Question about 2002 Jeep Grand Cherokee

1 Answer

Rear passenger window will not roll up or down

How do i remove door panel to inspect without damaging

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

  • Jeep Expert
  • 284 Answers

It's easy. You have screws and plastic clips. Uncover or remove all exterior plugs on panel that hide screws. Some are phillips and some ar T-15 torx. Once screws removed, take a screwdriver (flathead) and pry between door panel and body of door. Once clips are removed/pried loose carefully remove panel. Disconnect wire connectors to doo when removing panel. Job well done.

Posted on Jan 23, 2013

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

ZJLimited
  • 17970 Answers

SOURCE: how do you remove rear drivers side door panel on 2002 jeep

Several steps in here; review the KJ-2002-Liberty-Service-Manual-PDF-Secc-23-Body (page 128 and next).

I hope help you with this. Remember rated this help, good luck.


Posted on Sep 04, 2009

Testimonial: "THat information really helped thanks alot!!!"

  • 1348 Answers

SOURCE: how to take a door panel apart

check the fuse box and make sure the windows are not fused separately,before taking the door apart.
the door panel is held in with clips and there is a tool made for removing them.the window regulator/motor is a tricky one to do and unless you are really good,do not mess with it.
the motors have internal thermal cutouts.

Posted on May 09, 2009

  • 2 Answers

SOURCE: 2002 Jeep Cherokee Rear Passenger Side Window Slides down with no

i CAREFULLY REMOVED THE PANEL, THE SPEAKER, TAKING PHOTOS ALONG THE WAY (INCLUDING PHOTOS INSIDE THE DOOR WHERE I COULD NOT SEE), AND EVENTUALLY REMOVED THE TRACK WITH THE MOTOR AND CABLE. i FOUND THE PLASTIC MOUNT FOR THE UPPER CABLE BROKEN. AFTER MUCH STUDYING I FOUND THE CABLE SNAGGED ON THE REEL. I CLEARED THE SNAG AND LUBED THE REEL. I DRILLED A HOLE TO ACCEPT THE CABLE END AT ABOUT THE RIGHT DISTANCE , INSERTED A SCREW AND EPOXIED THE SCREW AND END IN POSITION, I HUNG THE ASSEMBLY ON THE OUTSIDE OF THE DOOR , PLUGGED THE SWITCH IN AND TURNED THE CAR ON -- THE TRACK WORKED PERFECT. I REPLACED ALL COMPONENTS, ATTACHED THE WINDOW, REPLACED THE PLASTIC REATTACHED THE LINKAGES TO THE LOCK AND DOOR OPENER. WORKS GREAT. SAVED SEVERAL HUNDRED DOLLARS FOR THE COST OF A COUPLE OF HOURS AND A SCREW AND JB WELD EPOXY.MEMBRANE, REINSTALLEED THE SPEAKER, 8f290b9.jpg2679bfa.jpgf4a65ed.jpg

Posted on Jun 22, 2009

laseramp
  • 309 Answers

SOURCE: Electric window will not operate on my 2001 jeep

white molding did it have gears on it? if so it;s the window regulator. and can be purchased at your local car shops like auto zone or pep boys even

the problem relates to this part please read the page to get a general idea of the cause. it;s cheap plastic part that failed and doped the window cable. here is the site.

http://pocketlogger.com/?pid=jpw


Posted on Sep 20, 2009

  • 491 Answers

SOURCE: passenger side rear window won't roll up

CHECK ALL CONNECTERS TO WIRES FOR WINDOW FOR LOOSE CONNECTIONS AND ALSO MOISTURE DRY ALL ENDS WITH DRY CLOTH ALSO LOOK FOR ANY BRAKES IN WIRING .

Posted on Nov 29, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Indica window roll up


Have you checked the rails,slides,for obstructions causing this?. Possibly one of the pieces in the mechanism is damaged or broken?. You can see/tell when the panel is removed from door to see when you roll up/down the window. Maybe not lubricated??????

Dec 26, 2013 | 2006 Tata Indica LSi

1 Answer

Passenger rear window will not roll up or down


You have phillips or torx screws to take out. Some may be hidden behind plugs. 1-take all seeable screws oit. 2-use a flat screwdriver and carefully pry all plastic clips between the door panel and the door body. Panel should lift off unless all screws are not removed.

Jan 23, 2013 | 2002 Jeep Grand Cherokee

1 Answer

I want to remove passenger side rear door panel because window is down and won't stay up


Hi,
Hi!!

Here is a little information on how window regulator works. Also step by step instruccions on how to remove and install the window glass.

