Question about Chevrolet Monte Carlo
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: 1985 monte carlo determination
Check your fuel pressure. For fuel injection, it should be 9-12 p.s.i. Your fuel pump is located in the tank. You might have to install an adapter fitting to hook up a pressure gauge. This can be installed inline at the throttle body or at the fuel filter. The fuel filter is mounted on the inside of the frame rail. You might just remove the fuel filter to see if you can blow through it. If you can't blow through it, it is plugged up and that may be your problem. You will need two wrench sizes to disconnect the filter 20mm and 16mm.
Posted on Aug 20, 2008
SOURCE: 2002 monte carlo ss
The fuel filter is located in the pressure line that runs from the fuel tank to the engine,
near to the fuel tank.
Keep the engine off for few hours before replacing the filter, to get rid of some pressure in the lines.
Posted on Feb 27, 2009
For the bank 0 (the engine one) Undo the dogbones holding the engine from rocking and push the car forward until it stops, then set the parking brake. With the car COLD, spray the sensor down with PB Blaster and tap it (TAP, not smack) and wait a bit, then use your O2 removal socket to pop it out. Put the new one in with a tiny bit of copper antisieze and be EXTREMELY careful not to get any on the head, just the threads - less is more here. Reconnect it, and then hld down the brake and take the parking brake off, then slowly release the brake to let the engine rock back. Reconnect the dogbones and you're all set.
For the Bank 1 (post cat), lift 1 side of the car and set it on stands, and chock the other wheels, slide under and look after the cat, before the resonator, on the ubend in the exhaust, unplug the sensor and PB blast it a bunch, then use the appropriate wrench. Install the new one with the above instructions.
Posted on Apr 26, 2010
Tips for a great answer:
Sep 29, 2015 | Cars & Trucks
Dec 20, 2014 | 1985 Chevrolet Monte Carlo
Aug 12, 2009 | 1985 Chevrolet Monte Carlo
Jun 18, 2009 | 2003 Chevrolet Monte Carlo
Jan 08, 2009 | 1985 Chevrolet Monte Carlo
Dec 14, 2008 | 1985 Chevrolet Monte Carlo
19 people viewed this question
Usually answered in minutes!