Question about Mitsubishi Passenger

1 Answer

When we stop on trafiklight suddenly engine shutdown,and some time transmisi light on.

But easy to start againt.

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Renaissance:

    An user who is expert in 3 categories / brands.

  • Mitsubishi Master
  • 1,632 Answers

Check vacuum hoses , install new ones .

Posted on Jan 23, 2013

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 1995 chrysler cirrus when im at the light the car starts jerking and sometime it shuts off.


IT WOULD BE NICE IF YOU TOLD US THE ENGINE SIZE;STRAIGHT OR AUTO TRANS,AC ETC.
The 3.9 LT V6 engines back then had bad lower distributor/camshaft bushing. IF your car missfires-is hard to start-or tries to run backwards upon shutdown it may be this.
Engine will have to be put on analyzer(to show vaariable timing caused by bushing)=easy to Dx and may be covered by warranty .

Aug 23, 2012 | 1995 Chrysler Cirrus

1 Answer

Where is the location of a ignition relay in a jeep grand cherokee 1999?


There is an auto shutdown relay in the box in the engine compartment that powers several things including the PCM.

Aug 11, 2012 | 1999 Jeep Grand Cherokee

1 Answer

P0735 relacion incorrecta gear 5 vw bora 2006 solucion


P0735 VOLKSWAGEN - Gear 5 Incorrect Ratio
P0735 se detecta cuando A / T no se puede desplazar a la posición 5 ª marcha incluso si el circuito eléctrico es bueno.

Notas técnicas
Empieza por inspeccionar el nivel de líquido de la transmisión y el estado, y el líquido cambia si es necesario.

Este diagnóstico monitores de la posición real del engranaje de control de la relación de deslizamiento del convertidor de par calculado por el Módulo de Control de Transmisión (TCM) de la siguiente manera:
Convertidor de par deslizamiento ratio = A x C / B

R: El eje de salida de la señal revolución de la revolución del sensor
B: Motor de la señal de velocidad del motor del módulo de control (ECM)
C: Relación de cambio fijado en la posición del engranaje que supone la medicina tradicional china

Si la posición real del engranaje es más alto que la posición (5 º) supone por TCM, la proporción de deslizamiento será más de lo normal. En caso de que la relación es superior al valor especificado, los jueces TCM este mal funcionamiento diagnóstico.

Los síntomas:
- A la luz del motor (o motor del servicio pronto luz de advertencia)
- Cambios de la transmisión incorrecta

Posibles causas:
- La transmisión de bajo nivel de líquido
- Dirty líquido de la transmisión
- Turno de solenoides
- Problemas de transmisión mecánica
- Transmisión del circuito de control hidráulico

Espero que esto le ayude. Por si acaso, adjunto el detalle en ingles original.

Suerte.

P0735 is detected when A/T cannot be shifted to the 5th gear position even if electrical circuit is good.

Tech Notes
Start by inspecting the transmission fluid level and condition, and change fluid if necessary.

This diagnosis monitors actual gear position by checking the torque converter slip ratio calculated by Transmission Control Module (TCM) as follows:
Torque converter slip ratio = A x C/B

A: Output shaft revolution signal from revolution sensor
B: Engine speed signal from Engine Control Module (ECM)
C: Gear ratio determined as gear position which TCM supposes

If the actual gear position is higher than the position (5th) supposed by TCM, the slip ratio will be more than normal. In case the ratio exceeds the specified value, TCM judges this diagnosis malfunction.

Symptoms:
- Engine Light ON (or Service Engine Soon Warning Light)
- Incorrect transmission shifting

Possible Causes:
- Low transmission fluid level
- Dirty transmission fluid
- Shift solenoids
- Transmission mechanical problems
- Transmission hydraulic control circuit

Mar 11, 2011 | Volkswagen Passat Cars & Trucks

2 Answers

95 grand prix died at a stop sign. It is trying to turn over but will not start. The gas tank is full. May be fuel pump?


see if you have spark at plug from plug wire.
these gm cars have a problem with the ignition module under the distributor cap and rotor button.
when they fail, car dies suddenly and will not restart.fairly easy to replace and not to expensive.

May 09, 2009 | Pontiac Grand Prix Cars & Trucks

1 Answer

Power shutdown


try checking all wiring connectors,especially the grounds. the new engine may have different connectors or missing connectors

Oct 09, 2008 | 2002 Volkswagen Jetta TDI

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

32 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...