Question about BMW X3 Series

Open Question

Can not remove radiator cap on 2006 Bmw x3

The cap does not want to move either way when pushing down on the cap.

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 1348 Answers

SOURCE: radiator fan doen't come on at all with a/c on or off 06bmw x3

get the wiring diagram and check the fan switch and the fan relay

Posted on May 15, 2009

Ad
  • 580 Answers

SOURCE: I am looking at used BMW X3's (2007 and 2006). I

Best advice is this do your homework check consumer reports,.Get a car facts report Compare this choice with a second choice perhaps a Mercedes Benz ML320 or a Volvo X90 and choose the one best suited to your needs, I like these But I am not driving You Are whichever you decide on have it checked b a mechanic independant of the dealer. Good luck on your decision

Posted on Jul 11, 2009

bschilz
  • 2049 Answers

SOURCE: 2006 BMW X3 indicator light - exclamation point

It's essentially our "check engine" light.

Go to a local mechanic or auto parts supply store and have them read the diagnostic code on the OBD2 port. Auto parts stores usually do it for free. With the code in hand, they can look up the code to help diagnose your problem.

It can mean something as simple as the gas cap is not on tight to a serious malfunction. It's best to have the code read soon!

Posted on Oct 17, 2009

  • 104 Answers

SOURCE: my back doors wont close all the the latch is in

TAKE A SCREWDRIVER OR SOMETHING TO PUT IN THE GAP IN THE LATCH WHERE THE STIKER IN THE DOOR JAM IS WHEN IT IS CLOSED NORMALLY,& WHILE YOU HAVE THE SCREWDRIVER OR SOMETHING SIMILAR IN THE LATCH,PULL TOWARDS THE CAR WHILE YOU PULL THE HANDLE LIKE TO OPEN THE DOOR AS IF IT WAS CLOSED NORMAL,& IT SHOULD OPEN THE LATCH.

Posted on Dec 05, 2009

Testimonial: "That was kinda simple but I appreciate it ...I guess I was Panicking ....."

  • 71 Answers

SOURCE: how can i remove door handle of bmw X-3

If you have the door panel off already. you have to look at the back of the door latch mechanism. you will see where the wire for the door handle hooks to the door. If you are starting you have to be very careful in removing the screws for the door panel look for the hidden screws under caps with cutout.there should be a toric screw where the door handle is and another one close to where the mirror mounts. again look for caps

Posted on Apr 26, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2005 bmw x3 3.0l automatic. Swapped out starter from underneath. Removed drive line from frt of tr/case, removed t/cs crossmember.


BMW X3 Starter - PartsGeek.com

www.partsgeek.com > Starter > BMW Starter > X3 Parts
BMW X3 Replacement Starter Information. Read Reviews for ... Search our onlinestarter catalog and find the lowest priced discount auto parts on the web. We sell wholesale ... They are available for the following BMW X3 years: 2006, 2005, 2004, 06, 05, 04. This part is also ... 07 2007 BMW X3 Starter 3.0L 6 Cyl N52 Bosch.

Jul 25, 2015 | BMW Cars & Trucks

1 Answer

2006 bmw x3 3.0i timing chain or belt


BMW, 3.0i has two Timing Chains. Primary Timing Chain can be
reached by removing the Harmonic Balancer. Lower Timing Case Cover. Vanos Adjusting Unit. Secondary timing chain replacement will require removal of several components and Vanos Adjusting Unit.

Mar 16, 2015 | 2006 BMW X3 X3 4dr AWD 3.0i

1 Answer

Bmw x3 troubleshooting


VACUUM LEAK IN THE OIL RE-CIRCULATOR

Aug 25, 2014 | 2006 BMW X3 3.0i

1 Answer

2006 BMW X3 rear passenger side window not working


ok i think cable that operate the gears to the window broke

Dec 16, 2013 | 2006 BMW - X3-Series

1 Answer

How do you take the radiator cap off


You want to be very careful doing this. To remove the radiator cap start the car you will have less pressure with it running or you can do this with it not running. You need to push down on the cap and release it from the notch lock then still pushing down turn it and it will probably go into the second safety lock. If so just push down ******* the cap and remove it. Be sure to remove the cap slowly if it is hot the antifreeze will blow out and burn you. Hope this helps.

Feb 18, 2013 | 2006 Chevrolet Uplander

1 Answer

The interior lights, locks, amd windows have stopped working in my BMW X3


Maybe you'd better do a troubleshooting with your BMW X3. These bmw diagnostic tool information may can help you.

Mar 23, 2012 | 2006 BMW X3 3.0i

1 Answer

How do i change the hig beam bulb on my bmw x3


1. Open hood.
2. Use a small flat screwdriver to CAREFULLY pry open cap leading to the headlight. Start directly underneath the tab that says "V2." Be careful not to break the tabs! -- to do this simply push the small screwdriver under the tab, as you push it in, you will hear the clip release. The cap will pop and remove very easily after that.
3. Pull out wire harness connecting to the bulb, push the spring clip in and to the side to release the clip and then you can pull the bulb out. Put the new bulb in (do not touch the glass portion or the bulb can explode from the oil residue) and reverse to close everything back up

Nov 05, 2009 | 2007 BMW X3 3.0si SAV

1 Answer

Radiator fan doen't come on at all with a/c on or off 06bmw x3


get the wiring diagram and check the fan switch and the fan relay

Apr 11, 2009 | 2006 BMW 3 Series

6 Answers

Bmw x3 2005 headlamp bulb replacement


The last post is correct, but I also have a few tips and pictures.

1. Open hood.
2. Use a small flat screwdriver to CAREFULLY pry open cap leading to the headlight. Start directly underneath the tab that says "V2." Be careful not to break the tabs! -- to do this simply push the small screwdriver under the, as you push it in, you will hear the clip release. The cap will pop and remove very easily after that.
3. Pull out wires, unplug burned out bulb - this clips in with what I can see is a spring clip. I reccomend using a cloth when removing and replacing the bulb. This will protect your hand if the bulb breaks by accident. Also some halogen bulbs will pop/break if your hands leave oily residue on the bulb. When the bulb heats, the oil heats too and can break the bulb.

Dec 23, 2008 | BMW X3 Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

146 people viewed this question

Ask a Question

Usually answered in minutes!

Top BMW Experts

Anthony Jones
Anthony Jones

Level 2 Expert

128 Answers

Doberman

Level 2 Expert

254 Answers

dhnguyen

Level 2 Expert

281 Answers

Are you a BMW Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...