An expert who has achieved level 2 by getting 100 points
An expert that got 5 achievements.
An expert who has written 20 answers of more than 400 characters.
An expert who has answered 20 questions.
Re: O2 SENSOR LOCATION
Oxygen sensors are usually located on the exhaust system. Cehck the exhaust circuit u will notice it. It's easy, just disconnect the necessary electricals and use the correct size spanner to unscrew it
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
P2195 O2 Sensor Signal Biased/Stuck Lean (Bank 1 Sensor 1) Code ... This codespecifically refers to the sensor between the engine and catalytic converter (not the onebehind it). Note: This DTC is very similar to P2196, P2197, P2198.
Ford Explorer and V8 O2 Sensor Locations diagram. This shows the
location of Ford oxygen sensors on Bank 1 and Bank 2. If you want to
know where your O2 sensors are, this diagram is your guide (click over pic for zoom)...
Hope helps with this (remember to rate and comment this answer).
The TPS is located on the side of the throttle body closest to the front of the vehicle. There are two electrical units attached to the throttle body the other being the IAC or idle air control. The IAC is usually a cylindrical object about 3" long and 1 1/4" in diameter.
the 4 cylinder has only one oxygen sensor. this sensor is a plug in with two wires coming out of it. As the exhaust leaves the motor the o2 sensor tells the car what carbon is leaving the. The o2 sensor is located on the exhaust pipe directly leaving the motor
There are 2. One is located above the catalytic converter most likely near the exhaust manifold where it attaches to the head. the second and most common one I have found to go bad is the down flow sensor located after the catalytic converter before the muffler on the underside.
Yes the 98 ranger has 3 02 sensors,they are located in the exhaust system under vehicle,2 of them
are in front of the cataletic converter and 1 behind it.I replaced mine ,reset the codes and the check
engine light still comes on?