Question about Cars & Trucks

Open Question

My nissan wingroad y12 4wd indicator light came on. When i switched off and restarted it remained off. what does this mean?

Called my mechanic and he said i probably need to do a diagnostic but he guessed it may be a sensor on the transmission. Please help

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 202 Answers

SOURCE: brake lamp indicator remains on

did you check the brake pedal switch? it located on the top of the brake pedal. good luck

Posted on Jul 29, 2009

Ad
  • 832 Answers

SOURCE: Rapidly fluctuating tachometer. Nissan Wingroad 1999.

You must be right, the sensor connection could have been moved. Have the mechanic do the checking.

Posted on Oct 02, 2009

  • 303 Answers

SOURCE: 2004 GMC Envoy check engine light remains

Leave 02 sensor alone ,it is doing it's job . It is heated up because of lean fuel mixture due to incorrect engine temp.,replace thermostat before looking further.

Posted on Jan 20, 2010

johnjohn2
  • 5763 Answers

SOURCE: code po705= Transmission range sensor, circuit

i ve run into this problem a few times,with no cler results,i checked all wiring from computer to switch and all check out fine i also replaced switch and a month later same code,this one ended up with a bad pcm, another one had a bad wiring for overdrive switch, this was not an easy repair to diagnose.i think you should have amazda dealer look at it.

Posted on Mar 03, 2010

consaka
  • 661 Answers

SOURCE: Speedometer went crazy, Engine signal, kick after full brake stop

he told you to take it to a transmission specialist because that is where those sensors are located. The speed sensor is located in the transmission. It reads the speed by counting the number of teeth on a relucter wheel. (thats the simple explanation).
I sounds to me like there might be some debri in the transmission that could be affecting the reading.
The engine computer uses that information to control the engine and transmission. Without that information the transmission could go into limp home mode and or have erratic shiffting plus other problems.
I would really suggest you get it in for a test and evaluation asap. I do not consider this vehicle to be reliable or safe because the transmission could lockup and or otherwise fail.
As a side note, these minivans are notorious for having failing transmissions and most transmission shops find that the majority of their work is on this minivans. One of the reasons I have just kept my full size van.

Posted on Apr 16, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What means p1652 obd code in Nissan Wingroad 2007 model


Write your answer...code p1652 in nissan note its all about cooling fan.

Dec 23, 2013 | Cars & Trucks

2 Answers

Nissan wingroad 2003 switching off on its own


Hi Njuguna. Undertake computer diagnosis of the engine, probably the crankshaft sensor is faulty and needs replacement. It could also be due to weak battery that will equally require replacement.

Mar 06, 2012 | Cars & Trucks

1 Answer

What is engine immobilizer


It's anti-theft security system, Nissan Vehicle Immobiliser System (NVIS)

The NISSAN Vehicle Immobilizer System will not allow the engine to start without the use of a registered key.

If the engine fails to start using a registered key (for example, when interference is caused by another registered key, an automated toll road device or automatic payment device on the key ring), restart the engine using the following procedures.

1. Leave the ignition switch placed in the ON position for approximately 5 seconds.

2. Place the ignition switch in the OFF or LOCK position and wait approximately 10 seconds.

3. Repeat steps 1 and 2.

4. Restart the engine while holding the device (which may have caused the interference) separate from the registered key.

If the no start condition re-occurs, NISSAN recommends placing the registered key on a separate key ring to avoid interference from other devices.

Statement related to Section 15 of FCC Rules for NISSAN Vehicle Immobilizer System (CONT ASSY - IMMOBILIZER, ANT ASSY - IMMOBILIZER) This device complies with part 15 of the FCC Rules and RSS-210 of Industry Canada. Operation is subject to the following two conditions; (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation of the device.

CHANGES OR MODIFICATIONS NOT EXPRESSLY APPROVED BY THE PARTY RESPONSIBLE FOR COMPLIANCE COULD VOID THE USER'S AUTHORITY TO OPERATE THE EQUIPMENT.



1_26_2012_2_35_28_am.gif
Security indicator light

For vehicles without Intelligent Key: This light blinks whenever the ignition switch is placed in the LOCK, OFF or ACC position.

For vehicles with Intelligent Key: This light blinks when the ignition switch is placed in the LOCK position with the key removed from the ignition switch.

This function indicates the NISSAN Vehicle Immobilizer System is operational.

If the NISSAN Vehicle Immobilizer System is malfunctioning, the light will remain on while the ignition switch is placed in the ON position.

If the light still remains on and/or the engine will not start, see a NISSAN dealer for NISSAN Vehicle Immobilizer System service as soon as possible. Please bring all registered keys that you have when visiting your NISSAN dealer for service.

Hope this helps; also keep in mind that your feedback is important and I`ll appreciate your time and consideration if you leave some testimonial comment about this answer.

Thank you for using FixYa, have a nice day.

Jan 26, 2012 | 2000 Nissan Maxima

1 Answer

The ABS light comes on on my 2005 nissan wingroad. When i turn the car off and start it again thelight is off. I have had the sensors changed. What else could it be? They said nothing showed up on the...


Well, it could mean that the emergency brake has not been fully released.The ABS system light is on if something has occurred within the ABS system. Something faulty may have happened there, get it checked out!

Aug 15, 2011 | Nissan Pulsar Cars & Trucks

1 Answer

Rapidly fluctuating tachometer. Nissan Wingroad 1999.


You must be right, the sensor connection could have been moved. Have the mechanic do the checking.

Oct 02, 2009 | 2006 Nissan Z

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

134 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...