Question about Pontiac Sunfire

Open Question

Fix loose steering column on 2000 pontiac sunfire

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

ilragatzzo78
  • 241 Answers

SOURCE: steering wheel column

there is a couple of rods on the left side of the colum.
take the panel of, put the key on the ignition. switch on and see wich rod is moving and thats the one that goes to a box type switch.
that switch is the problem, either is loose or faulty, if it wiggles try to tighten it up, if is tight then the switch is faulty and you will have to replace it, you can find it at any parts store

Posted on May 15, 2008

Bloomingidoi
  • 49 Answers

SOURCE: Steering column is loose on 97 sunfire. How can i fix it?

You have a tilt steering wheel! This is a problem with most GM tilt wheels. There is 3 or 4 screws you need to have tightened up; which requires tearing down the steering to get to them and put lock tight on them and tighten them back up, so they will not happen again for a long time.

Posted on Dec 01, 2008

  • 1 Answer

SOURCE: 1986 Buick Electra/Park Ave has

There are three bolts under everything that you see. The steering wheel comes off first,then the retainer ring has to come off(it's on the same steem that the wheel is on,there is a tool for that). There is a plate with slots in it that will come off. Pull everything else out carefuly as not to lose any screws or break any wires, and you should see the three screws in a triangle formation. Tightin them & reasemble.

Posted on Jan 12, 2009

bschilz
  • 2049 Answers

SOURCE: What is the paint code for a bright red 2000 pontiac sunfire

Pontiac 2000 Bright Red code is WA8774

Here's a link to the color code chart...
http://www.tcpglobal.com/aclchip.aspx?image=2000-gm-pg06.jpg

Posted on Oct 14, 2009

  • 1146 Answers

SOURCE: Were is the thermostat located in a Pontiac Sunfire 2000?

Hi:
Your thermostat is located under the thermostat housing, which is what the upper radiator hose clamps to on the top of your engine. Basically, you need to start with a cold engine, drain your radiator, then unclamp the upper radiator hose from the engine. Remove the bolts from the thermostat housing, and gently tap on it to remove it. clean up the mounting surfaces on both the engine and the housing, and install a new thermostat, and new gasket. tighten to proper torque, reconnect the radiator hose, then refill up the radiator and cooling system.

Posted on Nov 24, 2009

Testimonial: "Thank you, very helpful"

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Were is my rack and pinion for a 2000 sunfire


The rack and pinion is what the steering column and tie rod ends are connected to.

Jan 22, 2014 | 2000 Pontiac Sunfire

1 Answer

STEERING COLUMN LOOSE MOVES UP AND DOWN WITH ONE INCH PLAY ON A 1997 PONTIAC SUNFIRE.TILT STEERING LEVER HAS NO TENSION ON IT. SO NO ADJUSTMENT CAN BE MADE ON STEERING WHEEL POSTION.


remove the shroud around the column and have a good look at what has gone wrong ,fault could be a multitude of different things and without a good look its not possible to diagnose exactly what is wrong

Oct 12, 2011 | Cars & Trucks

1 Answer

Car ran fine went in store came out and tried to start it and nothing


check the recall on your 2000 sunfire they have 3 recalls on the car that maybe one of your problems if so it will be no charge to get it fixed. They did have a recall concerning the ignition switch that can get over heated and can catch a fire in the steering column even if the car is off and the key out. So go to 2000 sunfire make a copy of the recalls and get to your dealer hope this helped.

Jan 20, 2011 | 2000 Pontiac Sunfire

1 Answer

2000 Pontiac Sunfire turn signal sometimes flashes and sometimes doen't flash.


Sounds like your turn signal relay - it's located under the dash panel by the steering column.

Nov 21, 2009 | 1999 Pontiac Sunfire

1 Answer

Where is the ignition switch on a 2004 pontiac sunfire


The ignition switch is in the steering column.You need to be very careful when working with the steering wheel because of the air bag.If your are not familiar with taking apart a steering column with an air bag system then you should have a certified technician do it.

Nov 17, 2009 | 2005 Pontiac Sunfire

1 Answer

I need to know how i remove the intermediate steering shaft on 2000 sunfire


Hi remove the LEFT front wheel you will see the steering rack lift the rubber boot on the rack there will be a 11mm /7/16 pinch bolt you may have to turn the steering to get to the bolt remove the pinch bolt slide the shaft off the rack now go under the dash remove hush pannel if equiped at the bottom of the column there will be another boot pull it back there will be another pinch bolt remove it slide the steering shaft off the column
CAREFULL NOT TO ROTATE THE STEERING WHEEL WHILE SHAFT IS DISCONNECTED OR YOU WILL DAMAGE THE SIR COIL
pull the shaft up through the boot
then rev prev. for reinstalling

Apr 14, 2009 | 2000 Pontiac Sunfire

1 Answer

1996 sunfire gt. anyone know where the turn signal flasher is located?


Yep, under the dash, mounted to the drivers side of the steering column.

Hope this helps :)

Mar 16, 2009 | 2000 Pontiac Sunfire

1 Answer

Steering column is loose on 97 sunfire. How can i fix it?


You have a tilt steering wheel! This is a problem with most GM tilt wheels. There is 3 or 4 screws you need to have tightened up; which requires tearing down the steering to get to them and put lock tight on them and tighten them back up, so they will not happen again for a long time.

Dec 01, 2008 | 1997 Pontiac Sunfire

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

155 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

yadayada
yadayada

Level 3 Expert

74945 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7697 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...