Question about Cars & Trucks

Open Question

How do i change fan clutch on a 2003 f150 ,4.6 liter

Posted by Anonymous on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Temp gauge is in normal, 200 degree, range when starting. Within a few minutes of driving goes up to 250, right below orange line. No leaks found, coolant level appears fine. Any ideas?


250 DEGREES ENGINE GETTING TOO HOT.SOUND LIKE CLUTCH FAN FREEWHEEL.IF CLUTCH FAN DONT LOCK IN OR HAVE RESISTANCE TURNING BY HAND WHEN ENGINE HOT.FAN CLUTCH IS BAD.IF FAN CLUTCH OKAY COOLANT LEVEL CORRECT.I WOULD CHANGE THERMOSTAT FLUSH OUT ENGINE AND RADIATOR.IF ENGINE TEMPERATURE STILL READS 250 DEGREES OVER FLOW JUG OR RESERVOIR NOT BOILING OVER THE COOLANT TEMPERATURE SENSOR FAULTY.

Nov 05, 2010 | 2003 Chevrolet Avalanche

2 Answers

Does a dodge 290 ci 4.7 liter v8 have a clutch fan


YES, THEY BOTH DO, ONE IS A COOLANT FAN, AND ONE IS FOR YOUR A/C CONDESNER

Jul 20, 2010 | 2001 Dodge Durango

2 Answers

How do you remove the fan from 1998 f150 4.2 liter


how do you remove the fan and fan clutch from 1998 f150 4.2 liter engine. i am trying to replace the water pump but i cannot get the fan to break loose . i cannot figure how to stop pump from turning while trying to loosen the bolt or nut that holds the fan clutch on the water pump shaft . is there a special tool to help me with this

Jul 15, 2010 | 1998 Ford F150 Regular Cab

2 Answers

How do i change my fan clutch on my 1994 dodge 250 5.2 liter


Rent a fan clutch removal tool from the parts house. Pull the whole unit out of the truck. There are 4 little bolts holding it on.

Jun 14, 2010 | 1994 Dodge Ram

1 Answer

How do you remove the fan clutch 1999 5.7 Liter?


use a wrench long enough to reach past the fan and use a hammer to impact it loose, also check if it is reverse treaded a lot of them are

Apr 28, 2010 | 1999 Chevrolet Silverado 1500

1 Answer

High blowing sound fom fan


did you change the clutch fan if not that is what you need to do they go bad alot

Feb 02, 2010 | 2003 GMC Envoy

1 Answer

Need to change Water pump how do i remove the fan on a 1993 Crown Victoria 4.6 liter


there is Ford specific tool to hold the water pump pulley while a large wrench turns the fan clutch nut COUNTERCLOCKWISE.....hope this helps

Aug 07, 2009 | 1993 Ford Crown Victoria

2 Answers

P0172 and P0128 Error Code 2003 Trailblazer 4WD


PO172 means that an oxygen sensor in bank 1 detected a rich condition (too little oxygen in the exhaust). I would replace the thermostat first. The computer could be injecting too much fuel because it thinks it never gets to operating temperature. That may keep the light off.

Jan 28, 2009 | 2003 Chevrolet TrailBlazer

1 Answer

Remove fan from water pump on a 1997 Ford F150 4.2 Liter


There is a special tool that is required to hold the fan clutch. Then the fan screws out of the clutch. The tool can be bought or rented at your friendly parts store like autozone, etc. It will look something like this:  http://www.amazon.com/Universal-Clutch-Water-Pulley-Holding/dp/B000RT924E

Jan 16, 2009 | 1997 Ford F150 Regular Cab

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

38 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...