Question about 1990 Jeep Cherokee Limited

1 Answer

How much would it cost to repair a steering column in a 1990 Jeep Cherokee 4WD

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 840 Answers

You are loooking at roughly 140. 00 what is wrong with it/ and 2 if you take the vehicle to chrysler auto body shop not a dealership the rates are not the same insurance rates prevail so you are looking at roughly paying between 110.00 or 85.00 thats 25.00 difference or you can call a steering and lock person. Please rate my response thank you very much

Posted on Jan 28, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to replace ignition on 1990 jeep cheerokee


You have to disassemble the steering column in order to remove and replace the ignition key cylinder. Almost the entire innards of the column has to be removed to get to the clip holding the key cylinder in place. It's not a procedure that can be described....you will have to either locate a diagram of a disassembled column or have someone, who has done it before, replace it for you. Sorry to be the bearer of bad news.

Oct 13, 2011 | 1990 Jeep Cherokee Limited

1 Answer

To JTurcotte - Your discussion and directions on how to repair the 1990 Jeep Cherokee srteering column were very good. I have a similar but not exact problem. The key would not come out of the...


WHEN YOU INSTALL NEW LOCK CYLINDER, TURN THE KEY TO THE LOCK POSITION. INSERT THE LOCK CYLINDER INTO THE HOUSING FAR ENOUGH TO CONTACT THE DRIVE SHAFT FORCE IT INWARD AND MOVE THE IGNITION SWITCH ACTUATOR ROD UP AND DOWN TO ALIGN THE COMPONENTS. WHEN THE COMPONENTS ALIGN, THE CYLINDER WILL MOVE INWARD AND THE SPRING LOADED RETAINER WILL SNAP INTO PLACE LOCKING THE LOCK CYLINDER IN THE HOUSING.

Sep 11, 2011 | Jeep Cherokee Cars & Trucks

1 Answer

Where is the flasher relay for a 97 jeep grand Cherokee?


Two FLASHER applicatiosn there:
Hazard flasher: Front seating area, driver side, under dash, driver side of steering column, mounted in convenience center

Turn signal: Front seating area, driver side, under dash, driver side of steering column, mounted in convenience center

If you need additional details or some repair manual sections, just send us a new comment.

Hope this helps (remember to rate and comment this answer).

Aug 19, 2011 | 1997 Jeep Grand Cherokee

2 Answers

Need to remove ignition switch on a 1990 jeep cheeroke


Remove lower instrument panel trim. remove 2 steering column to dash/brake support nuts and lower steering column. remove screws holding ignition switch to column and lift switch off of lock rod. first remove black harness connector, then remove white connector from switch.

Apr 10, 2010 | 1990 Jeep Cherokee Limited

2 Answers

How and where is the turn signal flashers located?


1999 Jeep Cherokee 4WD 4.0L MFI 6cyl
The Flasher is located in seating area, driver side, located in a wire harness connector which is secured to the diagnostics splice block bracket outboard of the steering column opening underneath the instrument panel.

Also, I suggest check the Service Manual for Jeep XJ Cherokee Electrical Section or the other section HERE

Hope helps with this (remember rated this) Good luck.

Jan 13, 2010 | 1999 Jeep Cherokee

1 Answer

Where is the flasher located


1996 Jeep Grand Cherokee 4WD 4.0L MFI 6cyl:
The Flasher is located front seating area, driver side, under dash, driver side of steering column, mounted in convenience center.
Application:
- Hazard flasher
- Turn signal

Check the ZJ-Secc-8W-Wiring-Diagrams (page 8) for Convince Center graphics.

I really hope helps with this (remember rated this help) Good luck.

Dec 29, 2009 | 1996 Jeep Grand Cherokee

1 Answer

92 Jeep Cherokee Attempted Theft. The left side of the steering column is smashed. I start the vehicle now with a screwdriver. Can i get individual parts for inside the steering column?


yes,but it would be less costly and time saving to just replace the whole steering column from a salvage yard,but make sure it comes with keys.

Nov 21, 2009 | 1992 Jeep Cherokee Sport

1 Answer

Steering column has a 1 inch wobble to it


I'm sure there are bolts holding the steering column. This
can be found under the dashboard. Just tighten it up to
correct the problem.

Nov 11, 2009 | 1991 Jeep Cherokee Limited

1 Answer

Steering column diagram needed for 1989 Jeep Cherokee


If you intend to keep the vehicle long term, I would suggest you invest in a Haynes Manual, That is worth its weight in gold, for this and any other project..
Regards,DT

Aug 29, 2009 | 1989 Jeep Cherokee

2 Answers

2005 Jeep Grand Cherokee (HEMI) Service Electric Brake System


Problem is a faulty Steering Angle Sensor (part of Steering Module) located in steering column ...replacement part $600.00.

Apr 14, 2009 | 2005 Jeep Grand Cherokee

Not finding what you are looking for?
1990 Jeep Cherokee Limited Logo

Related Topics:

156 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

60769 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...