Question about 2009 Ford Escape

Open Question

Fuel fill inlet - 2009 Ford Escape

Posted by Anonymous on


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Partner put diesel in the water inlet. How do I fix this please.

Hope you did not put too much Derv into the water tank, you will need to remove the tank & the inlet pipe clean it all out with hot plenty of soapy water until you got rid of the smell & any black marks in the fill pipe. I hope you can get rid of the smell & use everything again, otherwise you'll need to buy everything new again & fit it. If your able if not you will need to take to service centre! but try what I have suggested you can't lose anything by trying. Cheers, Malcolm Campbell.

Apr 07, 2017 | Fiat Cars & Trucks

1 Answer

I have a 09 Lincoln mks and my check fuel fill inlet what's does that mean

Hi Regina:
A sensor thinks the fuel filler cap is not closed properly.
Just open it and then carefully close it making sure it is completely closed.

Apr 30, 2016 | Lincoln Cars & Trucks

2 Answers

Hi,my 2013 lincoln mkt Check fuel fill inlet light is on and I don't have a gas cap, my car don't come with a gas cap. What can I do ?

The sealing flap is not closing properly, most likely because of dirt on the rubber seal. Stick the fuel filler nozzle in and out 5 or 6 times slowly. This may dislodge the dirt. You can try blowing some compressed air around the flap also.

It may take a day or 2 for the check fuel fill inlet light to go out after you dislodge the dirt.

If that doesn't work, you have to replace the whole assembly. Any Ford Lincoln Mercury dealer will be able to order the part.

May 25, 2015 | Lincoln Cars & Trucks

1 Answer

Check fuel fill inlet

If the check fuel fill inlet lamp or CHECK FUEL FILL INLET message
comes on, the fuel fill inlet may not have properly closed. The inlet may
have stuck open or debris may be preventing the inlet from fully closing.
At the next opportunity, safely pull off the road, turn off the engine,
open the fuel filler door and remove any visible debris from the fuel fill
opening. Insert either the fuel fill nozzle or the fuel fill funnel (see
Refilling with a portable fuel container for funnel location) provided
with the vehicle several times to dislodge any debris and/or allow the
inlet to close properly. If this action corrects the problem, the check fuel
fill inlet lamp or CHECK FUEL FILL INLET message may not reset
immediately. It may take several driving cycles for the check fuel fill inlet
lamp or CHECK FUEL FILL INLET message to turn off. A driving cycle
consists of an engine start-up (after four or more hours with the engine
off) followed by city/highway driving. Continuing to drive with the check
fuel fill inlet lamp or CHECK FUEL FILL INLET message on may cause
the service engine soon lamp to turn on as well.
WARNING: The fuel system may be under pressure. If you hear
a hissing sound near the fuel filler door (Easy Fuel "no cap"
fuel system), do not refuel until the sound stops. Otherwise, fuel may
spray out, which could cause serious personal injury.

Jun 22, 2014 | 2010 Ford Fusion 1.25

1 Answer

Fuel fill inlet alarm

check the filler door to se if it closes all the way..some snap shut..

Dec 20, 2013 | 2001 Ford Escape

1 Answer

How do you change the inlet fuel line to the gas tank

There is no inlet fuel line,unless you're talking about a fuel line return from the pressure regulator? Or are you talking about the big hose between the fill cap and the tank?
If you're talking about a bad fuel line,is it plastic or steel? don-ohio

Nov 07, 2011 | 2002 Jaguar X-Type

1 Answer

Very slow to fill fuel tank. refuel hose nosel keeps clicking off when refueling

on your fuel tank their is a vent line from the tank that comes back up to the main fuel inlet line that is to let the air from an empty tank escape while fuel goes in, if that vent is not working properly then the fuel cannot go in quickly because the air in the tank has no where to go. The hose is made of rubber and may have become fatigued and kinked on a sharp corner. You will have to go underneath the vehile and inspect where vent line from where it exits the tank and goes back up to the main inlet line. You may have to replace the line.

Jan 30, 2010 | 2004 Chevrolet Tahoe

2 Answers

Fuel pump

you have to change your fuel pump,reinstall fist the pump by using socket wrench pliers and combination wrench,then buy new fuel pump together the old pump for sample.

Jan 14, 2009 | 2001 Chevrolet Suburban

1 Answer

92 dodge p u cummins eng power steering pump

to bleed the system fill the fuel filter then crack the inlet fule line turn over untill you get fuel then tightnline and start

Jan 11, 2009 | 1992 Dodge Ram 350

Not finding what you are looking for?
2009 Ford Escape Logo

Related Topics:

96 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts


Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers


Level 3 Expert

5520 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides