Question about 2003 Ford Ranger Regular Cab

3 Answers

I have ford ranger 2003, 2.3L manual transmission. Ileft it parked for about 2 wks and came to start but never crank at all, all ignition are "ON", battery is very strong fully charge. When I pressed the starter relay it crank but won't start. I do not know if this truck equipted with RAP MODULE, W/O RAP MODULE, STARTER INTERRUPT RELAY, or REMOTE ANTI-THEFT PERSONLITY MODULE. Please advise

Posted by on

  • Anonymous Mar 16, 2014

    has fully charged battery and new starter, no crank condition

×

3 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

You gatta find out if it has any type of theft system and most likely if it does then disconnect it because the computer for it may have malfuntioned and by u disconneting it will deactivate the security for the constint turning over and not starting... so figure that out first...

Posted on Jan 28, 2009

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 1,011 Answers

Since your security light was flashing you need to reset the system.sorry i lost you on chat.first turn key to the run position for 12 minutes see if light stops flashing.then try to start this should work .somewere down the road you will have to replace the key and tumbler .hope this helps

Posted on Jan 28, 2009

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Ford Master
  • 2,039 Answers

Start the ranger with a test check the power at the starter when you start it on the starter the big wire always power the little one supposed to have power when you start the truck if you have no power go at the cluch there a switch check it if power go thrue or jump it with a wire let me know pierre

Posted on Jan 28, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Ford Ranger won't move?


you might need a new whole transmission or new brakes or brake fluid.

May 03, 2016 | 2003 Ford Ranger Regular Cab

1 Answer

Both coils do not fire on 1 and 4. Will start but only running on 2 cylinders. Could both coils be bad or should I look elsewhere?


Part 3 -How to Test the Ignition Module and Crank Sensor ...

easyautodiagnostics.com > Ford > 2.3L
Mar 1, 2012 - Spark plugs for cylinders #2 and #3 get spark at the exact same time. ...voltage -12 Volts) to both individual ignition coils within the coil pack. ... Ford Mustang or Ranger (or 2.3L Mazda B2300), this is what you'll need ... for this 'Switching Signal' at the coil pack... but you can also test this ... 1991, 1992, 1993.

How to Diagnose a Misfiring Cylinder (2.3L Ford Ranger ...

troubleshootmyvehicle.com > Ford > 2.3L
Apr 3, 2012 - Bad Fuel Injectors can cause a Misfire Condition. ... the ignition system on the 2.3L Ford Mustang or Ranger consists of 2 ignition coil packs, ...

2002 ranger misfire rough idle - Discussion on Topix

www.topix.com > Ford Ranger
Jul 27, 2007 - My truck is giving the code misfire in number 4 cyl. I replaced my spark plugs, Wires, Coil packs (both of them) and all my fuil ... three (3.0L v6) go bad, the fuel/air mixture gets messed up. Judged: 2. 2 ... My truck runs rough only at idle. ...code for ford ranger 2002, 2.3 5speed. truck runs like a champ but that ...

Extremely stumped! I need the best and brightest 1994 Ford ...

answers.edmunds.com > Edmunds Answers

Jan 31, 2016 | Cars & Trucks

1 Answer

Won't start in park in nuetral


will a 1989 Toyota camry transmission fi 1991 Toyota corolla

Jul 25, 2013 | 1998 Ford Escort

1 Answer

1994 Ford Ranger 5-speed manual transmission does not crank


Check your battery cables on the battery remove and clean replace and see if that works.

Sep 23, 2012 | 1994 Ford Ranger Supercab

1 Answer

I have a 1988 ford ranger that I bought for $150. It had been sitting outside for 2 years. When I went to start it, it did satrt with jump. But once I disconnected the jumper cables it died. Did that...


First pour some gas down the intake(just a small sipp)and crank it,if it starts you have a fuel distribution problem.If it dont, there is an ignition problem.

Aug 25, 2009 | 1988 Ford Ranger

1 Answer

Ford ranger will not start


check your crankshaft sensor to see that its not got a broken wire

Jan 24, 2009 | 2003 Ford Ranger Regular Cab

3 Answers

1987 ranger starter stays engaged


possible starter solinoid bad

Sep 22, 2008 | 1987 Ford Ranger

Not finding what you are looking for?
2003 Ford Ranger Regular Cab Logo

634 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

63291 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21981 Answers

Fordexpert

Level 3 Expert

5331 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...