Question about Fiat Cars & Trucks
Heater not working in the above. Control display shows fan setting but no air is coming from the vents Thank you :-)
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
there is a good chance that you blend air door is stuck closed over your heater core and therefore not allowing the heat to flow, also your door that opens and close your direction of flow from the floor ,das,vent and defrost.your going to have to remove the lower cowling of the dash on the passenger side analso some of the center dash to actually check to see if the cable,servo motors. are acuating the doors.the issue could be just a stuck door or a misaligned cable or that it came off. that falls under the mechanical side of probabilities. electrical would most likely be a faulty selector switch or a servo motor
Posted on May 15, 2009
there are two separate actuators for the rear system. one controls temperature and the other controls vents from head to feet. mine problem was the later. that acutuator for esv 2003 is 89018365. it is located just below third seat cup holder passenger side and can be replaced simply by removing cup holder. triangular shaped part with wire harness.
Posted on Jul 11, 2009
The hot/cold switch is probably bad.you have a blend door box that opens to let the cold air in and closes to let the hot air in.From what you are saying this part is no responding to the switch movement.Make sure power is at the switch and power should go through the switch when put on cold air this moves the blend door.Some times the blend door goes bad and has to be replaced its under the dash on the right side.
Posted on Aug 10, 2009
first check to see if you have power going to the actuators when you switch the switch to it location if no power replace controller if you have power and no movement from actuators replace actuator. if actuators move remove hvac box and check for broken blend doors.
Posted on Jan 22, 2010
Tips for a great answer:
Feb 25, 2015 | 2003 Pontiac Montana
Jun 14, 2014 | Cars & Trucks
Jan 25, 2014 | Jeep Grand Cherokee Cars & Trucks
Jul 03, 2012 | 2003 GMC Safari
Oct 30, 2011 | 1997 Lincoln Continental
Jun 19, 2017 | 2000 Dodge Intrepid
Jan 22, 2011 | Fiat 500 Cars & Trucks
Jan 22, 2010 | 2003 Chevrolet TrailBlazer
Jul 31, 2009 | Buick Park Avenue Cars & Trucks
294 people viewed this question
Usually answered in minutes!