Question about Chrysler Sebring

Open Question

Code p1495 on a 2003 chrysler sebring

Posted by Anonymous on

Ad

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 14036 Answers

SOURCE: diagnostic Troubleshooting Codes for 1996 Chrysler Sebring Cvtble

FIRST YOU TURN IGNITION SWITCH ON WITH ENGINE OFF.LOOK AT MIL LIGHT IT SHOULD COME ON 3 SECONDS THEN GO OFF IT NOT THEN YOU GOT BURN OUT BULB OR A CIRCUIT PROBLEM.IF ALL IS WELL. ATTEMPT TO START ENGINE.TURN OFF IGNITION. WITH OUT STARTING ENGINE.TURN IGNITION ON OFF ON OFF AND WITHIN 5 SECONDS RECORD 2 DIGIT DIAGNOSTIC TROUBLE CODES.DISPLAYED BY FLASHING MIL LIGHT.YOUR MIL FLASHES WILL BE YOUR CODE LIKE THE MIL LIGHT FLASHES 5 TIMES THEN PAUSE FLASHES 3 TIMES THAT CODE 53 THAT YOUR CODE.IT LIKE MORSE CODE.WHEN DONE TURN OFF IGNITION SWITCH.GO TO AUTO ZONE OR ADVANCE AUTO GET HAYNES COMPUTER CODE BOOK. TO GET CODE MEANING OR WHAT SENSOR GONE BAD.HOPE THIS CAN BE SOME HELP.

Posted on Jul 27, 2009

Ad
ZJLimited
  • 17970 Answers

SOURCE: 1999 Chrysler Sebring Convertible code P1495. I

Code 1495 = Leak Detection Pump Solenoid Circuit

Remove the connector from the solenoid (should be on the back wall, just to the drivers side of the air-hat). You will have the solenoid to check and the harness. What you want to measure is the voltage coming from the harness and the resistance of the solenoid.

Turn the key to the "ON" position but do not start the motor; the voltage at the connector should be at least 10V or more,.now, check the resistance of the solenoid (should be around 35 ohms).

Hope helps.

Posted on Jun 03, 2010

clifford224
  • 1975 Answers

SOURCE: chrysler sebring code p0513

P0513 stands for invalid SKIM Key. Basically it means that the "computer chip" that is in your ignition key which has a special code is not recognized by your vehcile compter (PCM). In most cases that I have come across is that either your VIN is not entered or is the incorrect VIN programmed into the PCM. Have you recently changed the PCM ? You may try another ignition key but I doubt that would work unless you are using the wrong key for the vehicle. You will need special diagnostic computer programs in order to correct this problem. Most likely your PCM will need to be "Flashed" to the VIN. This really isn't a weekend/backyard/part time mechanic fix. Hope this helps you to understand what the code is and what it means. Guessing the vehicle won't start.....

Posted on Oct 11, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Codes po340 2004 Sebring


DTC code is P0340 no cam signal at PCM. Chrysler always used to say replace the cam and crank sensors together..wouldn't pay our warranty time at dealer unless we replaced both.

Aug 21, 2014 | 2004 Chrysler Sebring

1 Answer

Chrysler diagnosis code 253


My answer is i have chrysler sebring 2002 engine size is 2.7 i have engine light code is 253

Mar 14, 2013 | 2004 Chrysler Sebring

1 Answer

Code 41 for a 1999 chrysler sebring jx convertable 6 cyl 2.5


No vehicle after 1995 has a code like that

PO40 & PO41

Google OBD2 Codes P0 40

Mar 03, 2013 | 1999 Chrysler Sebring

1 Answer

Chrysler sebring code


MAP (Manifold Absolute Pressure) Sensor or MAF (Mass Air Flow) Sensor or TPS (Throttle Position) Sensor. Not that hard you just need to know where to look so I will give you a link to look up codes :-)
http://www.permoveo.ltd.uk/tabid/122/OBD-Error-Code/P0068/Diagnostics/Chrysler/Default.aspx

Jun 28, 2012 | 2002 Chrysler Sebring

2 Answers

Radio code for a 2005 chrysler sebring


as these are an anti-theft radio you will have to go to the dealer and have them get the code for you.find out the input sequence so you can do it if it happens again and write both down so you will have it,this will happen if the battery goes bad also.

Jun 24, 2011 | 2001 Chrysler Sebring

1 Answer

I have a 2003 chrysler sebring, what can cause my check light to come on?


once the code is pulled it will tell you why its on with out haveing code pulled it could be a hundred different things have code pulled

Dec 25, 2010 | 2003 Chrysler Sebring

2 Answers

Tire specs for 2001 chrysler sebring


HI. Here is the complete line up of specs concerning your vehicles front and rear tires. You did not post the trim line of this car, so I posted all models and tire combination's specified by the manufacture.


2001 Chrysler Sebring Lim 2 Door Convertible Front and Rear Tires P205/60R16
2001 Chrysler Sebring LX 2 Door Convertible Front and Rear Tires P205/65R15
2001 Chrysler Sebring LX 2 Door Convertible Front and Rear Tires P205/60R16
2001 Chrysler Sebring LX 2 Door Coupe Front and Rear Tires P205/55R16
2001 Chrysler Sebring LX 4 Door Sedan Front and Rear Tires P205/65R15
2001 Chrysler Sebring LX 4 Door Sedan Front and Rear Tires P205/60R16
2001 Chrysler Sebring LXi 2 Door Convertible Front and Rear Tires P205/60R16
2001 Chrysler Sebring LXi 2 Door Coupe Front and Rear Tires P215/50R17
2001 Chrysler Sebring LXi 4 Door Sedan Front and Rear Tires P205/60R16

Jul 06, 2010 | 2001 Chrysler Sebring

1 Answer

Paint color code


The below link will take you to the 2007 Chrysler Sebring colors. Please note that you mentioned it was a 2002, then a 2007. The link is for 2007.

http://www.paintscratch.com/cgi-bin/makepaint2.cgi

Jun 02, 2009 | 2002 Chrysler Sebring

1 Answer

P1128 code


I looked on alldata, and my Chrysler site, and there is no P1128 code listed. Are you sure the code is correct? What motor is in it? I looked for the code online for generic reasons, and it says it is for upstream heated O2 sensors swapped. Never heard of this code ever in 14 years of service work.

May 28, 2009 | 2006 Chrysler Sebring

1 Answer

Scan tool will not erase code # P-0601/2001 chrysler sebring 2.7


Sounds like a bad PCM.A dealer may be able to reflash the thing but not certain.Do a web search for the above code and you'll get all kinds of info. Good Luck

Mar 28, 2009 | 2001 Chrysler Sebring

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

57 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

76848 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8582 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...