Question about 2003 Chevrolet Silverado 1500

Open Question

2003 chevy silverado blower motor wont work

I checked the blower motor and it works, i just put a new resistor in and checked the fuses but still dosent blow any air nothing at all.

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

MacGyver911
  • 42 Answers

SOURCE: Where is the blower motor resistor on a 2003 Chevy Malibu

Remove the shroud below glove box, 2 screws and a snap-pop fitting. Be careful of the courtesy light. Remove the blower moter and disconnect the purple/black power connector to it - - you'll need this extra room to work with. 2 more screws, same size, 6.5mm on mine, 7or 8mm on some others, that holds the blower motor resistor in place. This replacement part is less than 40 bones at most parts store. Unplug, replace, re-install, test and you're on your way with about 2 hours of slow paced effort in your own driveway. Typical cost at a garage - up to $400, what a sham.

Posted on Mar 19, 2009

MacGyver911
  • 42 Answers

SOURCE: I have a 2001 Chevy

Replace the blower motor resistor. Remove the shroud below glove box, 2 screws and a snap-pop fitting. Be careful of the courtesy light. Remove the blower moter and disconnect the purple/black power connector to it - - you'll need this extra room to work with. 2 more screws, same size, 6.5mm on mine, 7or 8mm on some others, that holds the blower motor resistor in place. This replacement part is less than 40 bones at most parts store. Unplug, replace, re-install, test and you're on your way with about 2 hours of slow paced effort in your own driveway. Typical cost at a garage - up to $400, what a sham.

Posted on Mar 19, 2009

  • 5 Answers

SOURCE: Blower motor now only works in 5th speed, 1 to 4 not working

You are going to have to make a connector for your resistor to fit into the adapater under the dash. the new resistor doesnt reach the terminals on the connector. Even though it clips in place it doesnt reach. I took a piece of small soldier and put in the connector then plugged it in and it worked just fine. When you unplug the relay it will not work in any speed.

Posted on Jun 03, 2009

  • 580 Answers

SOURCE: 2003 chevy silverado 1500HD LT. A/C fan works intermittently

First check fuses, then test blower motor, Last Temp control switch

Posted on Jul 21, 2009

  • 1 Answer

SOURCE: 2005 chevy equinox. Blower stopped working..

John,
What's it going to take to pry that corrective action out of you? I've been trying to help someone w/ the same identifcal problem for a few days now.

Posted on Jul 22, 2010

Testimonial: "Bossier62 Is AWESOME! John Cushing, 6308087542 Thanks for posting my name on the internet. Not very nice. Answered ealier. Did not show. Not my fault"

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2003 chevy silverado blower motor wont work i tested blower motor it works i just replaced the resistor and still dosent work, i also checked the fuses and the are ok please what else could it be


Is the blower motor not getting power or ground ?
There are two fuses that power the HVAC control module. The module controls the blower motor processor and the blend doors.
Have you tested the module and processor ?
You may need a shop manual for the wiring diagrams and procedures.

Jan 23, 2013 | 2003 Chevrolet Silverado 1500

2 Answers

Blower motor does not turn off i have to take the fuse out


Go online to and google" manuel for 2006 chevy silverado 1500 2wd". Or you can go to ask.com and ask" Where is the resister located on a 2006 Chevy Silverado 1500 2wd". It will give you the info you need.

Dec 13, 2012 | 2006 Chevrolet Silverado 1500 2WD

3 Answers

I have a 2005 chevy silverado and my a/c blower motor wont work on #5 position just 1,2,3,4 position . what could be wrong with it,, i took the switch out and it looks good inside it, not burnt or...


Hi... On your question.
99% of the problem with speed in the blower Is. :
The blower Motor Resistor.
Is located Beside the Blower motor. Just follow the Blower motor wires it will lead to the Resistor.... I recomend to replace for a New one. Is not spensive...
I hope this help on your question,,, Thank you for use fixya...

Aug 18, 2010 | 2005 Chevrolet Silverado

2 Answers

2005 Chevrolet Silverado - Fan not coming on. When I turn the heater/ac blower fan on, fan does not work. Prior to completely going out, fan would quit working intermittently. Is this a fuse problem? ...


Chk for power at the blower motor electrical connector. If no voltage, check the blower motor resistor, its within the blower motor vent (this controls power to the blower motor). Also, in theses vehicles water may have damaged the blower motor itself. Inspect the blower motor for proper function.

Aug 10, 2010 | 2005 Chevrolet Silverado 1500HD

2 Answers

2006 chevy silverado heater fan dont work fuse ok


replace the blowermotor resistor, it is also called a blowermotor control processor its located on heater box next to the heatercore, here a picture of it and a diagram to show you exactly were it is. this will solve your problem,hope this helps you.daf0cd2.gifc3ee9b2.jpg

Jan 30, 2010 | 2006 Chevrolet Silverado

3 Answers

Chevy 2007 Silverado-blower motor not working


The bower motor is most likely what you are smelling.Replace the blower motor,and the blower resister next to the blower motor if,the blower motor has no speeds.

Oct 17, 2009 | 2007 Chevrolet Silverado 1500 2WD

2 Answers

I have a 2005 chevy silverado heater/ac fan stopped working . Checked fuses all were good .Removed fan and it works ,whats next?


Treed55508,

Try this solution. I have had the same issue three times. A Chevy tech told me that if it keeps doing it, to replace the blower motor, as it seems to be a chronic problem with the blower having to much resistance and thus burning out the resistors. I suspect that you probably had lost one speed first and then more. It has happened both ways with me, once the entire thing went out at once and then the other times it goes one speed at a time.

http://sparkysanswers.blogspot.com/2008/07/2005-chevrolet-silverado-blower-inop.html

Jan 06, 2009 | 2005 Chevrolet Silverado

2 Answers

Heater only work on high


Most likely is the resistor when they fault the default to high giving you off and high only

Dec 03, 2008 | 2003 Chevrolet Silverado 1500

1 Answer

Air only works on high


your blower resistor is bad look under rt side of dash by the blower motor you will see a flat plug into a piece bolted in air box this is the resistor. the wires are bad about burning up also un plug and check that if so gm sells a replacement plug. sometimes you can clean if you caught in time

Sep 11, 2008 | 2003 Chevrolet Silverado 2500HD

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

131 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8140 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...