Question about Toyota Pickup

Open Question

1985 toyota 22re will start when cold.will not after driven for a while

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

stormbrewin
  • 426 Answers

SOURCE: 1985 toyota 4x4 22re missing and rough idle

Have you pulled out the spark plugs to see if there are any tell tale signs on them.They are a good indicator of many problems that occur and can save a lot of time isolating the problem.They should all be the same colour.Is the air box and lid properly secured with no leaks or splits in the intake tube.Have you put injector cleaner in the fuel tank to clear up any possible dirty injectors.Therse a few things your problem could be including engine vacuum leak which you can find by lightly spraying carburettor cleaner around suspect places such as inlet manifold and around injector seals.

Posted on Oct 24, 2008

Toyota Guy
  • 42 Answers

SOURCE: timing on a 1985 toyota

Before you set engine timing i recomend that you check for trouble codes. You can do this by jumping TE1 and E1 whitch on your engine is a round 2 wire plug on the drivers side, by air box. if you have a code then have the problem fixed, because some codes will effect engine timing. You must have the TE1 and E1 jumped when timing engine. The engine timing marks are on the oil pump on the front of the engine,down by the crankshaft. Timing is set to 5 degrees advanced(factory). Also make sure you have no vacum leaks they will also effect engine idle 900rpm which is the setting for setting the timing at.

Picture of TE1 and E1
1a577b6.gif

Also make sure your engine distributer cap is good and same for plugs and wires. I hoped this helped.

Also timing chain strech which will affect timing.

Posted on Mar 07, 2009

  • 2 Answers

SOURCE: 1991 Toyota 4x4 22re .On cold start the idle

put a jumper wire between the bottom two pins in the plug for the throttle position sensor, if it idles down you need to replace the idle throttle position sensor

Posted on Apr 09, 2009

polarcycle
  • 1392 Answers

SOURCE: need diagram of fuel injection for 85 4x4 22re

Sounds like you have a vacuum leak somewhere. There may be a stop adjustment on the throttle body, but usually high idles are due to unmetered air entering the system.

Posted on Jul 14, 2009

  • 113 Answers

SOURCE: hard to start in morning, changed out cold start

Buy a high amperage cold cranking battery! Typically there used in diesel engines, this will solve any hard starts!

Posted on Sep 21, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

93' toyota pickup 4wd 4 cylinders 22re, sputters when given throttle


Low fuel pressure can cause this or a clogged filter, has the fuel pressure been checked? Has the fuel filter ever been changed?

Feb 13, 2013 | 1994 Toyota Pickup

1 Answer

1985 toyota motor home. 4 cyl. 22re engine. goes slowly into reverse when transmission is cold, but when it warms up, it wont go into reverse. If I give it more gas, it will sometimes catch briefly, but...


Change the fluid and filter. If i remember correctly reverse and third gear share the same band and clutch pack. Some transmissions you could tighten the band on it.

Aug 04, 2017 | 1985 Toyota Pickup

3 Answers

I have a 1985 toyota pickup (fuel injected)with a 22re engine, it will run on starting fluid, when i spray it but it wont run otherwise, just put in a new fuel pump, thanks for youre help,


Alright, i have a 1987 Toyota 4x4. it has a 22RE full injected motor..it was able to run, but it was running rich, and idling pretty eratic..and then now..it only starts up..and dies. after like 5seconds. 

Jun 15, 2010 | 1985 Toyota Pickup

1 Answer

94 Toyota 22RE engine. Cold engine starts and


i would check the egr valve sounds like its sticking.

Jan 29, 2010 | 1994 Toyota Pickup

2 Answers

Need diagram of fuel injection for 85 4x4 22re


Sounds like you have a vacuum leak somewhere. There may be a stop adjustment on the throttle body, but usually high idles are due to unmetered air entering the system.

Jul 14, 2009 | 1985 Toyota Pickup

5 Answers

Need to change engines


If you have a 22r carbed then all 22r carbed engines from 1981-1995 will interchange. You may need to use sensor out of your old engine however. The 20r,22r,22re,22ret all have the same mounts and tranny bolt patterns. how ever there are lot of differences. you can swap from a 22r to a 22re but you must also swap the entire vehical wiring harness to do it right. if you have a 3.0L i would keep the same engine. some people have swap to the tacoma 3.6L but that is a expensive swap not exsactly bolt on so to say. If you have a 22re then stay with the 1986-1987 22re because the newer 22re use different computers, electronics ,sensors and more.. Same story with the 22ret. I hoped this helped.

Mar 26, 2009 | 1987 Toyota Pickup

2 Answers

1991 Toyota 4x4 22re .On cold start the idle


Take car for trouble code at Autozone or similar store for free. it is probably the idle position sensor.(IPS)

Feb 19, 2009 | 1991 Toyota Pickup

1 Answer

1985 toyota 4x4 22re missing and rough idle


Have you pulled out the spark plugs to see if there are any tell tale signs on them.They are a good indicator of many problems that occur and can save a lot of time isolating the problem.They should all be the same colour.Is the air box and lid properly secured with no leaks or splits in the intake tube.Have you put injector cleaner in the fuel tank to clear up any possible dirty injectors.Therse a few things your problem could be including engine vacuum leak which you can find by lightly spraying carburettor cleaner around suspect places such as inlet manifold and around injector seals.

Oct 24, 2008 | 1985 Toyota Pickup

1 Answer

87 4Runner 22RE problem


Replace the number one injector; it is sticking open.

Oct 07, 2008 | 1985 Toyota Pickup

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

27 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

75197 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7782 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...