? Ask Honda, they designed the engines.

Posted on Aug 02, 2009

Testimonial: "Thanks for your clarification. Most helpful"

greg_margo
  • 1959 Answers

SOURCE: belt install diagram 3.4 liter

Below is the diagram you requested. Kindly return to rate this solution and thank you for using Fixya!
Greg
e4ea7d0.jpg

Posted on Sep 24, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How many kms can the Tucson AWD 2006 2.7L V6 travel on a full tank?


pending type of driving you do . Highway ,city etc it should average around 360 to 380km

Aug 29, 2014 | 2006 Hyundai Tucson

1 Answer

My 97 Ford Explorer will go in reverse but will not engage in drive or any other gears


1997 was the second generation Explorer

5.0 -4.9lt V8 or German 4.0 V6

No AWD until 2002

The V8 had a 4R70W
The V6 had a 5R55E

4 & 5 speeds --No 3 Spd

Think your Transmission is due fro a rebuild

Mar 26, 2013 | 1997 Ford Explorer AWD

1 Answer

Labor cost on o2 sensor mercury Milan 2007 v6 premier


You shouldn't pay more than $40 for the installation of an o2 sensor. It is only a 15 minute job at max. Good Luck!

May 11, 2011 | 2007 Mercury Milan V6 AWD Sedan

2 Answers

How to go from V8 to V6?


To do that, you would have to change the engine and the transmission on the car.

Feb 18, 2011 | 2007 Chrysler 300c AWD Sedan New Cars

1 Answer

2005 ford escape xlt awd v6, vehicle "jerks" as it accelerates from 0 to about 40mph. First few "jerks" are hard then then get a little smoother, until 40 mph is reached. When slowing...


Ford Escape - ConsumerAffairs.com

www.consumeraffairs.com > Automotive > Auto Manufacturers
Rating: 1.3 - ‎59 votes I have had my 2005 Escape 8 years. .... Ford Escape Limited 2010 - V6 AWD ....Brought my vehicle for 15T kms servicing and reported a jerking when I am ..

Jan 18, 2011 | 2005 Ford Escape

1 Answer

2004 Saturn VUE V6 AWD (Honda Engine)


How do i check the transmission fluid in 04 awd v6 auto

Jul 20, 2009 | 2004 Saturn VUE

1 Answer

Custom buggy wrapped on Astro AWD


All depends on the 4.3 your going to install. The transmission are the same, that both use the 4L60E. E being that the transmission is controlled by a ECM with the engine. If your running a Aspirated 4.3 and not fuel injected, your going to have to run a 4L60 transmission. 
As for the AWD the new AWD system on the Astro works off the ABS system as it runs on 2WD till the PCM detects the lost of traction then the transfer case is activated by the ECM.
The earlier Astro and Safari AWD 1991 to 1994 had a true AWD and stayed active, but was not that great off road since it had a 40/60 split ratio front to back transfer.
Good luck and hope this helps.

May 25, 2009 | 1997 Chevrolet Astro

1 Answer

Need a 03 3.0 v6 awd throttle body, linkage, sensor


Buy it new from many places Search Saturn Parts call local Dealer .
Happy Easter

Mar 30, 2009 | 2003 Saturn VUE

1 Answer

Fireing ordre to coils


For the 1997 Ford Explorer AWD
I do not know if you have the 4.0L V6 or the 5.0L V8; however I have included both below:

For the 4.0L V6:
Firing Order:
1-4-2-5-3-6
Cylinders:
....(back)....
'..3..'..'..6..'
'..2..'..'..5..'
'..1..'..'..4..'
...(front)
Coil Connections:
....(back)....
'..1...2...3..'
'..5...6...4..'
....(front)

For the 5.0L V8:
Firing Order:
1-3-7-2-6-5-4-8
Cylinders:
......(back)......
'..4..' .....'..8..'
'..3..'......'..7..'
'..2..'......'..6..'
'..1..'......'..5..'
......(front)
Coil Connections:

............(back)............
'..4...7..'.........'..3...5..'
'..8...2..'.........'..6...1..'
............(front)

Let me know if this helped....Thank you for using FixYa.com!

Mar 05, 2009 | 1997 Ford Explorer AWD

2 Answers

1998 bravada


Do you have a 4WD Bravada? Or an AWD? If it is AWD, there is no shifting. It is in 4WD Drive all the time.

Do you have something on the dash that allows you to change from 2WD to 4WD HI/Lo? Is so, then check your fuses in the fuse box. You may just have a blown fuse.

Sep 22, 2008 | 1998 Oldsmobile Bravada

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

341 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8180 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...