Question about 2001 Jeep Grand Cherokee

Open Question

Diagram oil pressure sending unit 2001 jeep grand Cherokee

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 35 Answers

SOURCE: 2004 Grand Cherokee: oil pressure fluctuates

if you know for certain that the sending unit is correct and the guage is accurate, then yiu may have big problems.....while the engine is running open the oil filler hole.. is everything wet with oil? or does it look dry or just a little lubed? you can allways install an aftermarket oil pressure guage(crappy tire) if you get the same results with that then you may have a week oil pump....worst case scenerio... need an engine rebuild as the moter may have wear issues.does the pressure slowly drop as the motor warms up? at idle ? does it jump up when you step on the gas?

Posted on Mar 30, 2009

Ad
  • 101 Answers

SOURCE: 2002 Jeep Grand Cherokee 4.0L oil pressure gauge reading too high

if the gauge starts a 0 - goes to 1/2 , than full - sounds like gauge is OK - seems to me like the sending unit is bad - you could try removing the sender and trying to clean out the port with "brake clean", letting it dry than re-installing it. the pressure switch is still the least expensive place to start

Posted on Oct 27, 2009

techbuster
  • 5081 Answers

SOURCE: Exactly where is oil pressure sending unit located

if you have the 5.2 V8 its located in the rear of the engine near the dist cap area you can see it if you look in that area , if 4.0 6 cyl its located on the side of the engine block near the oil filter area. It has two wires going to it and screws into the block. It's made mainly of plastic and if broken can allow oil under pressure to spew out and give you thoughts of a blown rear main seal due to the amount of oil all over the underside.

Posted on Dec 09, 2009

  • 247 Answers

SOURCE: 02 cherokee losing oil pressure when accelerating, fine at idle.

Was the sending unit an aftermarket part?We like to install the original part back into most vehicle, but because of people price shopping, this can cause some issues. If the switch is working properly, the gauge should rise as the engine RPM's increase as you stated. With the key on and the engine off, disconnect the sending unit wire and ground it. The gauge should go to the highest reading, and that checks the wire, and the gauge. I suspect that the sending unit is failed or not the proper one for your vehicle.

Posted on Jan 07, 2010

c17hydro
  • 2984 Answers

SOURCE: Where is the oil pressure sending unit located on

Removal & Installation

  1. Disconnect the negative cable from the battery.
  2. Raise vehicle on hoist.
  3. Remove front splash shield.
  4. Disconnect oil pressure sender connector (4).
  5. Remove the pressure sender (2).
6eaedba.gif
Oil pressure sending unit


To install:
  1. Install oil pressure sender.
  2. Connect oil pressure sender wire.
  3. Install front splash shield.
  4. Lower vehicle.
  5. Connect the negative battery cable.

Posted on Jan 12, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Color wire diagram for 2002 grand jeep cherokee oil sending unit plug


first off , the the book is free.
posted here 100s of times, endless....
here one more time.
chapter 8w covers all that. on all.GC.
WJ jeep that is.

oil sender of what, engine or trans.>>>>?????


it really is , all there.


http://www.morris4x4center.com/knowledge-base/index.htm?utm_source=cj#service


free as a bird.. RTM !

Nov 24, 2015 | 2002 Jeep Grand Cherokee Limited

1 Answer

Color wireing diagram for 2002 grand jeep cherokee oil sending unit


double posted (why?)
and answered 5min ago.
backup 1 post.

Nov 24, 2015 | Jeep Cars & Trucks

1 Answer

Where is the oil pressure sending unit located on a 2000 jeep grand cherokee 4.0 liter


Removal & Installation
  1. Disconnect the negative cable from the battery.
  2. Raise vehicle on hoist.
  3. Remove front splash shield.
  4. Disconnect oil pressure sender connector (4).
  5. Remove the pressure sender (2).
6eaedba.gif
Oil pressure sending unit


To install:
  1. Install oil pressure sender.
  2. Connect oil pressure sender wire.
  3. Install front splash shield.
  4. Lower vehicle.
  5. Connect the negative battery cable.

Jan 12, 2010 | 2000 Jeep Grand Cherokee

2 Answers

What causes the oil pressure gauge to fluctuate on my 2004 Jeep Grand Cherokee Laredo?


If the oil pressure is good and there is no engine noises then the oil pressure sending unit is the problem.Just replace it and you should be good.Hope this helps.Good luck.

Jan 07, 2010 | 2004 Jeep Grand Cherokee

2 Answers

2001 Jeep Oil Pressure


Last week my 2001 Grand Cherokee with a 4.7 was dropping below 10 and my "check gauges" light and chime came on. My sending unit was bad. I could see it was bad because oil was getting through the unit and leaking very slow. It's located above the oil filter. Easy fix, but the unit was over $50 and the 1 1/16 special deep socket for sending units was over $10.

Oct 07, 2009 | 2001 Jeep Grand Cherokee

1 Answer

Low oil pressure


the first i would do is to see if the oil sending unit is ok and if you gage is working right and if they are then checkout the oil pump.

Feb 14, 2009 | 2001 Jeep Grand Cherokee

3 Answers

OIL PRESSURE SENDING UNIT ON MY JEEP CHEROKEE 1993 WHERE IS IT LOCATED AND IS THERE A DIAGRAM OR PICTURE LOCATION FOR IT


OIL PRESSURE SENDING UNIT ON MY JEEP GRAND CHEROKEE LAREDO 1999
WHERE IS IT LOCATED AND IS THERE A DIAGRAM OR PICTURE LOCATION FOR IT

ANY SPECIAL KNOWLEDGE TO PUT IN?

Jul 30, 2008 | 1999 Jeep Cherokee

Not finding what you are looking for?
2001 Jeep Grand Cherokee Logo

Related Topics:

104 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...