Question about 1999 Honda Odyssey

1 Answer

My odyssey winshield fluit light all way on how to fix it ?

The bottle even full

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An user who is expert in 3 categories / brands.

  • Honda Master
  • 1,632 Answers

Wiggle the wire at the bottle beside the pump , spray de-oxit

Posted on Jan 23, 2013


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Where is the winshield washer pump located on a c1500 chevy truck

Do you know where you put washer fluid in , the plastic bottle ? You have to pull that plastic bottle off the vehicle . pump in the bottom of it !

Dec 17, 2016 | Cars & Trucks

1 Answer

Bright light

it is the most common problems with sunfire
if you follow headlights harness in front of the car near winshield washer bottle wiring could be cut .Remove tape and pull on each wires .. You should find the problem
hope it helps

Mar 26, 2014 | 1999 Pontiac Sunfire

1 Answer

After checking drains, door seals, taillights, window, etc where could water come in?

Front or rear winshields / heatercore / missing plug on the firewall or floorboards / rear hatchback hinge. Where is the water lacated in the vehicle.

Nov 06, 2012 | 1995 Honda Odyssey

1 Answer

How do I replace the windshield washer low fluid sensor. The low windshield washer fluid light is on and will not go off even though the washer fluid tank is full.

That sensor can be replaced. It's located on the washer fluid bottle which is found behind the front bumper and next to the passenger's fender.

Jan 25, 2011 | 2003 Honda Odyssey

1 Answer

Winshield wiper cleaner doesnt work

hate to say it but if you hear the pump running you either have a pinched hose or a hole in it usually its just a rodent passin through knaws a hole or 10 and moves on so fill the bottle run the pump a bit and see if its comin out on the ground

Jul 25, 2010 | 2003 Nissan Xterra

1 Answer

Car starts i can put it in drive fell the tranny ingage but wheels wont move even when in nutraul but if i rock car back and forth i hear a click and it drives but if i park then put gear shift in park...

Hi,check your transmision fluit level.I think the level is low .start the car ( car on level surface) put it in drive,parking brake set and check your trans fluit level.
good luck!!!!!

Feb 24, 2010 | 1996 Oldsmobile Cutlass Ciera

1 Answer

Washer bottle 1998 chrysler grand voyager 3.3 LX

If you are talking about the window washer bottle and the cooling system bottle the answer is no. The washer bottle goes to the winshield washer ports and the coolent bottle goes to the radiator

Jun 29, 2009 | 1998 Plymouth Grand Voyager

1 Answer

CAn't find the winshield washer bottle. Where is it located?

look at your car manual, if u don't have one look
under your hood neer the left or right fender for a blue plastic cap.

gl G

May 03, 2009 | Toyota RAV4 Cars & Trucks

1 Answer

My brake pedal sometimes would be hard to press, I took it to the mechanic and they said it was fine a week later when I drove it again the brake pedal did the dame thing hard to push and I couldnt...

ok here is the problem...your brake fluit is bad..maybe someone may have put some other kind of fluit in the brake bowl, but your brakes system is now No longer any will have to change every part of the brake system that has rubber in it...thats starting with the master cyl, then all the brake lines that are rubber, and all the calipers and wheel cyl if you have drum any part that has rubber in the system, you have no choice but to change...even the check value, for brakes..if you have one...and the best way to find out if your fluit is bad, just open the top of the master cyl cap and check the amount of fluit you have...but that is what you really need to look at is the rubber in the cap..if the rubber ring, that sets in the cap is a lot larger and your even having a hard time putting it in the cap to close it up.....then for sure...your system is bad...with out any question...your car even with no one even touching the brake pedal and you try to drive it anywhere..the calipers are stuck close and no matter what you do..the car will not good bad because it happen when people try to do a good thing and change the stuff under the hood, for the brake and trans fluit and all that stuff...wrong stuff in the brake systemm...your cost to fit it..a good $ 1,000

Mar 28, 2009 | 2002 Hyundai Santa Fe

Not finding what you are looking for?
1999 Honda Odyssey Logo

Related Topics:

16 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts


Level 3 Expert

78919 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides