a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US. click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need. Goodluck!
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Vacuum Control Motor-, Panel/Defrost Door
Panel/Defrost Door (Full Vacuum Position)
Defrost Air Flow
Side Window Demister Air Flow
Temperature Blend Door (Full Heat Position)
A/C Evaporator Core
Air Inlet Duct Door (Full Vacuum Position)
Outside Air Inlet
Vacuum Control Motor-, Air Inlet Duct Door
Recirculated Air Inlet
A/C Vacuum Reservoir Tank and Bracket
Vacuum from the Engine Intake Manifold
A/C-Heater Function Selector Switch
Vacuum to the 4x4 Hub Solenoids
Water Diverter Valve (Full Vacuum Position)
Floor/Panel Door (Full Vacuum Position)
Floor Air Flow
Vacuum Control Motor-, Floor/Panel Door
Panel Vent Air Flow
check the actuator motor on the heater sounds like the motor is not directing the air as it should. The motor is in the center of the truck inside attached to the heater and has arms on it to move the heater and ac doors.
Depending on what system is in that truck you may have a bad blend door motor or a vacuum leak, check around the engine for ant vacuum leaks or dissconnected lines, if its controled by selector motor then motor may be bad, this motor move the door to contorl which way the air comes out ,like defrost or vent or floor, the actuator motor is located under the dash bolted to heaterbox, this may be hard for you to find as there are 3 ,actuator motors, they control the recirculation door then one for temp and last the selector actuator. the best way to locate bad is to locate one at a time and watch as you move all heat controls until you find the one that doesnt move, that will be the bad one. hope this helps.
This may be caused by two things depending on the type of system, you may have a vaccum leak to the controls from the engine, like a broken vacuum line or your selector motor is bad, this motor moves a door in the heater/ac box that controls the flow of air to defrost vents or floor.i would say a 2004 jeep would mostlikely use the actuator motor instead of vacuum, have the selector motro checked.
Chanses are its either the blend door motor quit working or the controls ( temp., selector, blower) in dash are bad, my 95 did the same thing i chg. the blend door motor thinking it was that, but it turned out to be the controls in the dash, 5 minutes work and 140.00 later it was fixed.
I have a 1500 chevy picup that did the same thing the control panel (blower, temp, and selector) is what was the problem with mine replaced that and fixed it. Very easy to chg.front of dash pops off control panel pops out 1 plug ( yours may have 2 plugs)
pop back in and your done.
there should be a little canaster insid the dash maybe attach to the duct work it changes the position of the door if not it may be the control slide that you move to change the position of the heats function