Question about 2000 Mercury Sable

1 Answer

Missing an air hose that goes from the air breather to ? what is it called?

2000 Mercury sable V6 engine.there is an air hose missing.It is located on driver side of air breather towards the rear.Do not know where it connects on the other end.Is this the pcv hose?Need to know its name so I can buy it?

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Mercury Master
  • 3,103 Answers

If its about as big as your little finger in diameter it may be but if its an inch or larger its a manifold heat tube that comes up from the exhaust shroud on the header pipe which is used to preheat air on really cool days.. its usually around a foot long and flexible(bendable) and made from store sells by the foot if needbe..its like an exhaust patch..they will know when you tell what car it is..(normally)

Posted on Jan 22, 2013


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

2003 Sable engine change

check the location of the cam position sensor. if they are in the same place ,then use all the sensors from the old motor

Jan 09, 2013 | 2003 Mercury Sable

1 Answer

2000 mercury sable 3.0 v6 vaccuum hose fell off

If it is on the engine, the diagram is on the
federal emissions label under the hood

Nov 14, 2012 | 2000 Mercury Sable

1 Answer

No oil pressure, camshaft position sensor error,

Yes, the sensor is in small housing the goes in the hole where the distributor used to go. That also drives the oil pump so don't drive it you'll ruin the engine. It's located down under the throttle body, near transmission end of the engine.

Jan 04, 2010 | 1997 Mercury Sable

3 Answers

I have a 2000 mercury sable it started missing

have a major tune up done and ,,,fuel aditives,lucas fuel treatment and HEET gas dryer

Jun 28, 2009 | 2000 Mercury Sable

1 Answer

Missing air pump and Egr valve

Go immediately back to the dealer and find out why the parts are missing,,,In MOST states its ******* to sell a vehicle with pollution control parts missing!!!

Jun 06, 2017 | 2000 Volkswagen Jetta TDI

1 Answer

Where is the egr valve located on 99 mercury sable v6 3.0 litre

It is located at back of engine on top between the engine block and front windshield. It usually black or chrome in color and looks like a disk with a small vacuum line coming from the top of it.

Jun 15, 2009 | 2000 Mercury Sable

2 Answers

Misfire on cyl 2

how is the plug boot, does it have a burnt mark on it, that is the usual cause of the miss.

Mar 14, 2009 | 2000 Mercury Sable

1 Answer

1989 Mercury Sable, 3.0L V-6, Auto Trans. Engine Idles at about 2000 RPM.

Check your vacuum hoses (They are 3/8" Rubber hosing on the right side of the engine, you will need to remove the air intake piping (Also remove the throttle body to make accessing them easier) This is the #1 cause of high idling in the 3.0 OHV and 3.0 DOHC sable engines.

Jan 17, 2009 | 1989 Mercury Sable

Not finding what you are looking for?
2000 Mercury Sable Logo

80 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercury Experts


Level 3 Expert

80417 Answers


Level 3 Expert

5687 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Are you a Mercury Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides