Question about 1994 Buick Park Avenue

1 Answer

1994 buick park ave ultra wont charge battery

New alternator, battery checks out good at parts store new belts and tensioner

Posted by on


1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 4 Answers

Sounds like a bad connection or corroded wire

Posted on Feb 05, 2013


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

  • 6 Answers

SOURCE: on my 98 buick park ave, i lost power to all my

First off you have three fuse boxes in your car, 1 big one under the hood on the passenger side, next is under the dash on the passenger side, you get to this one by removing the kick plate {plastic cover} you have to look closly as this is the hardest one to find and get at, the third one and the one your probably going to need is the one under the back seat, don't worrie it's easy to remove, all you do is grab hold of the bottom of the seat in the middle and pull up in a quick jolt, the seat is very light and very easy to put back, the fuse box is right there and is black and has a black knob you undo, look inside the lid and you will see a diagram telling you what is what.

Posted on May 20, 2009

  • 2984 Answers

SOURCE: try to locate body control module on a 94 buick park ave

BCM --The Body Control Module is located on the right side of the vehicle and positioned under the instrument panel. In order to gain access to the module, it will be necessary to first remove the trim panel.

Posted on Jun 23, 2009

  • 1124 Answers

SOURCE: replace 2000 buick park ave serpentine belt

Firt - study & write down (draw) the belt path,,
and be sure about it..

Then - put a wrench on the nut in the center of the tension pully.. Move the tension pully to loosen the belt.. Pull belt off..

Repeat to put new one on..

Should be pretty easy..

Posted on Jul 09, 2009

  • 353 Answers

SOURCE: 1997 Buick Park Avenue Ultra. Replaced battery,

recheck your body ground may have surface rust on bolt, body, or connection

Posted on Aug 21, 2009

  • 98 Answers

SOURCE: how do i install serpentine belt on a 1998 buick

  1. there should be a place on the tenshoner pully to put a ratchet and tale tenshon off the pully then follow the routing diagram for the belt on the radiator suport pannel on the front of the car

Posted on Mar 09, 2010

Testimonial: "Thanks for taking time to answer my ?, but I'm wondering do I have to remove pessenger side motor mount to install serpentine?"

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Serpatine belt comes off buick park ave. when driving through standing water

My bet is that one of the pulleys is misaligned. Could possibly be on the belt tensioner. Have you tried a new belt tensioner?

Also make sure the other pulleys do not have ANY play in them. Take the belt off and by hand check to see if you can wobble any of the pulleys.

If the shaft of any pulley is not perfectly aligned with the other pulleys, that pulley could cause the belt to slip off. Has the alternator, power steering pump, AC compressor been worked on or removed just prior to this happening? One of those might not have been reinstalled perfectly. A washer that is missing or in the wrong place can cause a belt to drift.

Mar 03, 2014 | Buick Cars & Trucks

1 Answer

97 Buick Park Ave. Non-Ultra. Mileage 200K. Was squeaking at morning cold start for about 5 to 10 min. Replaced Serpentine Belt, belt tensioner, alternator, and PCV Valve. STILL squeaking at cold start....

How's your engine coolant level? If you've got a water pump leaking coolant, your belt will squeak, as the pump will leak the coolant directly onto the belt. You'll see the spray pattern under the hood if it's been going on for a while.

Oct 18, 2013 | 1997 Buick Park Avenue

1 Answer

Battery not charging and alternator checks out good

check condition and tension of the drive belt as it may be slipping under load

Jun 16, 2013 | 1984 Chrysler LeBaron

3 Answers

I can't find a diagram of the belt installation for my 97 Buick Park Avenue. Can you help?

I can help, a belt diagram for a 1997 park ave, some of these cars come with a super charger, heres a diagram that list both the regular belt and then the charger belt, use what is needed, hope this helps.cfccfd3.gif

Sep 09, 2010 | Buick Park Avenue Cars & Trucks

3 Answers

I have a 1995 Buick Park Ave Ultra. The car has power but will not turn over. I was told by one shop that it might be the V.A.T.S. system and by another that it is the IGNITION CONTROL MODULE.

Make sure the battery cables are clean and tight on the battery. Check to see if the wires to the starter are tight. Try starting it in neutral to make sure the safety switch is being make. Also hold it up into park and try.

Mar 22, 2010 | 1995 Buick Park Avenue

4 Answers

1994 buick regal wont start unlless a jump off,and then run good

Check the battery,have a load test done on the battery,now,it could be that the battery terminals,and battery cable ends are corroded,clean them really good,shining clean,this makes a big difference.Good idea to have the alternator checked also,while on the vehicle running,with the head lights on,and high blower motor,it should read at the battery,13.65 volts,to 14.25 volts.

Feb 09, 2010 | 1994 Buick Regal Gran Sport

1 Answer

My 1993 want start or turn over buick park ave.

Check the battery connections and the battery itself the battery must be charged and tested, clean the battery terminals charge the battery and try to start, if no luck take the battery to an auto parts store to have it tested for free replace battery if neccessary, always wear safety glasses when working near a battery. If the battery is good and connections are good replace the starter, but you may want to check the connections at the starter first before purchasing a starter there may be corrosion on the connections.

Aug 03, 2009 | 1996 Buick Park Avenue

2 Answers

Wont start without jump start

Check your alternator to see if is charging propperly.. There is also a fuse in the car to control the alternator charging as well. you should look at this.

Mar 02, 2009 | 1994 Buick Park Avenue

1 Answer

Installing accessory belt on 94 Buick P/Ave ultra.

You must press on tensioner to make room for new belt. The tensioner then re-traps and keep belt tension when new belt in on. So in other words you have to put belt over all othe pulley leaving tensioner for last using a 3/8 ratchet with out a socket (just the square end) in the hole thats in the tensioner pushdown/up to make room for belt to slide on. If the belt seems short make sure that it is routed the correct way. Good Luck get back to me if you need more help and leave me a "rating". Thanks

Dec 14, 2008 | 1994 Buick Park Avenue

1 Answer

Charging problem, alternator is new

it does not have a relay on the post on the altenator should have battery voltage and with key on should have voltage on the wire in the pigtail with it unplugged if you have that the alt is bad

Oct 13, 2008 | 1994 Buick Park Avenue

Not finding what you are looking for?
1994 Buick Park Avenue Logo

123 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts


Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8518 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides