Question about Dodge Cars & Trucks

1 Answer

2004.5 dodge 2500 diesel.....stopped running.....no fuel from the tank....removed the pump and tested....did not work....replaced...still no fuel pressure...will not start.....does the Ecm control the

Replaced fuel pump in tank....still no fuel pressure

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Renaissance:

    An user who is expert in 3 categories / brands.

  • Dodge Master
  • 1,632 Answers

Replace fuel filter first and see .

Posted on Jan 23, 2013

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 512 Answers

SOURCE: 2003 Dodge Ram 2500 Cummins Diesel

there is a technical service bulletin to relocate the fuel pump on this vehicle when the transfer pump needs replaced. there is the possibility the transfer pump is going bad on the 2003 now...its not good to run them low or out of fuel

Posted on Dec 23, 2008

BCally1
  • 133 Answers

SOURCE: 2004 Dodge Ram 2500 Diesel

do you still have the old style lift pump. located on the fuel filter housing or has it already been updated to in tank style. sounds like that to me. i've done a ton of them. chrysler has a whole conversion kit for this mod

Posted on Jan 09, 2009

  • 3 Answers

SOURCE: water pump replacement procedure 2005 2500 dodge with cummins diesel

take off old water pump. clean up area on the motor real good.do this by using a scrapper and cleaning slolvent. when thats all done put hi temp silicon on the block water pump and the put gasket on silicon. let dry for like five minutes. put in on torque bolts to specs.

Posted on Mar 22, 2009

  • 1 Answer

SOURCE: 99 dodge 2500 5.9 cummins fuel pressure at 3psi

The 3 psi is caused by a failed transfer pump. The problem the loss of could be the VP44 injection pump. This pump should be run at min 7psi. I had the same fuel pressure problem. I replaced my stock transfer pump with a FASS DDRP from www.usdieselparts.com. The stock pump is over $200 to replace and will fail again, sometimes right out of the box. The DDRP will supply about 15psi to the pump and is simple to install. I hope this helps.

Posted on May 10, 2009

  • 1 Answer

SOURCE: 2001 dodge 2500 diesel oil leak in front of power

The power steering pump is piggie backed to the vacuum pump. The seal in the back of the vacuum pump has engin oil under presure behind it cousing a leak that gets worse over time. Cummins make a seal kit to fix this leak.

Posted on Feb 05, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

2004 Dodge 2500 diesel loses power while driving.


either your fuel guage is not reading properly and you have less fuel than you think or your fuel pickup nedds to be adjusted sometimes the pickup looses the ability to pull the fuel from a certain level which would indicate that the pick up is going bad or is already bad if you replace just the pickup see if you can get one thats a little longer than the one that you have already so that it can go deeper into the tank. maybe the pickup tube has fallen off also and the pump can only pull the fuel when the tank is full. hope this gives you some ideas as to where to start.

May 07, 2010 | 2004 Dodge Ram 2500

2 Answers

Unleaded gas in a diesel fuel tank


do not worry about draining it, pour about 6 to 8 ounces of engine oil in it, and top it up with fresh fuel, it will be fine. The only way to drain the tank is to remove it and turn it over.

Apr 26, 2010 | 2006 Dodge Ram 2500

1 Answer

2003 CUMMINS STALLS BELOW 1/2 TANK RUNS FINE ABOVE 1/2. REPLACED IN TANK FUEL PUMP MODULE STILL HAVING SAME PROBLEM


Just a suggestions but...

Check fuel filter.

Also add some fuel conditioner (e.g. HEAT for diesel) to get rid of any water that may be in your system.

Mar 19, 2010 | 2004 Dodge Ram 2500

3 Answers

2004 Dodge ram diesel just die out of the blue.


It sounds like it could be the transfer pump. Turn the key on and then crank the engine for about 1 second but leave the key in the run position and listen for the transfer pump to run. It should run for about 15 seconds after you stop cranking. If not, then you will need to replace the transfer pump with a in-the-tank conversion kit if your is mounted on the side of the engine block below the fuel filter housing. If you already have the in-the-tank pump then it might be siezed or the "sock" might be plugged up with alge or other contaminants. I usually lift the bed rather than removing the tank to replace the fuel module. If the check engine light is on you might want to have it scanned for codes to make sure since the modules can be spendy.

Jun 05, 2009 | 2004 Dodge Ram 2500

1 Answer

2005 Dodge 2500 just stopped and acts like it is


first place to look would be your lift pump (fuel pump located behind the fuel filter housing). listen to it when you turn the ignition on, it should run for a few seconds and if you bump the starter it should run for about 30 secs. if you dont hear it running that is most likely your problem

May 10, 2009 | 2005 Dodge Ram 2500 Truck

1 Answer

Diesel fuel pump problem


All diesel full filters should be install with fuel in it.The engine has to be primed before it will run. Hope this helps.

Apr 28, 2009 | Dodge Ram 2500 Cars & Trucks

2 Answers

2004 Dodge Ram 2500 Diesel


do you still have the old style lift pump. located on the fuel filter housing or has it already been updated to in tank style. sounds like that to me. i've done a ton of them. chrysler has a whole conversion kit for this mod

Jan 08, 2009 | 2004 Dodge Ram 2500

1 Answer

2003 Dodge Ram 2500 Cummins Diesel


there is a technical service bulletin to relocate the fuel pump on this vehicle when the transfer pump needs replaced. there is the possibility the transfer pump is going bad on the 2003 now...its not good to run them low or out of fuel

Dec 23, 2008 | 2004 Dodge Ram 2500

4 Answers

2003 Dodge Ram 2500 Cummins Diesel


change fuel filter again may have gotten garbage in it and clogged it or if it is diesel lost its prime

Nov 11, 2008 | 2004 Dodge Ram 1500

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

57 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

75117 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7772 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...