Question about Nissan Cars & Trucks

1 Answer

Nissan altima 2003 shift gear with ****

Jerks when i put in to drive or reverse

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    MVP:

    An expert that got 5 achievements.

    Greenhorn:

    A rookie expert who has answered 20 questions on their first day.

    Cheetah:

    An expert who has answered 20 or more questions within one hour.

  • Contributor
  • 23 Answers

You may need a new transmission solenoid

Posted on Jan 23, 2013

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: 94 Nissan Altima accelerator problems

check your throttle position sensor

Posted on Aug 13, 2008

  • 2 Answers

SOURCE: 2003 nissan altima 2.5s transmission rough shift

Probably sensors! I have already replaced the crankshaft positioning sensor once, nissan replaced it once under recall and now it is bad again! Plus my speed sensor is bad too! Go to any part store and get diagnostic test ran, it will tell what sensors are bad.

Posted on Oct 02, 2008

  • 15 Answers

SOURCE: gear shift "loose" - car won't go into any gear

it could be your shift cable snapped?

Posted on Jun 01, 2009

GM Elec
  • 1000 Answers

SOURCE: The gear shift gets stuck and won't shift into

Either the shift knob or the actuator rod under the shift knob has worn out.
Remove the shift knob and pull the actuator rod (plastic) out of the shift lever and inspect it for wear or damage. If the rod is not worn or damaged, replace the shift knob and you will be good to go.
Good luck.

Posted on Nov 11, 2009

Testimonial: "Thank you, I think you found problem"

SOURCE: I have an 07 ford five hundred, first owner of

Trans Solenoid Pack

Posted on Apr 15, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2005 Nissan Altima jerks while driving, stops jerking when in neutral.


That usually happens if you're in too high a gear. If it also seems to accelerate slowly, you may have a fouled plug or other cause of a dead cylinder.

Jun 01, 2015 | 2005 Nissan Altima

1 Answer

Why doesnt my nissan altima shift


Im assuming you mean that the vehicle wont move when put it in gear and its an automatic! Check the transmission fluid level if it is ok check if vehicle will move in any other gear reverse 1 or L etc. If not it maybe a torque converter issue and maybe best for a transmission shop to sort

Apr 14, 2014 | 2005 Nissan Altima

1 Answer

Iam getting a delay of a few seconds whenever i shift between neutral and drive or neutral and reverse on my 2007 nissan tiida cvt transmission.


Have the oil changed and the filter checked . I have a Mitsubishi lancer and it is in good nick but If I apply power before the shift happens it chirps the tyres . have the bands and clutch pack adjusted Run fault codes to check for faulty solenoids and servos.

Jan 21, 2014 | 1994 Nissan Altima

1 Answer

2005 Nissan Altima jerks on Drive or Reverse for a second when hot.


Check for loss engine motor mounts and transmission mount
Also check the air tube (TOP AND BOTTOM) for hairline crack.

A loss motor mount can cause excessive vibration and damage the air inlet tube.

Jan 15, 2014 | Cars & Trucks

1 Answer

My Nissan Altima (2003) 4 cyl has started to have a rough shift from 1st to 2nd gear. After 15-20 minutes of driving, the shift become smooth/normal. I have 105,000 miles on it and have changed the trans...


possibly normal wear,band adjustment, check fluid level & condition(contamination); check for vacuum hose leaks and condition opf vacuum hoses..

Oct 03, 2010 | 2003 Nissan Altima

1 Answer

Rattling / grinding sound coming from engine area when vehicle is in gear and car break is applied, but when gear is set into neutral noise stops. Was told the problem was the aircondition compressor....


Just a couple ideas...
Your engine and transmission will shift slightly when in drive, and maybe that movement is allowing it to rub on something. Another issue may be that the noise is actually from the transmission.
Torn motor mounts will allow the drive train to shift or move farther than normal.

Jul 07, 2010 | 2003 Nissan Altima

1 Answer

Car won't go into gear properly


it could be a few things bent shifting fork or first gear is out reverse runs off an idler that is conected to first gear.

Jun 05, 2009 | 1999 Nissan Altima

1 Answer

Nissan 1999 Altima won't go into gear properly


howdy,you need a clutch..thats for sure,101%

Jun 05, 2009 | 1999 Nissan Altima

2 Answers

Car shift seems locked


probably due to safety on brake pedal, it will not allow you to move selectoer from park.

Apr 25, 2009 | 2005 Nissan Altima

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

72 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...