Door Glass & Regulator Power Windows
Diagnosis & Testing
When the rear window lockout feature is enabled, the circuit is open and no voltage is supplied to the rear window switches. When the feature is not enabled, the circuit is connected to battery positive voltage. If this circuit is shorted to ground when the lockout feature is not enabled, the PWR WDO circuit breaker may cycle continuously OFF/ON until, either the lockout switch is pressed to open the circuit, or the circuit breaker is permanently damaged. All windows may be partially or totally inoperative while the fault is present.
Inspect for aftermarket devices which could affect the operation of the system. Inspect the easily accessible or visible system components for obvious damage or conditions which could cause the symptom. Faulty electrical connections or wiring may be the cause of intermittent conditions.
Removal & Installation
Window Motor & Regulator
  1. Position window approximately half way down in the door.
  2. Remove the interior trim panel.
  3. Remove the water deflector.
  4. Tape the window to door frame to prevent it from moving.
  5. Remove the three front door window regulator motor screws.
  6. Disconnect the electrical connector from the window regulator motor.
  7. Remove front side door window regulator motor.
  8. To install, reverse removal procedure.

Window Switch
Front
  1. Remove the front door pull cup screws and pull cup from the front door trim panel.
  2. Disconnect the electrical connectors from the front door power window control switch.
  3. Remove the front door window control switch using a small, flat-bladed tool at the side of the switch.
  4. To install, reverse removal procedure.

Rear
  1. Remove the rear door pull cup from the rear door trim panel.
  2. Disconnect the electrical connectors from the power window control switch.
  3. Remove the rear door window control switch from the pull cup using a small, flat-bladed tool at the side of the power window control switch to release the power window control switch retainer.
  4. Remove the power window control switch from the rear door pull cup.
  5. To install, reverse removal procedure.

Sep 07, 2010 | 2002 Buick Century

1 Answer

Just bought 2000 Ford Focus SE sedan.Neither rear window will operate from drivers door or from rear door switches.Fuse is good. Any other places to look without tearing into door panel?


Look to see if there may be a child safety feature. Not allowing passengers to roll their own window down. The drivers window switch is the master switch that controls all others. For example, if drivers window switch was disconnected than none others would work. Some vehicles it is not necessary to remove door panel when removing the master control switch. I'm not sure if you are one of the ones that doesn't have to do that.. good luck.

Jul 11, 2010 | 2000 Ford Focus

2 Answers

The passenger rear window won't roll up or down from the drivers controle it clicks in the passenger front door. it will roll down in the passenger rear door but not up. the window modulator rolls up and...


I have the exact same problem on a Jeep Grand Cherokee 2004. The rear passenger window rolls down only from the rear passenger window and won't go up or down from the front. It has to be in the wiring because the problem was intermittent initially and a new window motor does the exact same thing. If you figured it out or have the wiring diagram please let me know.

Apr 22, 2010 | 2004 Jeep Grand Cherokee

1 Answer

I have a 92 Lexus ES300. I went to roll down the passenger window, accidentally hit both passenger window buttons at the same time on the driver door switch panel. Both windows rolled down about an inch,...


Hi

Thanks for using FixYa. First of all you’ll need to check battery voltage, recharge it if it is low or jump start with another battery charger. Inspect, clean and tight both ends of all battery cables. Also check, clean and tight wiring connections. Check for voltage at relay. If relay has voltage but there is no "click" when key is turned to start, replace relay. Remove starter and inspect drive gear and flywheel teeth, replace damaged parts if necessary. Check to see if voltage reaches starter relay/solenoid when turn to start. If not, check for open P/N switch and brake or clutch pedal switch. Please pry the interior panel and release the inside door locks. If still the issue is not resolved then you’ll need to drill a two inch hole into the latch to access the inside lock link through the interior panel. After removing the panel replaces the latch to resolve the issue. See the picture where to drill---

7988ac4.jpg
Please do accept the solution if the issue is resolved or else revert for further assistance.


Thanks
Rylee


Mar 10, 2010 | Lexus ES 300 Cars & Trucks

6 Answers

Windows won't roll down


Does the rear window work from the passenger switch?

Oct 07, 2009 | 2003 Cadillac CTS

1 Answer

Rear passenger window just slides how do I get the door panel off


Well first take the mirror cover off. Then the roll up window handle if its manual. There is a star head behind the handle to open the door, remove that and unplug all wiring.Then behind the handle to close the door there is a cover, it has 2 screws, take those out and the rest is just plastic door clips just pull away from the door and they will start coming off.

Mar 12, 2009 | 2000 Chevrolet Malibu

Not finding what you are looking for?
2002 Jeep Grand Cherokee Logo

71 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7754 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...